查询词典 experiment with

The experiment is began with the runoff quality on the diverse roofage and different grade roadway, the results are as follows:(1) The concentration of contamination is different with the diverse roofage, and SS value is also different with the style roof;(2) In the beginning , the concentration of COD value and SS value is higher ,but the runoff quality will be reduced to steady gradually along with the rainfall duration increase;(3) The city roadway runoff is worse than the roadway of university ,because the city roadway runoff involve vehicle n people and the sanitation and material of roadway;(4) Based on the analysis of rainwater quality , the paper provide the process of rainwater treatment for roof, roadway, and lawn.

对教学区内不同建筑物，及道路上的雨水径流水质进行监测，得出以下结论：(1)材料不同，径流雨水中污染物浓度不同，屋顶类型不同，径流雨水中SS浓度亦不同；(2)初期径流污染物浓度很高，随降雨历时的延长，COD和SS浓度逐渐下降并趋于稳定；(3)道路污染与路面材料、来往车辆、人员流动、路面卫生状况有关。市区道路相比校园内道路，水质较差；(4)对雨水水质分析基础上，分别对建筑屋顶、道路、绿地提出雨水利用的处理工艺。

It was indicated by the CALPHAD that the solute content at the end point of primary solidification changes synchronistically with the start point, solute content in dendritic arm and the partition coefficient increase with the solid fraction. Simple Scheil equation was shown to be able to calculate the eutectic amount on the base of partition coefficient calculated by thermodynamics, its prediction for the different solutes is self--consistent and agreeable with the CALPHAD. The eutectic amount and SDAS was measured in DC experiment and compared to model value, it was shown that the experimental data are in agreement with the model prediction.

相图计算耦合Scheil模型的计算结果显示， Al--Cu--Zn合金单相凝固结束点的溶质含量与凝固初始点的成分同步变化，溶质含量和溶质分凝系数随凝固过程的进行不断增加；在热力学计算出合金分凝系数的基础上，简单Scheil方程可以计算初生相含量，从不同溶质得到的计算结果是自洽的，并与相图计算耦合Scheil模型的预测值一致；实验测定了不同成分铝合金的共晶含量和枝晶间距，实验数据与模型结果基本一致。

This article mainly simulates gradually damage destruction process of rock, major in determinationg the definition of rock three-dimensional damage tensor, simplify to the damage tensor and obtain its engineering calculation method, and obtains the basic expression form of equivalent stress by equivalent stress assumption, symmetrization to the actual stress, thus obtains construction relation of the festival principle of three-dimensional damage rock mass, finally couples elasticity- plasticity with damage in the finite element equation, with reference to elasticity-plasticity gradually degenerated method thought, simulates rock damage to advance gradually the destruction process in finite element method, draws up elasticity - plasticity and damage coupling two-dimension finite element procedure with the C language in the VC contact surface, by simulating experiment destroyed process, acquires destruction image and the axial load distortion curve of model, agreement with the experimental result.

本文主要模拟岩石渐进损伤破坏过程，确定岩石三维损伤张量的定义，对损伤张量进行简化计算并得出其工程计算方法，采用等效应力假设得出有效应力的基本表达形式，对有效应力进行对称化，得出节理损伤岩体的三维本构关系，在有限元方程中实现弹塑性和损伤耦合；借鉴弹塑性渐进退化方法的思想，采用有限元的方法模拟岩石损伤渐进破坏过程，用C++语言在VC界面编制了弹塑性和损伤耦合的二维有限元程序，通过模拟已有的实验破坏过程，得出模型的破坏图像和轴向荷载变形曲线，与实验结果基本一致。

In the experimental study, 12 joints tests are completed, including 5 uniplanar X joints loaded with axial forces, 3 uniplanar X joints loaded with in-plane bending, 4 multiplanar XX-joints loaded with axial forces, with the emphasis on the influence of β and the existence of the out-of-plane braces, of which the multiplanar XX-joints tests is the first experiment project in china.

试验重点研究节点支主管宽度比β以及平面外支管荷载等因素对节点性能的影响，共进行了3个足尺方管平面X型受压节点，3个足尺方管平面X型受弯节点、2个方、圆管杂交平面X型受压节点和4个足尺方管空间XX型节点试验，其中方管空间XX型相贯节点试验是国内的首次试验。

The above method can be used as a general method of determining molecular weight distribution of polymers.4.Solid-state ~1H wide-line NMR and ~(31)p magic angle spinningNMR were applied to a series of PEI/DNA complex samples with different PEI molecular weights and nitrogen/phosphatemolar ratios,in order to disclose the influence of various structural factors on the interactions and morphology.The results of ~1H NMR spectra showed that the linewidth of the PEI signal was greatly broadened with increasing the N/P ratio.Meanwhile,in the ~(31)p M_AS experiment,the signal was found to shift upfield with the increase of the N/P ratio.Both ~1H and ~(31)P NMR experiments demonstrated that the interaction between two constituents and subsequently the morphology of the complexes vary with the N/P ratio.

首次将固体核磁共振应用到聚合物/DNA复合物体系，观察复合物体系中不同N/P比对其相互作用和相结构的影响，研究表明N/P比的变化对聚乙烯亚胺/DNA基因递送体系分子水平上相互作用有着很大的影响；另外，还发现不同分子量的聚乙烯亚胺聚合物载体在N/P比为3的情况下对复合物中DNA的微观尺度没有明显影响；通过氢的自旋扩散实验，首次测得在PEI/DNA复合物体系中DNA相尺寸的大小，并发现在体系中N/P比达到3以上的复合物中DNA和PEI达到了分子水平上的相容。

The pot experiment results showed that inoculation with A1501 and A1513 could promote the growth and grain yield of rice. Comparison with the non\|inoculation, the grain yeild of rice treated with A1501 and A1513 increased by 8 5% and 10 3% respectively. And %Ndfa of rice shoot and grain estimated by 15 N\|isotope dilution method was 9 00% and 11 5%, respectively, which was consistent with the increment of the total N(8 5% and 11 6%,respectively).

盆栽结果表明，接种A.faecalis 显著提高了水稻的生长，接种A1501 和A1513 的水稻稻谷产量分别比未接种提高了85％和103％，用15N 同位素稀释法估测水稻地上部总氮中来源联合固氮的百分率达900％和115％，其结果与水稻地上部总氮量的增加幅度（86％和116％）基本一致。

Experiment group was treated with stomahesive powder combined with barrier film, and control group was treated with zinc oxide ointment combined with lamp roasting.

结果：实验组显效26例，有效3例，无效1例；对照组显效10例，有效18例，无效2例，两组之间治疗效果有显著性差异，实验组治疗效果明显优于对照组(P.05)。

The results revealed that screwdrivers with triangle shaped handle could help subjects produce the maximum torque. Besides, using screwdrivers with hexagon shaped handle spent the least time, generated the minimum biceps muscle activity, and bad the least subjective fatigue rating. Moreover, wearing an anti-static glove or being barehanded can produced the maximum torque and spent the least time as well. Experiment 2 evaluates the handle diameter of screwdriver (30 mm, 34 mm or 38 mm) and operation plan. The results showed that the torque increased with the increase of the radius, the operation time and the brachioradialis muscle activity also increased with the increase of the radius.

本 研究共分为三次实验，实验一分析握把造型(八角形、锐角六角形、圆角六角形、枪型、圆角三角形)与手套(棉质手套、防静电手套、赤手)的影响，结果显示三角形造型握把可产生最大扭力，六角形造型握把的锁附螺丝时间最短、二头肌肌肉活动度最低、主观整体疲劳评比最低，防静电手套与赤手状态的扭力最大并且锁附螺丝时间最短；实验二比较握把直径(30 mm、34 mm、38 mm)与作业面的影响，结果显示直径越大扭力越大，但直径越小锁附螺丝时间则越短，且肱桡肌肌肉活动度越低。

In the towing tank, the calm water resistance experiment of SWATH model ASW-2 with canted struts has been conducted and researched. And based on the above-mentioned work, the method is also adapted to cope with the calculation of wave resistances for both vertical and canted-strut SWATHs. It is shown that the theoretical calculation results agree well with the test results. Compared with some other materials about SWATH, the results in this thesis show better agreement.

作者在船模水池进行了斜支柱SWATH的静水阻力试验研究，并在前面工作的基础上，通过对理论模型的扩展，提出了直/斜支柱SWATH兴波阻力的理论模型和相应的数值计算方法，理论计算与试验结果吻合良好，与所见到的一些SWATH船型的计算资料相比，具有更好的符合程度。

Preparation of the cathode includes:shaping under the press of 40Mpa, sintering at 550℃for 1 hour and at 900℃for 8 hours and threading with molybdenum bar; Considering the literatures we choose CaCl2 as salt for preparation titanium. Pretreatment of salt is for 1 hour at 100℃and for 2 hours at 300℃. Partial pressure of oxygen which need lower than 5.11×10-7Pa to reduct titanium oxides and hygroscopic property of salt need a sealed equipment to electrolyse. And finally successfully designed a satisfied one and the results show that the equipment can be satisfied the requirment of the experiment. Flow of the inert gas is 1.5L/min, the voltage is 2.8 V, temperature is 850℃and time is 2 hours during pre-electrolysis. Flow of the inert gas is 0.2L/min, the voltage is 3.1 V, temperature is 900℃and time changes with the mass of TiO2 during electrolysis, namely the greater need the longer time; To eliminate influence of salt and other impurities, the products need to wash with distilled water and dilute chlorhydric acid , then wash with dilute hydrochloric acid under supersonic wave assistant. Finally, electrometical properties of the electrolysis of TiO2 is researched by cyclic voltammetry and chronoamperometry, and results show that there are two main reodox steps, namely from TiO2 to TiO and from TiO to Ti.

阴极制备主要包括40MPa压力下模压成型、两段式烧结(1小时内升至550℃保温1小时，再1小时升温至900℃保温8小时)及烧结后TiO2块打孔用钼棒串接三个主要环节；实验中选用CaCl2作为电解熔盐，并对其进行预处理(100℃，保温1小时； 300℃，保温2小时)；经热力学计算，还原钛氧化物的氧分压至少要低于5.11×10-7Pa，结合电解过程中所用熔盐CaCl2有极强的吸水性的特点，电解装置应有较高的密封性，自行设计了一套密封性可靠的电解装置，便于实验过程中熔盐预处理和氧分压的控制；通过干燥处理预电解过程中Ar流量大约为1.5L/min、电压为2.8 V、温度为850℃、时间为2小时，电解过程中Ar流量大约为0.2L/min、电压为3.1V、温度为900℃，实验结果表明电解时间与TiO2质量密切相关，质量越大需要电解的时间越长；通过自来水冲洗—稀盐酸浸泡、洗涤—在超声波辅助作用下稀盐酸洗涤，可减少熔盐及其它杂质对电解产物检测结果的影响；最后，通过循环伏安法、计时电流法对电解机理的研究，确定电解还原TiO2制备金属钛主要经历了TiO2-TiO-Ti的过程。

According to the clear water experiment, aeration performance of the new equipment is good with high total oxygen transfer coefficient and oxygen utilization ratio.

曝气设备的动力效率在叶轮转速为120rpm～150rpm时取得最大值，此时氧利用率和充氧能力也具有较高值。

The environmental stability of that world - including its crushing pressures and icy darkness - means that some of its most famous inhabitants have survived for eons as evolutionary throwbacks, their bodies undergoing little change.

稳定的海底环境─包括能把人压扁的压力和冰冷的黑暗─意谓海底某些最知名的栖居生物已以演化返祖的样态活了万世，形体几无变化。