查询词典 electrochemical

Electrochemical investigation at the interface between two immiscible electrolyte solutions has received intensive study in the last decades.

这种非互溶界面在过去的几十年中得到了许多人广泛而深入的关注。

Studies are encouraged to find new imprinting matrices and methods to satisfy the requirements of electrochemical sensing elements.

因此，寻找新的印迹基质和印迹方法以满足电化学传感器对敏感元件的要求具有重要的研究意义。

Wear and corrosion involve mechanical and electrochemical mechanisms, and the combined action of these mechanisms often result in significant mutual reinforcement. To measure the effect on wear-corrosion resistance of the chemical and abrasion wear separately at the same time, wear-corrosion synergism rate is selected to indicate the nature and degree of the chemical and abrasion wear.

腐蚀磨损是同时涉及力学因素和电化学因素的复杂的材料的流失过程，通常条件下，腐蚀磨损不是纯磨损和纯腐蚀的简单叠加，还有两者间的协同作用，为定量描述腐蚀与磨损的促进程度、进一步完善腐蚀磨损机理，本文利用腐蚀磨损协同作用率值的大小来分析腐蚀和磨损的交互作用程度，结果表明：本文制备的镀层，在5％H_2SO_4溶液中腐蚀磨损时，机械磨损是造成镀层表面材料流失的主要原因，腐蚀和磨损的协同作用为次要因素。

In the end, they were used as the anode materials of thelithium-ion battery, and their electrochemical performance were studied indetail.

最终将其以锂为对电极应用于锂离子电池作为电极材料，研究了它们的电化学性能特点。

The Electrochemical measurement system used to perform DPSV measurement is constructed with two parts, a low-current measurement system consists of low input bias current operational amplifier and a high resolution SAR ADC and a potentialstat consists of high resolution DAC and high current buffer amplifier.

对于差分脉冲伏安溶出测量，我们使用高精度连续逼近寄存器型ADC和低偏置电流运放构成微电流采样系统；使用高精度DAC和高速大电流缓冲放大器构成了恒电位计，在微控制器的控制下组成电化学测量系统。

The intercalation of P also has a pronounced effect on the electrochemical properties of the GO.

同时发现，增加P的含量，不仅提高了GO的电化学活性，也改善了GO的锂离子嵌入/脱嵌的循环稳定性。

The effects of lightly cation doping and electrochemical oxygen intercalation were investigated in La2CuO4+δ system.

研究了低浓度掺杂和电化学插氧对La2CuO4+δ系统的磁行为和相分离的影响。

The relation between interelectrode gap and flow rate in pulse electrochemical finishing was analyzed in theory,and the rules of effect of both on surface quality were highlighted and analyzed based on the experiments.

通过理论分析脉冲电化学光整加工中的间隙与电解液流速之间的关系，并通过系统地实验研究，探讨了加工间隙和流速对表面质量的影响规律。

The rules of effect of the experimental parameters of the pulse electrochemical finishing, such as the flow field, the electrolyte flow rate and the interelectrode gap on surface quality are highlighted and analyzed based on the experiments in this paper.

目前 ，脉冲电化学加工主要集中在脉冲电解成形加工方面，加工精度是其重点研究对象[1～ 7] 。日本学者用成对电极的方法对线切割加工后的表面进行光整加工[8] ，取得了较好的表面质量，但这种方法也采用成形加工，通用性较差。

pulse electrochemical finishing ; flow field ; interelectrode gap

基本原理是以周期性间歇脉冲电流代替直流，使工件阳极在加工

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新