查询词典 error

Taking the design of plane mechanism as an example, the paper briefly explains how to apply the snap function of AutoCAD to graphology, analyzes the design error of graphic method,and discusses about the error control of the method.

以平面机构设计为例，简要说明如何将AutoCAD的各种捕捉功能用于图解法中，并对其设计误差进行了分析，对误差控制进行了探讨。

To generate digital elevation model for gross error check, to check out the corresponding gross error.

对生成的数字高程模型进行粗差检查，能够检查出相应粗差。

Some methods and strategies of gross error detection are introduced. An improved NT-MT method for gross error detection is proposed.

系统介绍了显著误差检测方法和多显著误差检测策略，提出了一种新的显著误差检测方法：改进的NT-MT方法。

There are two methods of detecting gross error, one is to include the grosserror in numerical model and the other is to include the gross error in stochastic model.

粗差检测方法有把粗差归入函数模型的检测方法，也有把粗差归入随机模型的检测方法。

We most often see the hard disk partition table error is the most serious errors will be different from the degree of error caused by different losses.

我们最常见到的分区表错误也是硬盘的最严重错误，不同错误的程度会造成不同的损失。

The revised Hargraves formula has the best result compared with Penman-Monteith formula, the average relative error is 6%, moreover, Hargaves method requiring the least data in calculating ETo, so this method has the high actual application value; The following are Radiation method and Blaney-Criddle method ; The worst is the Pan method, even after revised, the highest and average relative error is 36% and 10%, respectively. So, in this study, Penman-Monteith method, Radiation method, Blaney-Criddle method and Hargraves method are used except Pan method.

在这四种方法中，修正后的Hargraves方法与彭曼—蒙特斯方法的计算结果符合最好，其平均相对误差为6％，而Hargraves方法需要的气象数据只有计算时段的最高、最低温度，该方法具有较高的实际应用价值；辐射方法和布兰尼—克里德尔方法次之；蒸发皿方法最差，即使在修正后，E601型蒸发皿的最大误差也高达36％，平均为10％，所以在预报系统的研究设计中采用了除蒸发皿方法之外的四种方法。

Simulation results show that the proposed method comes to stabilization within 50 s and that its tracking initial error can be reduced to the hectometer level with the measurement precision of 20 ns. But the traditional method requires 250 s to go to stabilization and its tracking initial error is greater than the kilometer level.

仿真结果表明，在20 ns的测量精度条件下新方法在50 s内即可进入稳定跟踪状态，跟踪起始误差也减小至百米量级，而传统时差定位方法需要250 s才能进入稳定跟踪状态，跟踪起始误差则超过了千米量级。

"High memory Area. NET 3506: A system error has occurred. DOS error ."

英文意思：高内存区，网3506：发生一个系统错误，即DOS错误

First order coefficient of the phase error function can be estimated by sensor-based motion compensation. Second or higher order term of phase error function could be estimated and cancelled by autofocus technique.

传统由感测器执行之运动补偿功能只能测量到相位的一次项系数，如果加上自动聚焦法，则可以将二阶以上的误差项消除。

First of all, we introduce some interval methods and propose a new approach to find confidence interval for the slope in homoscedastic measurement error models. The performance of the interval estimation is compared in terms of both coverage probability and its diameter via simulation studies. Second, we suggest two approaches to estimate confidence intervals for the slope and joint confidence regions for both intercept and slope in heteroscedastic measurement error models. Application of these methods are illustrated with real data sets.

首先，当测量误差的变异是同质性时，我们对斜率项参数建构信赖区间，除了回顾已发表的方法外，也提出一个新的方法，建议的区间方法分别和已存在的方法做模拟比较，比较的标准建构在覆盖机率和平均长度上；另外，当测量误差的变异是异质性时，我们不仅对斜率项参数建构信赖区间提出新的方法，也对截距项参数和斜率项参数建构联合信赖区间。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。