查询词典 fault

According to the structure of the NO.l boiler and technique point, a fault tree has been built to analyse the boiler fault such as overhigh or overlow smoking temperature, overlarge ash combustible, deflective smog and so on.

并根据大庆石化公司热电厂一号锅炉结构以及技术特点，对锅炉排烟温度偏高、偏低，飞灰可燃物偏大，烟气偏斜等锅炉故障建立故障树并进行分析。

A simulation experiment on the quantitative relation between mudstone content in fault zone and vertical seal of overthrust was carried out. In addition, this paper analyzed the influence of deformation characteristics of rocks on vertical seal of fault.

在正确分析逆掩断层形成的地质条件和封闭机理的基础上，本文认为与逆掩断层相伴生的塑性岩石的变形特征、断面压力和断裂带中泥质含量是影响断层垂向封闭性的主要因素。

In fault-developed block or in complicated overthrust structural area ,the strata being of various interval velocities may be in touch with each other or the same strata appear many times at the faults because of these factors as fault offset and formation fold, etc.

在断裂发育的断块区或复杂的逆掩构造区，由於断层错动及地层褶皱等因素，具有不同速度特徵的地层在断层处相互接触或同一套地层多次重复。

The page fault exception could be chained with other exceptions without causing a double fault .

页面错误例外的可能是用铁鍊与其他例外没有造成双发失误。

Based on the analysis of fault feature of teed circuit of parallel transmission line s, a new fault line selecting method is proposed.

针对T型线路中出现同杆双回线的线路结构，提出了判定故障分支的新方法。

First,the BP neural network to carry on the partial diagnosis to the fault information is used,then the fusion using the D-S evidence theory to the partial diagnosis result is carried on,and the final fault result is obtained.The introduction of D-S evidence theory increases the diagnosis result reliability and the accuracy,enhances the diagnosis algorithm compatibility.

首先用BP神经网络对故障信息进行局部诊断，然后利用D-S证据理论对局部诊断结果进行融合，进行全局诊断，得到最终的故障结果。D-S证据理论的引入，增大了诊断结果的可靠性和准确性，提高了诊断算法的适应性。

In the step of modeling, normalization in feature space is discussed. In the step of fault detection, SPE statistic is constructed more easily by virtue of the kernel matrix. Partial kernel PCA is developed to extend the fault isolation based on structured residuals to nonlinear system.

在建模阶段，讨论了特征空间标准化的问题；在故障检测阶段，提出了一种利用核矩阵构造SPE统计量的方法以便故障检测更易实现；在故障隔离阶段，提出了部分KPCA算法，把基于结构化残差的故障隔离方法推广到非线性系统。

Fault diagnosis of PLC control system includes fault diagnosis of peripheral equipment, hardware and software of system.

PLC控制系统故障诊断包括外设、系统和硬软件诊断。

This article illustrates a method of fault diagnosis based on fault Petri net .

介绍了利用故障 Petri 网构建的一种故障诊断方法。

It was shown that the 3D deformation in the tunnel at soft rock was obvious at F7 fault and phyllite section, with the characteristics of large deformation and longitudinal displacement developing in the opposite direction of work face and being stable at a distance about 2.0 times of tunnel diameter from the work face. And the 3D displacement of tunnels at F7 fault zone developed in an uneven symmetrical way, while there was good consistency for 3D deformation at slate section. Furthermore, there was a mutally verifying relationship between 3D deformation and ground stress distribution of tunnel region.

结果表明，F7断层和千枚岩地段软岩隧道三维位移十分明显，具有隧道大变形特性，其纵向位移背离开挖面方向发展并在相距开挖面约2.0倍洞径时趋于稳定状态；F7断层地段隧道三维位移呈不均匀对称地发展变化，而板岩地段三维位移变化的一致性较好；隧道三维变形规律与隧道区域地应力场的分布存在相互印证关系。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。