查询词典 failure-free

In the experiment of this study, the failure structures of pipeline of exhaust system, rib material of water tank, slip-oil steady pin bolt and slip-oil separated valve made by copper alloy under water were cut individual with suit size for specimen. The X-ray, PT non-fracture detection, observation of metal micro-structure, hardness test, element spectrometer, SEM and EDS were used to investigate the mechanism of corrosion and failure.

实验首先将长期使用於水下环境之排烟系统管路、水柜肋材、滑油泵稳梢螺栓及船舶舱间柴油系统用隔舱阀之破损构件，分别裁取适当尺度之试件，藉由X-ray、PT非破坏检验、金相显微组织观察、硬度实验、腐蚀生成物机制研究、分光分析仪成分分析及利用SEM进行破断面形貌观察与EDS元素成分分析等实验。

According to the statistics show that the valve plunger pump cover up failure of the more prominent, and its failure mode of the main fracture.

据统计资料表明，柱塞抽油泵上阀罩失效情况较突出，其失效形式主要为断裂。

Objective To investigate the effect and side-effect of mifepristone in small doses comparing C53contraceptive in postcoital contraception.Methods 142women with normal menstruation were divided into two groups randomly.Observation group（n=66）were given mifepristone10mg and C53contraceptive5mg within72hours after unprotected intercourse or contraception failure.Control group（n=76）were given mifepristone with a sin-gle dose of10mg within72hours after unprotected intercourse or contraception failure.The effect side-effect and menstruation of the two group were compared.

目的 探讨低剂量米非司酮配伍双炔失碳酯应用于紧急避孕的效果方法将142例月经规律的合格妇女随机分 2组，观察组（66例）在避孕失败或无保护性性交后72h内开始服用米非司酮10mg+双炔失碳酯5mg，对照组（76例）在避孕失败或无保护性性交后72h内开始服用单剂量米非司酮10mg，观察两组避孕效果、不良反应及月经情况。

Deposit insurance system is used to prevent the risk of failure of commercial banks; deposit premium ratio under deposit insurance system should match with risk of bank failure.

第三，存款保险制度是用来防范商业银行的破产风险的，存款投保费率应该与银行的破产风险相匹配。

Long-term use in the process of the printer, you may find a wide range of print failure; order to be able to help you efficiently and quickly these failures, this article summarizes some common specially Print failure to answer the question, and I hope that can be useful for you .

在长期使用打印机的过程中，你可能会发现各种各样的打印故障；为了能帮助你高效、快捷地这些故障，本文特意总结了一些常见打印故障问题的解答方法，希望能对你有用。

At this time the relay contacts can be seen after the pull-off O5s This shows that ABS control module has control of the relay, as why did it after the pull-bounce, it should be is a system to monitor the failure of the circuit failure protection.

此时可看到继电器触点吸合O5s后断开，这说明ABS控制模块对继电器有所控制，至于吸合后为何又弹开，应该是系统监测到电路故障后的失效保护功能。

At this time the relay contacts can be seen after the pull-off O5s This shows that ABS control module has control of the relay,as why did it after the pull-bounce,it should be is asystem to monitor the failure of the circuit failure protection.The next testing.

此时可看到继电器触点吸合O5s后断开，这说明ABS控制模块对继电器有所控制，至于吸合后为何又弹开，应该是系统监测到电路故障后的失效保护功能接下来的检测工作。

We analyzed the characteristics of pulling-out curves and observed the characteristics of adhesion failure under SEM to obtain the mechanism of adhesion failure of Aramid cord-rubber composites.

着重对这两种粘合体的抽拔曲线特征进行分析，并采用扫描电镜观察其在不同粘合条件下的界面粘合破坏特点，以得出它们在不同条件下的粘合破坏规律和粘合破坏机理。

Next, author has proved it through ten samples for experiment, and then, we get the clear and definite understanding of failure mechanism of normal section, the failure state and the work behaviors of every component (flat steel wire web, inclined steel wire, concrete coat, longitudinal bar), established the formulas of the load-bearing capacity of the normal cross-section.

本章首先对3D板的正截面抗弯承载力进行了理论分析，并通过六个试件做了试验验证，明确了3D板正截面破坏机理、破坏状态以及3D板各组成构件（钢丝平网、斜丝、混凝土面层、纵向受拉钢筋）的受力性能，建立了承重型3D板正截面承载力计算公式及适用条件。

However, the fact that you are graduating from Harvard suggests that you are not very well-acquainted with failure. You might be driven by a fear of failure quite as much as a desire for success.

我想说，并不是我太迟钝，我觉得你们还不曾知道什么是艰难困苦，或者什么是心碎的感觉，因为你们还年轻，而且天资聪明，受到良好教育。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。