查询词典 element of area

The discrete element method and the finite element method have their own advantages and weaknesses. Basically, the DEM was developed for predicting the failure problems accompanying with the transition from continuum to non-continuum media. However, it is not accurate to calculate the problem of continuum media. The FEM may forecast the failure area of the material reasonably, while it is hard to calculate the failure process in brittle media. Therefore it becomes a good choice to combine the two methods to construct a hybrid model.

离散元法和有限元法等数值计算方法各有其优势，同时也都存在不足之处：离散元法适于处理由连续介质向非连续介质转化的破坏问题，但对于连续体计算结果精度不高；有限元法适于预测材料破坏的区域，但难以直接用于计算脆性材料破坏过程，因此将两种方法结合可以形成一种较好的混合模型。

By means of field test for the pile of 15 meters length and MARC finite element analysis, this paper studies the bearing mechanism of the reinforced mixing pile, analyzes the law of load transfer and the percentage about cement-soil ring and reinforced concrete core under vertical load, analyzes the change law and interactive behavior about the pile's surface bearing and end bearing. In the end an experiential equation that can be used in Tianjin area to estimate the bearing capacity of single pile is proposed on the basis of test researches and finite element analysis.

分析了劲性搅拌桩在竖向荷载作用下的荷载传递规律及芯桩与水泥土的荷载分担比；分析了劲性搅拌桩在竖向荷载作用下桩侧摩阻力和桩端阻力随桩顶荷载的变化规律；分析了劲性搅拌桩在竖向荷载作用下桩端阻力及桩侧阻力的发挥性状与桩土位移间的关系及端阻力与侧阻力的荷载分担比。

Is welcomed buying the house , the first key elements is section of an area , second key elements are section of an area , third key element are still section of an area.

值得注意的是，表2和表3中职业所处的位置是动态而非静态的。如煤炭业，今年的表现就不俗，各项指标上涨幅度喜人。

A circulation channel adjacent to the element causes the internal coolant to transfer the heat from the element to the working area of the mold.

流通渠道，毗邻该元素的原因内部冷却转移热从元素工作领域的具。

Its benefit is that different structural sizes can be controlled by single design variable, such as the thickness of plate element and the area of bar element can be controlled by single dimensionless design variable.

采用无量纲设计变量为了适合工程实际的设计变量连接，利用无量纲设计变量，其好处是可以跨单元、跨截面的用同一个设计变量控制不同类型的结构尺寸(如板单元的厚度、杆单元的截面面积等)。

This paper also shows the distribution of the fluorine in sediments of the area is mainly controlled by the chemical composition of the material from the surrounding islands, and the element seems to be incorporated by the hornblende at the most extent, thus the correlation between the element and the hornblende amount in the sediments can be expressed statistically as following: F=217+lnVh.

研究结果表明，测区沉积物中氟含量分布主要受周围岛屿风化基岩的化学成分制约；沉积物中主要含氟矿物：萤石/磷灰石、黄玉、黑云母等含量极低，氟在沉积物中赋存的矿物相主要与角闪石[AX_2Y_5Z_8O_(22)_2]有关。氟含量与碎屑矿物中角闪石的体积比间的关系式可大致表示为：氟含量=217+361nV_H；间隙水中的低氟主要由测区化学风化不发育及氟的钙盐沉积所致。

The kernel point of the mountainous area high dip angle strata 3D seismic data processing is how to solve 3D reflection surface element divergence ,to increase reflection surface element trace gather inphase stack .

山地大倾角地层的三维地震资料处理的核心问题是如何解决3D反射面元发散，增加反射面元内道集同相叠加，而静校正技术和偏移成像技术正是解决这一问题的关键技术。

In this paper, the stress and strain fields of lithosphere in Himalayan Western Syntaxis orogenic belt and its adjacent areas since 10Ma are investigated through using the 3-D finite-element simulation, and deformation and evolution process in former 2Ma are simulated with different rheological parameters and rheological structure. Studies on functions in simulation process of different viscosity parameters, constitutive relation and changes of initial curst thickness show below results:(1) When various viscoelastic models are adopted, the selection of the coefficient of viscosity in the Western Syntaxis area has important influence on the its uplifts and evolutions. The computational results show that the viscosity in the Western Syntaxis area should be smaller than 1023Pa·s;(2) When the elastic model is adopted in relatively rigid Tarim basin, obvious changes are induced to the stress and strain fields of the whole Western Syntaxis area;(3) The existence of mechanical property stable block doesn′t make the propagation of the stress field show obvious decoupling phenomenon.

用数值模拟的方法探讨了自10 Ma以来喜马拉雅弧形造山带的西构造结及邻区岩石圈的形变和位移变化特征，并采用不同的流变参数和流变结构模拟了前2 Ma内的形变和应力场的演化过程，通过对不同黏性系数、本构关系和初始地壳厚度的改变在演化过程中所起的作用研究表明：（1）采用黏弹性模型时，西构造结区黏性参数的选取对西构造结及邻区隆升高度和隆升范围有重要影响，计算结果给出西构造结区地壳黏性系数应小于1023Pa·s；（2）相对刚性的塔里木盆地采用弹性结构时，对整个西构造结区域的应力和应变场均能引致明显变化；（3）力学性质稳定块体的存在并没有使应力场的传播出现明显的解耦现象。

The electric-field and potential distribution along a post insulator under dry and clean conditions are calculated through the Finite Element Method.and three principles about model building are presented.In theprocess of solid modeling.the post insulator is simplified to a 1/2 area model because of its axial symmetryt and anannular area is innovatively presented to represent the field at infinity.W hen area meshing.the metallic fittings ofthe insulator are omitted.

为解变电站支柱绝缘子表面电场分布及RTV涂料、增爬裙的影响，用有限元法计算了洁净条件下支柱绝缘子的电场和电势分布规律，提出了模型建立的三原则--根据轴对称性简化模型；采用环形区域作为无限远求解区域；不剖分绝缘子的金属附件。

This paper presents conductive polymer molecular materials with insulating powder, mixed into the deployment of surge suppressors for low capacitance of paste, while the component design concept is based on the field of passive components, manufacturing process to make the basic theory to design the protective components, the main use of the existing ceramic substrate for the component body structure design, screen design in the body through the structure of the gap at the top of the printing layer of a different conductors, and then to learning to know the printing process technologies approach the low capacitance of the surge suppressor paste cover the gap in the two conductors, and by the resistance of plastic burning process technology, the temperature of sintering parts made of electrostatic protection element, and this protection through the external ESD components in bombardment tests, measurement of capacitance electrostatic discharge after bombardment, Trigger voltage and leakage current data, and the volume measured by the results of future discussion of the layout of this different style of work in the same area, different clearance, solid content and temperature than the next, for the attainment of performance components, a low capacitance ESD protection devices with low breakdown voltage requirements and to chip-based protection devices can be designed to integrate with the advanced Integrated Circuits or used independent of the electrostatic protection element in the system.

本文提出高分子导电分子材料搭配绝缘粉末，调配混合成适用於低电容突波抑制器之PASTE，而元件设计概念是以被动元件制程领域作基础理论去设计此防护元件，主体利用现有陶瓷基板为元件本体结构设计，在经由网版设计在本体结构上方印刷一层不同的间隙导体，再以习知印刷制程技术方式，将低电容突波抑制器之PASTE覆盖在两导体的间隙内，并经由电阻制程习知塑烧技术，将元件烧结适当温度制成静电防护元件；而此防护元件在经外加静电放电轰击测试后，量测静电放电轰击后的电容、Trigger voltage及漏电流相关数据，并藉由测结果讨此同的布局样式，在相同工作区面积、不同间隙、固含量与温度比下，对於元件效能是否达到静电防护元件低电容与低崩溃电压的需求，并藉此晶片型防护元件可设计整合於先进积体电或应用於独系统的静电防护元件中。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。