查询词典 error analysis

In this paper, provide a detailed analysis the error susceptibility for an AMBA bus based systems.

提出了详细的分析基于AMBA总线的系统的事务级的错误敏感性模型和系统级敏感性预测方法。

The analysis of dynamic performance of the overall system is performed by using Lyapunov method, which proved that by using the proposed method uniform ultimate boundness of close-loop error is guaranteed under certain conditions.

使用Lyapunov方法对整个系统的动态性能进行分析，证明了在一定条件下此方法能保证闭环误差及网络权值一致最终有界。

ABSTRACT:The present paper is mainly introduced GPS the basic principle, the system composition, the technical characteristic, the error source and the application method and the sequence of operation, and carry on a lofting, the curve lofting as well as using GPS in the project survey carry on the boundary point survey in the cadastration, carries on the precision analysis to the measurement result.

论文摘要：本论文主要介绍GPS的基本原理、系统组成、技术特点、误差来源和使用方法及操作步骤，并利用GPS在工程测量中进行点放样、曲线放样以及在地籍测量中进行界址点测量，对测量结果进行精度分析。

ABSTRACT摘要: The present paper is mainly introduced GPS the basic principle, the system composition, the technical characteristic, the error source and the application method and the sequence of operation, and carry on a lofting, the curve lofting as well as using GPS in the project survey carry on the boundary point survey in the cadastration, carries on the precision analysis to the measurement result.

论文摘要摘要：本论文主要介绍GPS的基本原理、系统组成、技术特征、误差来源和使用方法及操作步骤，并利用GPS在工程测量中进行点放样、曲线放样以及在地籍测量中进行界址点测量，对测量结果进行精度分析。

ABSTRACT: The present paper is mainly introduced GPS the basic principle, the system composition, the technical characteristic, the error source and the application method and the sequence of operation, and carry on a lofting, the curve lofting as well as using GPS in the project survey carry on the boundary point survey in the cadastration, carries on the precision analysis to the measurement result.

本论文主要介绍GPS的基本原理、系统组成、技术特点、误差来源和使用方法及操作步骤，并利用GPS在工程测量中进行点放样、曲线放样以及在地籍测量中进行界址点测量，对测量结果进行精度分析。

ZqD;Z.BUB0 abstract:the present paper is mainly introduced gps the basic principle, the system composition, the technical characteristic, the error source and the application method and the sequence of operation, and carry on a lofting, the curve lofting as well as using gps in the project survey carry on the boundary point survey in the cadastration, carries on the precision analysis to the measurement result.

论文摘要：本论文主要介绍gps的基本原理、系统组成、技术特点、误差来源和使用方法及操作步骤，并利用gps在工程测量中进行点放样、曲线放样以及在地籍测量中进行界址点测量，对测量结果进行精度分析。

Using numerical analysis method and GLSFA the paper researches into the plane, conicoid and three cubed anti error fitting model.

利用数值分析方法和GPS水准拟合过程分析软件对相关平面、二次曲面和三次曲面抗差推估数学模型进行对比分析研究。

Analysis of several cylindricity measurement models based on error separation technique.

基于误差分离技术的几种圆柱度测量模型分析。

The invention selects hypo- sensitive absorbing line of metal to be measured to analyze by the atom absorbing spectrometer, so alloy sample metal salt solution is diluted for direct analysis, so error induced by dilutedness can be decreased greatly, operation is easy, fast and accuracy is high.

本发明选择待测金属元素的次灵敏吸收线进行原子吸收光谱仪分析，因此无需对合金样品金属盐溶液进行高倍稀释，就能直接分析，因而可以大大减小由稀释放大的误差，操作简便、快速，准确性高。

A modified analysis method based on the determination of ozone—indigo disulphonate spectrophotometer(GB/T 15437-1995) in gas phase has been developed to detect the concentration of ozone in liquid phase. An analytical condition of λmax=612～615 nm,ε=20 000 L/, pH 2 is obtained by the titration of indigo disulphonate. Compared with potassium iodide method,it shows a higher precision and accuracy,CV＜3.0%. The results also prove that blank experiment will bring about 5.0%systematic error.

在气相臭氧浓度的靛蓝二磺酸钠分光光度法(GB/T15437-1995)基础上提出了液相臭氧浓度的测定方法，采用靛蓝二磺酸钠标准曲线法代替采用易分解的臭氧标准曲线法，得出测定条件λmax=612～615 nm、ε=20 000 L/、pH为2，通过碘量法比较实验，说明新的测定方法具有较高的精度和准确度，相对标准偏差小于3.0%；比较结果表明忽略空白实验将引入5.0%的系统误差。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。