查询词典 emulsion

The Syntheses of a High Temperature Gellant in Acid Stimulation Using Invert Emulsion Polymerization;2. Aiming at the special oxidizability of NTO,three different gellant s were chosen which could form gel with NTO,and their rheologic properties were studied.

针对四氧化二氮的特殊氧化性，筛选了三种不同胶凝剂与NTO形成凝胶，对其流变性能进行研究，并结合发动机试验、限流圈试验、发动机头部液流试验，验证了其与偏二甲肼凝胶组成的双组元推进剂用于凝胶发动机试验的可行性。

In this paper , a new acrylates emulsion with hard core of Pand soft shell of P structure was prepared by the idea of designing partical structure.

本论文从粒子设计的思路入手，采用种子半连续法合成了一种具有明显的硬核P和软壳P结构的丙烯酸酯乳液。

Gelatin submicron particles were prepared by emulsion chemical cross-linking method using gelatin as core material and paraffine as oil phase.

以A型明胶为原料，石蜡油为油相，采用乳化化学交联方法制备了明胶亚微米粒子。

By 16S rRNA. When it was cultured in MMSW substrate, adding MWFO and SWFO as the carbon source, it could produce crude biodemulsifier of 4 g/L and 3.5 g/L respectively. Compared with biodemulsifier produced by paraffine as the carbon source, both of them could achieve higher demulsification ratio in breaking W/O and O/W model emulsion.

的一株破乳剂产生菌，在以废弃油脂MWFO、SWFO为碳源培养下，得到的生物破乳剂的粗重为4 g/L、3.5 g/L；对于W/O、O/W模型乳状液的破乳效果均可超过以液体石蜡产生的破乳剂，且以SWFO废弃油脂培养得到的生物破乳剂可以同时应用于两种模型乳状液的使用。

The influence of NaOH on the stability of paraffinic crude oil emulsion.

Zeta电位和界面膜强度对水包油乳状液稳定性影响。

For VC suspended emulsion polymerization initiated by potassium persulphate, the initial polymerization rate is proportional to 133 and proportional to RpJ0 72, where

以 KPS为引发剂进行的 VC悬浮态乳液聚合，基本上是在隔离的小水滴内进行的，类似于乳液聚合机理，但齐聚物自由基的相转移可以引发少量的单体相聚人采用优化的聚合工艺条件，得到转化率大于70％、颗粒仍由基本不熔结的初级粒子组成、吸油率为 19。

The basic nature, emulsion making and coating technology, photoetch experiment etc.

对超微粒乳胶的基本性质、涂布工艺、光刻实验等进行了讨论。

Polysilicate aluminum chloride flocculants of various molar ratio of Al to Si are prepared. The influence of ingredient molar ratio, pH value of waste water and the adding amount of flocculant is investigated in treating simulant rolling emulsion.

制备了不同Al/Si摩尔比的聚硅氯化铝，实验考察了成分摩尔比、废水pH值、药剂投加量对除油效果的影响。

The organic montmorillonite VC18-MMT was prepared by the exchanging inorganic cations with vinylbenzyldimethyloctadecylammionun chloride which could be co-polymerized with styrene.The predispersion of VC18-MMT was realized via sonicating the suspension of the montmorillonite particles in emulsifier solution,and then the styrene was added into the system and the in situ emulsion polymerization was carried out to prepare PS/VC18-MMT nanocomposites.

以可与苯乙烯发生共聚的阳离子表面活性剂乙烯苄基二甲基十八烷基氯化铵为插层处理剂改性蒙脱土（VC18-MMT），有机蒙脱土在超声波强剪切作用以及乳化剂作用下预分散在乳化剂溶液中，然后引入苯乙烯单体进行原位乳液聚合制备聚苯乙烯/蒙脱土纳米复合材料。

The research of polymer/layered silicate nanocomposite was introduced detailedly, including the classify, property and the latest research advance. On the basis of consulting the document and the exploratory experiment, the experimental method which first creative preparing poly (acrylonitrile-vinyl acetate)/raontmorillonite nanocomposite by emulsion intercalation copolymerization was established; the structure and property of polyacrylonitrle different molecule weight with inorganic mineral super fine nanocomposite was reseached. The reaction principle of PMMA by photo-initution was explored. The mixture principle with productor condition, property of PE/Clay nanocomposite milt insert was seal prived. By PS/Clay nanocomposite munufacture, the monomer ins-polymerization and polymerial solution was proved.

在查阅文献和探索性实验的基础上，确定采用乳液原位插层聚合方法首先创制了聚/蒙脱土纳米复合材料，利用正交实验得出了最佳实验条件，通过X射线衍射和红外光谱对纳米复合材料的结构进行表征，研究了复合材料的溶解性能，并测定了其溶液的绝对粘度；研究了不同相对分子质量的聚丙烯腈与不同的无机矿物超细粉复合材料的结构与性能；探讨了在蒙脱土中光引发聚甲基丙烯酸甲酯的反应机理；通过聚乙烯与粘土的纳米复合材料制备，探讨了热塑性树脂熔融插层复合机理与最佳工艺条件和复合材料性能关系；通过聚苯乙烯与蒙脱土纳米复合材料制备，验证了单体原位聚合插层和聚合物溶液插层机理。

In the negative and interrogative forms, of course, this is identical to the non-emphatic forms.

。但是，在否定句或疑问句里，这种带有"do"的方法表达的效果却没有什么强调的意思。

Go down on one's knees;kneel down

屈膝跪下。。。下跪祈祷