查询词典 eutectic

The results show that the microstructures of these three kinds of coating are different from those of the matrix (20 steel). The wear resistance of the flame spray coating is 4. 9 times that of the matrix. This is caused by the existance of hard noncrystal microparticals. The wear resistance of the coating by flame spray welding is 6. 3 times that of the matrix. The reason is that the fine crystal grains can be formed and the solution strengthening, dispersion hardening can be induced by these alloy elements. The resistance of the laser remelt coating is 8. 8 times that of the matrix. This is due to the solution strengthening, dispersion hardening and the existence of very hard dendritic crystal, eutectic and martensite in the microstructure.

作者指出，喷涂层由于层内有一定数量高硬度的合金非晶质点存在，其耐磨性是钢基体的4.9倍；喷熔层内合金晶化产生的晶粒细小，合金元素能起固溶强化作用，也能生成化合物产生弥散硬化作用，故此耐磨性是钢基体的6.3倍；激光涂敷层除所含合金元素产生的固溶强化和弥散硬化作用外，表层组织为高硬度的枝晶+共晶和马氏体，故其耐磨性是钢基体的8.8倍。

As Hf is added into the alloy the volume fraction of γ/γ′eutectic is increased and the temperature range between solidus and liquidus is expanded, which may maintain the effective linkage of interdendritic capillary feeding channel, thus improving the resistance of DS castings to ...

铪的加入，增加了共晶γ/γ′的体积分数，扩大了凝固范围，改善了合金凝固后期的毛细补缩通道的联系，从而减轻了热裂倾向性。随着铪含量的提高，合金的中温持久性能，特别是中温横向持久性能有所提高。

The relationship of modification level and △TEG(the eutectic temperature difference between modified and unmodified alloy) was established.

利用自主开发的铝合金热分析系统，研究了Sr加入量、变质后保温时间对ZL104合金冷却曲线的影响，建立了变质等级与变质前后共晶温度的降低值△TEG之间的对应关系。

By adding ZrO2(4Y) to the thermit,the influences of centrifugal force and eutectic composition on the microstructure,mechanical properties, strengthening and toughening of ceramics lining are researched.

基于燃烧合成理论，在铝热剂中添加ZrO2(4Y)粉末，采用离心技术制备出了高强度、高韧性的Al2O3/YSZ共晶系陶瓷内衬复合管，并研究了离心力、共晶成分对陶瓷内衬显微结构、力学性能及强韧化本质的影响。

In the experience Salt、Sb and thulium can change primary Si and eutectic Si through changing the morphology, but the effect of modification is very defferent.

其中钠盐的变质效果强，锑次之，稀土变质效果最差；变质剂对Si相的变质主要是通过孪晶凹角沟槽机制进行的。

Actinomorphous structure is mixed structure of martensite and γ mischcrystal covered with floriated and dendritic eutectic.

放射状组织为马氏体相和γ合金固溶体相的混合组织上均匀覆盖着的大量的花状和枝晶状共晶体。

After T6 heat treatment, the eutectic Si particles become small granular or short bacilliform, and the aspect ratio and area fraction of Si particles decrease evidently. The energy of the T6-treated castings is 1.453.80 J, which is higher than that of the as-cast castings. Furthermore, the fracture mechanisms of different regions in the castings were analyzed and discussed.

结果表明：铸态下共晶Si粒子大多为纤维状或长针状，呈不均匀的网状分布，冲击吸收功在1.17~2.35 J的范围内变化后；经T6热处理后，团簇状Al-Si共晶相明显减少，共晶Si粒子呈现出粒状或短棒状，且细小均匀，Si粒子的长宽比和面积分数都有显著降低，冲击吸收功在1.45~3.80 J的范围内变化，比铸态有明显提高。

In this paper,the built-up welding rod of the wear-resisting alloy with boronic compound hard phase is studied by author which is a Cr-Mn-B alloy system, the structure of buitt-up welding layer is consist of eutectic of austenite and contain boronic compound hard phase.

该文研究的硼化物硬质相耐磨合金堆焊焊条为Cr－Mn－B合金系，堆焊层组织由奥氏体和含棚化物硬质相的共晶体组成，由于硼化物硬质相的硬度高，故含硼化物硬质相的共晶体在磨损过程中起到耐磨骨架作用，显著地提高了堆焊层的耐磨性。

The results showed that the eutectic point and the consolute point of longan's pulp materials were -26℃ and -20.0℃ in the vacuum freeze-drying, respectively.

为了确定龙眼真空冷冻干燥的工艺参数，以&乌龙岭&龙眼为材料，采用电阻法测量龙眼真空冷冻干燥的物料共晶点和共熔点温度，并应用单因素和正交试验，以冻干品形态保持、色泽、生产能耗等指标进行综合评定考察冻干效果，优化龙眼真空冷冻干燥工艺。

Seven to ten percent attapulgite clay mixed with the eutectic salt, sodium sulfate decahydrate, will keep anhydrous crystals suspended in the solution where they will hydrate during phase change and hence contribute to the heat absorbed and released when Glaubers salt are used for heat storage.

七，百分之十凹凸棒石粘土混合的共晶盐，硫酸钠十，将继续暂停无水晶体中的解决方案，他们将在水合物相变，从而有助于吸收和释放热量时Glaubers盐用于蓄热。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。