查询词典 electromagnetic contact

Through field measurement for the contact pressure of box foundation with Ⅰ shaped plane of a high rise building on cobble subsoil, the distribution law of the contact pressure has been diagrammed. At the same time, the contact pressure has been calculated with finite compression layer model, which is well accordant with the measured result. The relative error of average value for the measured to the calculated contact pressure is 6.9%. This shows that the numerical calculation is right.

通过对西南交通大学某教学楼箱形基础基底反力的实测结果，得出了&Ⅰ&形平面箱基置于密实卵石层上的基底反力分布规律，又用有限压缩层地基模型对该箱基反力进行了计算，结果表明：实测反力与计算反力分布规律一致，实测反力平均值与计算反力平均值相对误差为6.9％，也说明此法计算箱基反力是可行的。

The contact fatigue strength was measured after the 20CrNi2Mo and 15CrNi6 steel used asdragging gear on quasi high speed locomotive was carburized and quenched as well as peened,com-pared with that of 20CrMnMo steel.The results shown that the contact fatigue strength limits of thesethree types of steel carburized and quenched essentially same,and the contact fatigue strength Iimit hasbeen increased by 5 porcent after peening,and that the failure appoarances of all contact fatiguespecimen were delamination ...

对20CRrNi2Mo、15CrNi6及20CrMnMo渗碳淬火齿轮及15CrNi6渗碳淬火＋喷丸处理齿轮进行了弯曲疲劳试验，介绍了齿轮试件的设计与加工、试验装置与夹具、试验方法及试验数据的统计处理，试验结果表明，20CrNi2Mo和15CrNi6渗碳淬火齿轮在R＝0.99时的σFlim分别为530MPa和375MPa，与20CrMnMo渗碳淬火齿轮相比，弯曲疲劳强度分别提高80％和27％。15CrNi6经渗碳淬火＋喷丸处理齿轮在R＝0.99时的σFlim为490MPa，比未喷丸处理者提高30％。

The computation model of two-point contact (for cone-tread) and conformal contact (for worn-tread) resulting from wheel flange close to rail is firstly established in this paper. A detailed analysis is made of the wheel/rail contact force, contact status and wheel/rail stress distribution on the different action of tractive forces and transverse forces. We draw some important conclusions, one of which is that the locomotive adhesion performance will decrease with the increase of transverse forces between wheel and rail.

本文建立了车轮轮缘贴靠钢轨形成的轮轨两点接触和共形接触的计算模型，对不同的牵引力矩、不同的横向力作用下的轮轨接触力、接触状态和轮轨应力分布进行了详细的分析，得出了轮轨间横向力增大会降低机车粘着性能等一系列重要结论。

Initially, assuming that the contact between cam and tappet is"dry contart", a dynamics model of Hertzin contact stiffness and impact damping is established. Next, with dynamic load on cam—tappet pair from the model, an analysis is made both to unsteady EHD oil film in cam—tappet pair under condition of full and partial lubrtication and to wear characteristics of cam profile. then, according to the fact that the lubrication in cam—tappet contact surface is EHD lubrication, taking the interaction between stiffness and damping of unsteady EHD oil film and rigidity of solid object contact into account, a dynamics equation of valve train relating to the dynamic effect of EHD oil film is built up and solved. Consequently, a further study is made on the dynamic characteristics of valve train under interaction of EHD oil film dynamic behavior and the problem of EHD lubrication in cam—tappet pair. Finally, the dynamic effect of full and partial EHD oil film is studied accordingly.

首先，通过对凸轮—挺杆接触为&干接触&的假设，建立了考虑赫兹&接触刚度&和冲击&阻尼&的配气机构动力学模型，用由此求得的凸轮—挺杆表面动载荷对凸轮—挺杆进行了全膜状态和部分膜状态非稳态弹流润滑分析，并研究了凸轮轮廓的磨损规律；然后，是在凸轮挺杆表面存在弹流动压油膜这一事实的基础上，相当于在动力学方程中考虑非稳态弹流油膜的&刚度&、&阻尼&和固体接触&刚度&的耦合作用，建立并求解了考虑弹流润滑行为动力学效应的配气机构的动力学方程，从而深入地研究了弹流润滑行为与动力学行为耦合作用下的配气机构动力学特征以及凸轮挺杆弹流润滑问题；作为前面工作的对应部分，考虑弹流油膜动力学效应的研究工作也同样分为全膜状态和部分膜状态进行。

In order to distinguish these two types of transitions, a state recognition method is introduced. We firstly propose a variable contact set in which the contact points on the robot body are defined to represent the alternation of the contact states logically. Then, by predefining thresholds for the contact forces, the state transition can be well recognized.3 As another research topic, the local tracking control according to the pre-acquired state transition trajectories plays an important role in realizing the non-regular motion for the humanoid robot.

在状态转换识别方法上，本文提出了接触点集合的概念，对接触状态的变化进行逻辑上的表达；再结合接触点集合的变化情况，通过设定接触力阀值来实现对状态转换的识别。3根据给定的状态转换轨迹进行局部的跟踪控制，是本文实现类人机器人非规则运动的另一个重要研究内容。

The contactless inductive coupled power transfer system is one of the newest power transfer technology, which transmit energy to load by electromagnetic coupling and without electrical connection or physical contact, whats more, it comb-out contact existence of electric spark completely, reduce mechanical wear, and have the characteristics that safeguard operating non-maintaining or low.

非接触式感应耦合电能传输系统是一种新型的电能传输技术，它摆脱了传统供电方式通过导体直接接触供电的方式，通过感应电磁耦合关系向负载提供电能，彻底消除了接触电火花的存在，减小了机构磨损，具有免维护或低维护运行的特点。

Electromagnetic brake cooling fan, contactor coil connected KMb has two slip, one is always intrude KMa KMa contact and, in parallel with the power all the way between intrude feadwater safety switches that normally closed contact.

增热电扇，电磁刹车的隔绝器KMb线圈的连开有两条岔路，一是串出KMa常开触不面与KMa并联，另一路是与电源之间串出盘车不乱残开关的常不开触不面。

The full space calculation model, which suits for the asymmetric structure sometimes even including air below the surface of medium, can enable simulative result to approach real one. The FDTD algorithm based on the mixed ABCs is proper to calculate the transmission line where the electromagnetic wave is transmitted in order to send electromagnetic energy along central conductor. The calculation efficiency will be raised if the PML absorbing boundary condition is set on both planes of transmitting direction and so is the MUR two-order absorbing boundary condition in the other planes.

全空间计算模型是适合所有的不对称结构的待研究体的，而且包括了介质下面的空气部分，使仿真更加的接近实验真实情况；基于MUR-PML混合吸收边界条件的时域有限差分法非常适合计算传输线这种结构，因为传输线是传送电磁波的，电磁能量主要是沿着中心导带行进，因此在两个传输端面上设置PML完全匹配层吸收边界条件，在其他面上设置MUR二阶吸收边界条件，会大大提高计算效率，而且计算结果与XFDTD仿真软件计算结果相比较，基本趋于一致。

The effects of magnitude and distribution of the electromagnetic force on the flow around the aerofoil were investigated. The results show that the electromagnetic force with large magnitude and concentrated distribution on the surface of aerofoil is advantageous to eliminate vortex structures and boundary separation, and therefore to increase the lift-drag ratio.

同时对不同电磁力大小和分布影响翼型表面边界层流动的规律进行了探讨，其结果表明，较大的电磁力和更加集中于翼型表面的电磁力分布可以很好地消除涡结构，抑制边界层分离进而达到提高升阻比的效果。

General Atomics Electromagnetic Systems division has successfully fired multiple rounds for the first time in a prototype of its new Blitzer electromagnetic railgun air defense prototype system.

通用原子电磁系统部的成功发射了在其新布利策电磁轨道炮防空系统的原型样机首次多轮。

A carrier gas such as nitrogen is directed through line 20 and valve 22 to connect with line 26 and mix with the gas sample.

如氮气之类的载体通过管线20和阀22引入，与管线26相通，与气体样品混合。

But for the most part, knaves and parasites had the command of his fortune

然而支配他的家产的大多是恶棍和寄生虫。