查询词典 error of measurement

Cased hole formation resistivity logging calculates apparent formation resistivity by measuring slight potential difference on metal casing,its measurement error of the apparent formation resistivity is decided by the measurement error of the potential difference on the casing.

过套管电阻率测井通过测量金属套管上的微小电位差来计算地层视电阻率，套管上电位差的测量误差决定了地层视电阻率的测量误差。

At the same time, ambient temperature changes affect the acceleration of the method There is a certain measurement error, but the error of law stronger, from the basic structure, measuring principle, numerical and other aspects of the process of measuring the inclination and measurement system The structure of error correction for analysis.

同时，由于环境温度变化时对加速度计的影响，该方法存在一定的测量误差，但误差分布规律性较强，因此从基本结构、测量原理、数值计算等方面对倾斜度测量的过程和测量系统结构误差的校正进行分析。

Second, the data checking and correction process, to understand the various sources of measurement error, its three main areas: equipment error (determined by the instrument itself, is an objective source of error), observation error (due to the technical level personnel a result of belonging to a subjective source of error), external influence error (subject, such as temperature, atmospheric refraction effects of external factors such as these factors are also constantly changing and difficult to control, belonging to a variable source of error).

其次，在对数据的检查和矫正的过程中，明白了各种测量误差的来源，其主要有三个方面：仪器误差（仪器本身所决定，属客观误差来源）、观测误差（由于人员的技术水平而造成，属于主观误差来源）、外界影响误差（受到如温度、大气折射等外界因素的影响而这些因素又时时处于变动中而难以控制，属于可变动误差来源）。

Meanwhile , the measurement error of contact angles caused by the measurement error of droplet height , the bottom diameter of droplet and the turning error of protractor were discussed : Verification experiments were performed and the results obtained are coincident with the theory . Finally , hypsometry is proved to be more precise , faster and more convenient .

从理论上对这2种液滴角度测量法的测量原理和测量误差进行比较分析，分别讨论了液滴高度，底端直径的量取误差和量角器转动误差产生的接触角测量误差，并用实验进行验证，这些实验结论和理论相符，最后证实量高法更准确，快捷，方便。

By measuring missile movement inertia with torsion pendulum, the influences of periodic measurement error, systemic damp, period of swing object and corporative period of t he measured object and swinging object were analyzed. The relation among measurement error of movement inertia, measureme nt period, the period of swing object,corporaˉ tive period of tested object and swing object was proved. The maxi mal ratio between movement inertia for swinging obˉ ject and the measured object under conditions of different errors w as given under typical measurement precision.

通过扭摆测量导弹转动惯量的方法，分析了周期测量误差、系统阻尼、摆动体周期以及被测件和摆动体共摆周期对转动惯量测量精度的影响，得出转动惯量测量误差和周期测量误差、摆动体摆动周期、被测件和摆动体共摆周期之间的关系，给出了在典型的测量精度要求，不同的周期测量误差情况下，摆动体转动惯量和被测件转动惯量之间的最大比值。

It is pointed out that the error of indication E0 for the calibrated test length which are measured when the offset length between the ram axis and the stylus tip is zero shall neither exceed the maximum permissible error MPEE0 nor exceed 1/3 of the probe error,that the repeatability of E0 shall neither exceed the maximum permissible error MPE Rnor exceed the repeatability error of the probe,and that if the measuring data is rejected in acceptance and reverification,measurement must be carried at least 5 times at the same position for reducing the possibility of misjudgement.

提出探测轴探针针头零偏置长度的校准测试长度的示值误差E0应不超过最大允许校准测试长度的示值误差MPEE0，且不应超过测头误差的1/3；E0的重复性误差R不应超过最大允许重复性误差MPER，且不应超过测头的重复性误差。建议验收校准测量数据超差剔除后，必须在相应位置重复测量5次以上，以减小误判的可能性。

The error is mainly the system error of the experiment, and the velocity measurement error is the identification of the first arrival of the primary wave and the attenuation measurement is the coupling between the sample and transducer.

对误差分析表明，本文研究中的误差主要来自于实验系统误差，其中速度观测误差来自于对首波初至点的确定，声衰减观测的误差来源于探头与样品之间的耦合状况。

The measurement system error model analysis is introduced into power system real time network state analysis as an important part for the first time, which can improve on the state estimation quality and provide the capability to monitor the operation of the measurement system; 2. The theory and algorithm of the on-line estimation and update of measurement noise variance based on the relation between the residual variance and noise variance. The statistic properties of the sample variance are discussed and the relation between the estimation precision and sample size under given confidence level is derived; 3. The theory and algorithm of detection and identification of measurement bias are presented, which is based on the relation between residual mean and noise mean. The statistic properties of sample mean are discussed and the relation between estimation precision and sample size is derived; 4. The Givens orthogonal transformation algorithm is selected to be the essential algorithm of state estimation, the fast orthogonal transformation algorithm with damp factor and the algorithm which can handle the zero injection measurements efficiently are presented; 5. The quantity analysis theory of bad data detectivity and identifibility are presented, which describes the relation between the elements in matrix W〓 and bad data amplitude and can provide the theory base for measurement system design and valuation.

一、首次将量测系统误差模型分析做为一个环节引入电力系统实时网络状态分析中，为EMS系统增加了实时监视系统运行、修正量测系统误差模型的新功能，进一步发挥了实时网络状态分析应用软件的潜力；二、首次提出了应用样本方差在线估计与修正量测系统误差方差的基本理论，讨论了样本方差的统计性质和概率分布，推导出了样本容量、估计精度和置信度之间的关系，给出了在线估计与修正量测系统误差方差的算法；三、首次提出了应用样本均值在线检测与辨识量测偏差的基本理论，讨论了样本均值的统计性质，推导了样本容量、估计精度和置信度之间的基本关系，给出了在线检测与辨识量测偏差的算法；四、在状态估计算法设计中，以Givens变换算法做为基本算法，提出了快速正交变换阻尼因子法和可以有效地处理零注入量测的混合法，并对实时应用中的一些问题进行了讨论；五、提出了不良数据可检测性与可辨识性的定量分析理论，揭示了描述量测系统配置、网络结构与参数的残差灵敏度矩阵中的元素与不良数据的幅值在可检测、可辨识能力上的定量关系，为量测系统配置设计与评价提供了理论基础；六、综合国内外最新研究成果，采用自适应自回归预测技术和稀疏矢量技术，构造了较完善的不良数据检测与辨识算法。

But sometimes we find the data that is combined by true explained variable and measurement error when we constructed back to regression analysis. We call this kind of regression model as measurement error model.

但是在建构回归分析时，有时会发现所得到的资料是由真实解释变数和测量误差所结合而成的观测值，像这种具测量误差的回归模式，我们称为测量误差模式〈measurement error model〉。

In order to evaluate aiming error of missile on the warship or on the submarine, including the error of warship position, the error of reference azimuth and the error of transfer measurement given by the navigation system, and try to divided them from the general error, it is highly important that we estimate and evaluate missile system of mobile bedding launching.

为了评估从舰船／潜艇上发射导弹的瞄准误差，包括舰船导航系统给定的船位误差、基准方位误差及其传递测量误差，并试图把它们从总的瞄准误差中分离出来，这对于动基座发射导弹武器的瞄准精度的评价极为重要。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。