查询词典 fatigue strength

Fluid strength torque converter although can stepless change the torque in certain scope compared to, but because it exists changes turns between ability and the efficiency contradiction, at present the application fluid strength torque converter generally changes turns the coefficient insufficiently to be all big, satisfies the automobilism request with difficulty, therefore on the high-quality passenger vehicle, widely uses is fluid strength torque converter and the gear type transmission gearbox union composition fluid strength mechanical type variator.

液力变扭器虽然能在一定范围内无级地改变扭矩比，但由于它存在着变扭能力与效率之间的矛盾，目前应用的液力变扭器一般变扭系数都不够大，难以满足汽车使用要求，故在高级轿车上，广泛采用的是液力变扭器与齿轮式变速器联合组成液力机械式无级变速器。

The yield strength of the line pipe is the key factor for strength design of pipelines, but the deviation of the test result of yield strength by the most universal normative round bar specimen and flattened strip specimen cannot be ignored in high strength line pipes, which does give more bewilderedness to the inspection and evaluation of line pipe.

管线钢管的屈服强度是管线强度设计的基本参数，但是最常用的标准圆棒试样和板状试样测试钢管横向屈服强度的结果存在明显差异，并且差异随钢级的提高而增大，给实际的生产检验和评价带来困惑。

The artide focused on the cellule and molecule character of myocardic ischemia and ischemical reperfusion injury induced by strength training, the essential feature of strength training preconditioning and the signal transduction mechanism and the intra-cellular effector of myocardial preservation, proposing the research strategy, concrescencing the theory of contemporary strength training, clarifying some hot questions and important future directions on endogenous myocardial protection of strength training.

就力量运动引起相对心肌缺血及缺血再灌注损伤的细胞分子学特点、力量运动缺血预处理的基本特征及心肌保护作用的细胞信号转导机制与细胞内效应器及存在的问题进行阐述，提出研究策略。

The relationship between in situ target strength and depth of chub mackerel was established by selecting the length composition of mackerel was larger than 90%. Results showed that the in situ target strength of chub mackerel was changed significantly depend on depth up to 8.7 dB. And it indicated that the measurement of in situ target strength of fish with swim bladder should be modified by the relationship of target strength and depth, especially in chub mackerel, it may be led to overestimate the standing crop to 7.4 times of the assessment.

将科学鱼探所收录到的白腹鲭声学资料使用线性回归来检定现场标物反射强度与样本所在水深关系，检定结果显示出白腹鲭在不同水深时所反射的现场标物反射强度均会随著深度改变，并且呈现负相关的显著水准(p.01)，现场标物反射强度变动有8.7dB差异量，对白腹鲭鱼群现存量会超估7.4倍的差异。

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After preaging at 100℃for 24 h, retrogression at 200℃for 7 min, and reaging at 100℃for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210MPa in 3.0%NaCl+0.5%H2O2corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the microstructure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7 min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720 h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa， 767 MPa和9.1%，显示优越的综合性能。

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After pre-aging at 100 ℃ for 24 h, retrogression at 200 ℃ for 7 min, and reaging at 100 ℃ for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210 MPa in 3.0%NaCl+0.5%H2O2 corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the microstructure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7 min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720 h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa， 767 MPa和9.1%，显示优越的综合性能。

The results show that proper RRA heat treatment can improve SCC properties with retention of the high strength of T6 level. After pre-aging at 100℃ for 24 h, retrogression at 200℃ for 7 min, and reaging at 100℃ for 24 h, the ultimate tensile strength, yield strength and elongation of the alloy are 795 MPa, 767 MPa and 9.1%, respectively. Meanwhile the failure time of the alloy applied to tensile strength of 210 MPa in 3.0%NaCl+0.5% H2O2 corrosion condition is longer than 720 h. The corresponding TEM observation shows that after retrogression for 7 min and re-aging treatment, the micro- structure of grain boundary is similar to that treated in the T73 condition with coarsen and isolated distribution, and the microstructure inside grain is similar to that treated in the T6 condition with small and homogeneous distribution.

研究结果表明：在峰值时效T6状态下合金强度高，但抗应力腐蚀性能差；采用合适的RRA热处理工艺既能使合金保持T6状态下的高强度的同时，又能显著改善合金的抗应力腐蚀性能；经回归7min RRA处理后合金的晶界类似T73态析出相聚集粗化，而晶内类似T6态析出相细小弥散分布，在拉伸应力为210 MPa和3.0%NaCl+0.5%H2O2腐蚀液中，其断裂时间大于720h，相应的抗拉强度、屈服强度和延伸率分别为795 MPa，767 MPa和9.1%，显示优越的综合性能。

The results show that BFRC has favorable impact compressive strength and deformation;,and the impact compressive strength and deformation of BFRC is relational with strain rate and fibre volume content; with strain rate increasing, impact compressure strength and deformation enhance; the impact compressure strength of BFRC is better when the fibre volume content is 0.1%, and the deformation performance of BFRC is better when the fibre volume content is 0.3%.

研究结果表明，BFRC具有良好的冲击压缩强度和变形性能，且其冲击压缩强度和变形与应变率和纤维掺量有关；BFRC的冲击压缩强度和变形随应变率的增大而增加；纤维掺量为0.1%的冲击压缩强度较高，纤维掺量为0.3%时的变形性能较好。

The results show that the addition of cross-linker makes tensile strength of the material greatly increase. After the addition of dialdehyde starch, the tensile strength raises from 7. 2MPa to 13. 2 MPa. However, the strength of the material cross-linked by TDI greatly increases when the additive level is less than 10％ while the tensile strength of sample whose additive level is 20％ is even worse, which is mainly caused by the inner-flaw after cross-linking.

结果表明，交联剂的加入使材料的强度得到较大的改善，添加双醛淀粉后，材料的强度从原来的7.2MPa提高到13.2MPa，而添加TDI的材料在添加量10％以前强度有较大的提高，但20％添加量的样品的强度却很差，主要是由于形成的内部缺陷造成的。

Systematical researches were carried out on the cleavage strength of steel fiber concrete with 3 base strength grades,6 steel externalities and 4 fiber admixtures,and it is discovered that the cleavage strength of concrete increases as the base strength grade rises,and dumbbell-like,shield-like and hook-like steel fibers have good reinforcement effect while flat steel fiber has less reinforcement effect.

通过对3个基体强度等级、6种纤维外形、4种纤维掺量的钢纤维混凝土的劈拉性能进行系统研究，发现混凝土的劈拉强度均随基体强度等级增加而增大；哑铃、盾铃、端勾形钢纤维的增强效果较好，而平直形钢纤维的增强效果较小。

Metrorrhagia is also gynaecological problems of common diseases.

崩漏是妇科常见病也是疑难症。

WordFTP gives you the convenience and timesaving you need.

wordftp让您的方便和省时您所需要的。