查询词典 erodent

The results are listed as following :㏕he best anti-erosion proportion of resin present is 25wt% in the condition of silicon carbide reinforced SMCC, while the alumina reinforced SMCC is 40wt%.(2) The better anti-erosion results was achieved with the ratio of silicone resin to acrylic resin containing hydroxy being 3: 1.㏕he composites coating tends to be more brittle when added in alundum particles. It also means that the maximum erosion peak of alundum reinforced SMCC tends to normal angle.甌he change of erosion rate of SMCC can be divided into two stages with the increment erodent velocity: the slow erosion stage of the beginning and the stable erosion stage.

首次发现：①SiC增强的复合涂料涂层，树脂含量为25wt％时，具有最佳耐冲蚀性能：Al_2O_3增强的复合涂料涂层，树脂含量为40wt％时，具有最佳耐冲蚀性能；②SiC增强的涂料，有机硅树脂与丙烯酸树脂的比例为3：1时的耐冲蚀性能好于1：1的复合涂料涂层；③Al_2O_3增强体使涂层变脆的倾向大于以SiC为增强体的涂层，即SiC增强的复合涂料涂层的最大冲蚀率出现在30°，Al_2O_3增强的复合涂料涂层的最大冲蚀率出现在75°～90°之间；④低速冲蚀磨损机理主要是弹性变形与疲劳；高速冲蚀磨损机理主要是显微切削和显微犁耕。

Generate electricity in recent years bring the water with chute many upper reaches, already bring down erodent speed.

近年来发电引走瀑布上游大量的水，已减低了侵蚀的速度。

At the same time the corresponding measures to dissolution of gypsum and erodent character to the concrete in the hydro-engineering are put forward.

同时针对水利工程中石膏溶蚀以及对砼的腐蚀性提出了相应的防治措施。

Established corresponding measure to dissolution of gypsum and erodent character to the concrete in the hydro engineering.

据此针对水利工程中石膏溶蚀以及对砼的腐蚀性提出了相应的防治措施。

The interaction between multiphase liquid in boundary layer within pipe wall and the damage of protective erodent products film is analyzed.

针对异径管的冲蚀失效问题，以管壁腐蚀产物保护膜为研究对象，主要研究流固耦合对管道冲蚀破坏的作用机理。

Special temperature sensors must be developed in order to meet the need of specific environments including highly erodent and heat medium, vacuum and radiation of nucleus, etc.

对于测量条件恶劣，不能用常规传感器实现的特殊场合，如高温强腐蚀性介质、真空、高温熔体及核辐射条件下的温度测量，必须开发特种专用传感器。

The effects of resins ratio, proportion of resin presents, different kinds of ceramic particles, impact angle, velocity of the erodent (alumina, silicon dioxide and calcite) and impact time (expressed by the weight of being used erodent) were demonstrated.

研究了树脂的配比、涂层中树脂的含量、增强体的种类、冲蚀粒子(刚玉、二氧化硅和方解石粉)的速度、冲蚀角度和冲蚀时间(用冲蚀粒子的用量来表示)等因素对涂层的冲蚀率的影响。

It was also found that the protecting effect of erodents on the coating surface does exist. The protecting effect will be more evident if using erosion efficiency of unit mass erodent of sand in the slurry to describe the erosivity of erodent. Besides a model is proposed to explain the protection process. The wear mechanism of the coating is the co-operation of ploughing, cracking and ablation.

对涂层的SEM分析可知，除冲蚀粒子在涂层表面的犁沟作用，冲蚀磨损的结果造成涂层的表面生成了系列针孔，其中的一部分为溶剂挥发所至，另外还存在由增强颗粒的剥落和裂纹的扩展造成的涂层剥落产生的孔洞，这将可能为水的吸收和扩散造成有利条件，使复合涂层亚表层产生内应力。

The results of the investigation showed that the best entrance angle of B〓C, B〓C/ C and Al〓O〓/ C ceramic nozzles is 11°, 14°and 16°respectively. Erosion wear model has been put forward. The B〓C and B〓C/ C nozzles exhibited a stress fatigue induced removal process under the condition of umber emery erodent impacting, and a brittle fracture induced removal process under the condition of white emery and SiC erodent impacting.

建立了不同磨损机理下的冲蚀磨损模型，提出了喷砂嘴的磨损属于多冲蚀机理并存的复合冲蚀机制。B〓C和B〓C/C陶瓷喷砂嘴在棕刚玉磨料的冲蚀下，主要表现为应力疲劳断裂冲蚀，在白刚玉和SiC磨料的冲蚀下，主要表现为脆性断裂冲蚀。

EM analysis the worn surface morphology shows the following results: elastic deformation and fatigue are the main wear mechanisms of SMCC when impacted with lower erodent velocity, while the dominant mechanisms change into microcutting and microploughing with the increment erodent velocity.The slurry erosion behaviors of ceramic particles reinforced epoxy matrix composite coating were explored using a self-designed slurry pot tester.

首次采用自制的模拟罐式泥浆冲蚀试验机对环氧基复合涂料的泥浆冲蚀磨损性能进行了研究，通过调整固化剂聚酰胺与环氧的质量比，设计出最佳的基体组成；尽管涂层的铅笔硬度对其抗冲蚀性能有一定的影响，但起决定性作用的因素是涂层的韧性和硬度有机结合。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。