查询词典 experimental probability

Drying experiment of pelleted corn seed was conducted through three factor and three level orthogonal experimental design, its drying characteristic curve was obtained as an index curve, and the effects of various experimental factors on drying property were analyzed....

采用正交试验的方法，对玉米丸粒化种子进行了 3因素 3水平的干燥试验，得出其干燥曲线为指数曲线，并分析各试验因素对干燥特性的影响。

Peribulbar injection of dexamethasone 0.5mg was applied in the experimental group every other day 48 hours after operation to the end of the experiment, and the growth state of conjunctiva in both groups were observed. 2 HA implants from experimental group and control group respectively were extracted for testing the positive expression of VEGF by immunohistochemistry 3,7,14,21,28 days after operation.

术后滴妥布霉素滴眼液4次/d，实验组术后48h起隔日球周注射地塞米松0.5mg和实验结束，并观察两组的结膜生长情况；实验组与对照组分别于术后 3，7，14，21，28d摘取2只HA植入物行免疫组织化学检测VEGF阳性表达情况。

Objective The influence of experimental perilymphatic fistula on inner ear morphology was investigated to establish an experimental model which could offer a warranty for cinical treatment.

目的：建立动物模型观察实验性外淋巴瘘对内耳形态学的影响，为临床治疗外淋巴瘘提供实验性依据。

The periostea of both experimental and control side of the mandibular ramus were taken and prepared, 2 of each 5 rabbits in a group were prepared for HE stain detection and 3 for proliferating cell nuclear antigen immunohistochemical detection.Results:1, The newly formed bone was detected on the lateral aspect of mandibular ramus after periosteal distraction. The bone was shaped like a hill. It looked very low and was full of holes at postoperative day 28. With the time of consolidation period lengthened, the newly formed bone matured gradually. X-ray examination showed the new bone shaped like a hill. The average values of new bone height at postoperative days 28,35,42 and 56 were 1.86 + 0.15mm, 2.29 + 0.29mm,3.19 + 0.13mm and 4.70 + 0.45mm. Histological examination of both HE stain and picricacid-fuchsin stain showed the increase in the number of osteoblasts and the change in the orientation of collagen fibers and bone trabecula. There were no significant differences between newly formed bone and original bone on the lateral aspect of mandibular ramus at postoperative day 56 histologically.2 Compared with the control side, the distracted periostea proliferated obviously under the microscope, and the number of periostealcells increased with satiation of cellular nuclear per unit area. The images of PCNA immunohistochemical stain of periosteum showed that the experimental periosteum proliferated obviously after distraction compared with the control side.

结果：骨膜牵张成骨的实验研究南京医科大学硕{学位论文l、骨膜牵张后，可见下领升支外侧的骨皮质上有新骨形成，新骨呈山峰状凸起，术后第28天的新生骨较低平，多孔隙，随着固定时间的延长，新骨逐渐成熟；下领升支前后向切线位X线投照显示新骨呈山峰样隆起；经测量，术后第28、35、42和56天组平均新生骨厚度分别为x.86士0.15mm、2.29士0.29mm、3.19士0.13mm和4.70 土0.45mm；脱钙骨组织的HE染色和不脱钙骨组织的苦味酸一品红染色的组织学观察均显示了新生骨在成骨细胞数量上的增长，以及胶原纤维和骨小梁排列方向上的变化，术后第56天的新生骨在组织学上与原升支骨组织已无明显区别。2、HE染色显示，与对照组相比较，实验侧骨膜增生明显，细胞间排列紧密，单位面积内骨膜细胞数增多，细胞核饱满；骨膜PCNA 免疫组化染色显示，与对照侧相比较，实验侧骨膜在牵张后出现了明显的增生迹象，PCNA阳性细胞分布紧密，单位面积内阳性细胞数较对照组多，靠近骨表面的骨膜中的阳性细胞数更多而且分布更为紧密。

The photoelastic coating method used to carry out experimental research of stress distribution is the relatively suitable method in experimental mechanics at present. But it is necessary to improve the measurement accuracy and the degree of automation.

光弹性贴片法是现有的实验力学方法中比较适用于对锻压设备应力分布进行研究的一种方法，提高其测量精度和自动化程度有利于扩大其应用领域。

In the light of looking up -finishing-inquiring into the literature,The subject ntegratedly applied the knowledge of botany and phytotomy and Authentication of Chinese Medicines and the experimental technology to study taxonomy and anatomy of Cornus chinense Wanger and its kindred plant.To combine the knowledge of natural medicinal chemistry instrumental analysis,pharmaceutical analysis and experimental technique,Glycosides chemical components of Cornus chinense Wanger and its kindred plant were qualitatively analysised by using TLC.

以文献查阅-整理-调查为基础，综合运用植物学、植物解剖学、中药鉴定学知识与实验技术对川鄂山茱萸及其近缘植物进行分类学处理与解剖学研究，结合天然药物化学、仪器分析、药物分析等学科的知识与实验技术，用TLC定性分析川鄂山茱萸及其近缘植物的苷类化学组分；用HPLC测定川鄂山茱萸不同器官、细胞组织、果实不同采集期的熊果酸、马钱苷的含量并进行色谱条件优化。

Experimental studies were conducted at the Yucheng Comprehensive Experimental Station of the Chinese Academy of Sciences during the period from March to June in 2003 . Respiration of a pulverous sandstone soil was studied under cultivation of winter wheat over a growth season . Soil CH4 was measured by the Static-Chamber method combined with Gas Chromatography technique .

本文利用静态箱／气相色谱分析的方法，在中国科学院禹城综合试验站，对华北平原冬小麦生长旺季期间麦田土壤中CH_4气体通量进行了测定，试验起止时间为2003年3～6月，得出华北平原典型冬麦田土壤是大气CH_4的弱吸收汇。

A quasi-experimental study design was used to evaluate the effectiveness of the intervention. An experimental school and a comparison school within the same administrative district were purposively selected.

为评价介入效果，采用类实验研究设计，立意选取同一行政区内的一所中学为实验学校，另一所中学为对照学校。

The study on the pathogenesis of the growth of the experimental saccular aneurysms in rats Objective To study the possible pathophysiological mechanisms of the growth of the experimental saccular aneurysms in rats.

大鼠实验性囊性动脉瘤生长塑形机制的研究目的探讨在囊性动脉瘤生长塑形过程中可能存在的血管生物学方面的病理生理机制。

In this paper, two assemblies of special test equipments have been designed and fabricated by authors in our laboratory: namely Catalyst Molding Process Analyzer and Catalyst Mechanical Process Tester. These new skills are developed for the dynamic studies on whole mold forming process and crushing process of Fe-Cr WGHS catalyst pellet. Based on the orthogonal experimental design, the effects of some factors during the forming process of solid catalyst, such as predensification proportion, calcination time, calcination temperature and content of graphite on the mechanical strength of catalyst pellets are systematically examined, and the molding conditions have been optimized. Based on the experimental data, the relationship between catalyst density and forming pressure are educed, and the physical significances of some related parameters are described. The parameter of macro scopic elastic moduls has been suggested to character the mechanical properties of molding catalyst. The effects of molding pressure on mechanical properties of catalyst pellets are discussed, and results show that there exists a optimal molding pressure for the ideal mechanical properties: when over-high or over-low pressure is applied, the specific surface area and side crushing strength of catalyst pellets will decreased. The "rebound effect" will be undermined by the unsuitable pressure maintain process, resulting in the apparent decrease of mechanical strength of catalyst pellets.

本研究通过自行设计制造的催化剂模压成型过程分析仪（Catalyst Molding Process Analyzer， CMPA）和催化剂力学性质测试仪（Catalyst Mechanical Properties Tester， CMPT），以Fe-Cr系高温变换催化剂片剂为研究对象，对成型过程和受压破碎过程提供了全过程动态研究的新手段；本研究利用正交实验设计方法考察了固体催化剂成型过程中诸因素（包含预密致比例、煅烧时间、煅烧温度和石墨含量等）对催化剂成型体强度的影响，并对成型条件进行了优化；根据实验结果，关联确定了固体催化剂成型过程中的密度－压力关系式，并对方程中诸因子的物理意义进行了描述；提出了一种利用宏观弹性模量来表征成型催化剂的力学性质的方法；研究讨论了成型压力对催化剂成型体强度性质的影响，结果表明：对于催化剂成型体的强度和比表面性质，成型压力存在着一个最佳值，过高的成型压力会导致比表面积和侧压强度的降低；不适当的成型压力的维持时间会破坏&压力回弹&作用，造成催化剂成型体的机械强度明显降低。

We got alerted a couple of times while we were down south that HETs were on the way to bring us back up north because things were going to go hot again, but it was just rumors.

南下的途中我们不只一次得到警告说重型装备运输车将拉着我们重新北上，因为局势正在变得重新紧张起来，但这只是谣传。

It's the one where they find the ghost in the salt mine.

这一集是演他们在盐矿找到鬼