查询词典 eutectic
- 与 eutectic 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
The results show that the influence of electromagnetic stirring on the following solidification behavior is more outstanding when the stirring temperature is near the liquidus; the number of α dendrites is declined and the morphology is transformed into rosiness and non-dendritic grains; the Al-Si eutectic's transition from lamellar structure to fibrous structure occurs in the eutectic reaction too.
结果表明:随着搅拌温度的降低至液相线附近时,电磁场对熔体凝固行为的影响逐渐显著;α初晶中树枝晶不断减少并逐渐转变蔷薇状晶和非枝晶;水淬后Al-Si共晶组织也由粗大的片层状转变为细小的纤维状和鳞片状结构。
-
SnPb eutectic solder reflow on BGA pad metallized with Au/Ni to form solder bump with induction self excite heat under alternate electromagnetic radiation is performed, and impacts of induction self excite heat and solid state aging on interfacial reaction between SnPb eutectic solder and Au/Ni metallization are investigated.
进行了交变电磁辐射下附Au/Ni镀层BGA焊盘上SnPb共晶钎料球感应自发热重熔形成钎料凸台的实验,并分析了感应自发热重熔以及固态老化对SnPb共晶钎料与Au/Ni镀层焊盘界面反应的影响。
-
It was indicated by the CALPHAD that the solute content at the end point of primary solidification changes synchronistically with the start point, solute content in dendritic arm and the partition coefficient increase with the solid fraction. Simple Scheil equation was shown to be able to calculate the eutectic amount on the base of partition coefficient calculated by thermodynamics, its prediction for the different solutes is self--consistent and agreeable with the CALPHAD. The eutectic amount and SDAS was measured in DC experiment and compared to model value, it was shown that the experimental data are in agreement with the model prediction.
相图计算耦合Scheil模型的计算结果显示, Al--Cu--Zn合金单相凝固结束点的溶质含量与凝固初始点的成分同步变化,溶质含量和溶质分凝系数随凝固过程的进行不断增加;在热力学计算出合金分凝系数的基础上,简单Scheil方程可以计算初生相含量,从不同溶质得到的计算结果是自洽的,并与相图计算耦合Scheil模型的预测值一致;实验测定了不同成分铝合金的共晶含量和枝晶间距,实验数据与模型结果基本一致。
-
The results show that as for the as-cast castings, eutectic Si particles are characterized as fibrous or long acicular shape as well as in homogenous distribution, and the impact absorbed energy varies from 1.17 to 2.35J. After T6 heat treatment, the eutectic Si particles become small granular or short bacilliform, and the aspect ratio and area fraction of Si particles decrease evidently. The energy of the T6-treated castings is 1.45-3.80 J, which is higher than that of the as-cast castings. Furthermore, the fracture mechanisms of different regions in the castings were analyzed and discussed.
结果表明:铸态下共晶Si粒子大多为纤维状或长针状,呈不均匀的网状分布,冲击吸收功在1.17~2.35J的范围内变化后;经T6热处理后,团簇状Al-Si共品相明显减少,共晶Si粒子呈现出粒状或短棒状,且细小均匀,Si粒子的长宽比和面积分数都有显著降低,冲击吸收功在1.45~3.80J的范围内变化,比铸态有明显提高。
-
The result showed that Si--Si covalent bond eAsts in the melt of eutectic and hyper--eutectic alloy and Sr has capability to weaken the coto bond.
结果表明,在共晶及过共晶的合金的液态结构中,存在着Si—Si共价键,Sr有削弱这些共价键的倾向。
-
The solidification of interdendritic eutectic of hypoeutectic gray iron has the same characteristics as eutectic gray iron.
界面呈锯齿状的片状石墨/奥氏体共晶的生长过程不仅受液相扩散的控制,还受固相扩散的控制。
-
The current theory and application of Al-Si alloy mainly focus on the study of hypoeutectic and eutectic, therefore we systematically analyzed the modification process of hypereutectic Al-Si alloy based on the methods and results of predecessors. Several factors including the modification temperature, the content of modifier, the available holding time, the times of repeat melting , the casting temperature and the speed for cooling have been studied in order to understand its effects to the composition, function and performances of primary silicon and eutectic silicon.
中文摘要本文针对目前Al-Si合金相关应用和理论的研究多集中于亚共晶和共晶合金的情况,在前人的研究成果和研究方法的基础上,对过共晶Al-Si合金变质处理进行了较为系统的分析,研究了变质剂的成分配比、变质温度、变质剂的加入量、变质后的静置时间、浇注温度及冷却速度等因素对过共晶铝硅合金中初晶硅和共晶硅的大小、形状、数量和分布的影响。
-
The current theory and application of Al-Si alloy mainly focus on the study of hypoeutectic and eutectic, therefore we systematically analyzed the modification process of hypereutectic Al-Si alloy based on the methods and results of predecessors. Several factors including the modification temperature, the content of modifier, the available holding time, the times of repeat melting , the casting temperature and the speed for cooling have been studied in order to understand its effects to the composition, function and performances of primary silicon and eutectic silicon.
本文针对目前Al-Si合金相关应用和理论的研究多集中于亚共晶和共晶合金的情况,在前人的研究成果和研究方法的基础上,对过共晶Al-Si合金变质处理进行了较为系统的分析,研究了变质剂的成分配比、变质温度、变质剂的加入量、变质后的静置时间、浇注温度及冷却速度等因素对过共晶铝硅合金中初晶硅和共晶硅的大小、形状、数量和分布的影响。
-
There occure 10 stoichiometrical compounds with RE∶Ag=1∶5,2∶9,1∶4,14∶51,2∶7,1∶3,1∶2,1∶1,3∶2和5∶2 and 19 crystal structures,4 eutectic systems with 10 eutectic reactions,and 8 peritectic reactions in Ag-RE systems.
在Ag-RE系中出现1∶5、2∶9、1∶4、14∶51、2∶7、1∶3、1∶2、1∶1、3∶2和5∶2十种化学计量化合物和19种晶体结构,4个共晶系10种共晶反应和8种包晶反应。
-
But where there are brittlement intermetallics segregating in pre-eutectic phase , the non-eutectic phase maybe make the coating crack more susceptibly because of their resistance to dislocation moving.
在多道搭接熔覆时,搭接区结晶方向与激光扫描方向的夹角越小,越有利于提高熔覆层的抗裂性。
- 推荐网络例句
-
However, as the name(read-only memory)implies, CD disks cannot be written onorchanged in any way.
然而,正如其名字所指出的那样,CD盘不能写,也不能用任何方式改变其内容。
-
Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.
镀锌钢托盘多用于出口,替代木托盘,免薰蒸,符合欧盟、北美各国对出口货物包装材料的法令要求;喷涂钢托盘适用于重载上货架之用,托盘表面根据需要制作成平板状、波纹状及间隔形式,满足不同的使用要求。
-
A single payment file can be uploaded from an ERP system to effect all pan-China RMB payments and overseas payments in all currencies.
付款指令文件可从您的 ERP 系统上传到我们的电子银行系统来只是国内及对海外各种币种付款。