查询词典 error

We apologize for any trouble/inconvenience you have been put to by our error, and will do our best to prevent any reoccurrence of this sort of error.

对于此次失误给贵公司带来的麻烦，我们表示由衰歉意。今后我们一定尽力，使这类错误不再发生。

This paper discusses a fast calculation method of GPS carrier phase integer ambiguity resolution, analyze independent variables in search space, derivate new residual transition matrix which directly associates all measurement error with minimum search space, and search space is minimized through selecting the ambiguity combination which is consistent with satellite geometry size and measurement error.

探讨了一种GPS载波相位整周模糊度的快速求解方法，分析了搜索空间中的独立变量，推导出了新的传递矩阵。该矩阵将所有的测量残差直接和最小求解搜索空间相关联，通过仅选择那些与卫星几何尺寸和测量残差一致的模糊度的组合，搜索空间被最小化。

A new switching scheme to the gain of variable structure control signals is proposed. The following important open problems in standard VS-MRAC and MRAC are solved by using the scheme: 1 . a prespecified transient and steady-state performance index for tracking error can be achieved without requiring any information about the plant high frequency gain sign when relative degree of modelled part of plant is one, and 2 . it is shown that as long as the performance indexes are guaranteed for the auxiliary errors, each of which in dynamics is a sub-system with relative degree one, the tracing error will converge to a small residual set in a prespecified transient time when relative degree of modelled part of plant is greater than one.

提出了一种控制增益可切换的变结构自适应律，解决了如下变结构模型参考自适应控制（包括基于调参律的模型参考自适应控制）理论研究中长期没有解决的问题：当对象建模部分相对阶为1、高频增益符号未知且存在非线性输入扰动和未建模动态等情况下，系统跟踪误差可满足预先给定的动态和稳态性能指标；当对象建模部分相对阶大于1且存在非线性输入扰动和未建模动态时，可保证系统跟踪误差在预先给定的过渡过程时间内收敛到一个残差集中； 5。

Based on the order number 10, the quadratic sum of residual error is 533%, the extrapolating result is wrong. But with the order number 9, the quadratic sum of residual error is 0.673%, the result is right

对於表面特定温度为θ(0， t)的曲线，测得其0.0129cm处的温度变化规律反推，选取阶数为10时，剩余误差平方和为533%，外推结果错误，选取阶数为9时，剩余误差平方和为0.673%，外推结果正确。

It was found that both the root mean square error and the mean error were minimal when using the neural network and fuzzy controller.

在临床试验部分，本研究针对四位受测者进行不同控制器的控制品质比较，结果发现以类神经网路加上模糊控制器的控制方法，其均方根误差及平均差皆为最小。

The simulation result shows that this dynamical prediction model has the performances like, better generalization, stronger robust, and preferable accuracy (the relative root mean square error of air is lower than 10%, and the relative root mean square error of oxygen is lower than 19%).

仿真研究结果表明：该动态预估模型具有较好的泛化能力和较强的鲁棒性，并具有较好预测精度(风量预测的相对均方根误差小于10%，氧量预测的相对均方根误差小于19%)。

It was found that the predicted results of the mathematic model are good when the number of samples is 15 in calibration model and that in validation model is 6 (the total is 21) In that case, the value of the root mean square error of the estimation of calibration and the root mean square error of prediction of validation are very small(0.0115 and 0.0105 respectively) and almost the same.

结果发现，当校正集样品数为15检验集样品数为6（总样品数为21）时，使用外部检验法建立的数学模型预测结果较好，其校正集的均方根误差和检验集的预测均方根误差（分别为RMSEE和RMSEP）均较小（分别为0.0115和0.0105），而且很接近。

A large number of commercial data were simulated, and the high performance of the soft-sensor is demonstrated by the fact that the maximum relative error, relative root mean square error and tracking precision are 2.68%, 0.17% and 0.9569, respectively.

针对大量工业数据，进行仿真计算，得到模型的最大相对误差、相对均方误差和跟踪性能指标分别为2.68%、0.17%和0.9569，说明该软测量模型具有良好的预测能力和跟踪性能。

The experimental results show that the proposed method can obtain good performance in terms of both objective evaluation criteria such as root-mean-square error,signal-to-noise ratio,mean error and visual subjective evaluation criteria.

实验结果表明，无论是依据均方根误差、信噪比、灰度平均误差等客观评价标准，还是视觉的主观评价，所提出的融合方法都能取得较好的性能。

Deducing error equation that used vector rotating and transfer of axes theory,Measuring out measurement parameter error on different orthogonality by testing optical-electrical device.

提出误差推导的一种新方法，利用向量旋转及坐标系变换理论推导出误差公式。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。