查询词典 electro-discharge

In this paper, the author has analyzed some problems in the Experimental Education of the Electro circuit, putting forward reformative action about them in the new centuries.

本文从发展的角度，分析了电路实验教学过程中存在的一些问题，并针对这些问题提出了改革措施。

Under the action of DC electric field,by using water as regenerant,it substitutes the acid and the alkali to regenerate,the electro-regeneration technology for ion exchange resin in outer body of the exhausted ion exchange resin.

在直流电场作用下，利用水代替酸碱作为再生剂再生失效离子交换树脂的体外电再生工艺，使离子交换水处理变为一种绿色环保水处理技术。

The effect of remanet polarization on electro-mechanical fields in ferroelectric ceramics with a flaw has been investigated.

因此揭示铁电晶体在力电载荷作用下的断裂和疲劳破坏机制就十分重要。

The effect of remanet polarization on electro-mechanical fields in ferroelectric ceramics with a flaw has been investigated. Two types of flaw, i.e. an elliptical cavity and a line crack, have been studied in terms of the exact boundary conditions.

二、首次考察了剩余极化对含缺陷的铁电材料力电场的影响，分椭圆孔和裂纹两种情况，并采用精确边界条件进行了求解。

The magnetic properties of carbonyl iron particle s were characterized by VSM;the apparent viscosities and the magnetic field-induced shear stresses of the magnetorheological fluids above were investigated by an advanced rheometric expansion system;the properties of MR damper were tested by an electro-hydralic servocontrol testing system.

研究了一种新型MR液和MR阻尼器；用振动样品磁强计测试了MPS-MRF-25羰基铁粉的磁性能；用磁流变仪测试了MR液的表观粘度和磁致剪切应力；用静置沉降法分析了MR液的抗沉降稳定性；用电液伺服材料性能试验机测试了MR阻尼器的性能。

Finally, the article discussed the possible mechanism of multi-phase electrochemical degradation of wastewater through the XPS spectrum of the used catalysts surface: In the acid solutions, the electro-generated O_2 may get electrons on the porous graphite cathode and then form H_2O_2, H_2O_2 may diffused to the surface of catalyst and reacted with its active part to produce OH, which in turn can destruct organics. The catalyst functioned as both the catalyst to decompose H_2O_2 and the flocculants to sedimentate the degraded waste.

最后全文结合研究反应后催化剂表面的XPS光电子能谱推断了该体系降解污废水可能的反应机理：在酸性条件下，石墨双阳极产生的O_2被多孔扩散性石墨阴极还原成H_2O_2，并通过扩散传质作用在催化剂的表面活性中心分解为强氧化性中间产物·OH，强氧化性攻击有机物，使其降解为小分子有机物或CO_2和H_2O，催化剂在体系中即起催化作用也起吸附、絮凝作用。

The recent development of the analysis of trace arsenic is reviewed,including spectrophotography,atomic-absorption spectrometry,atomic-fluorescence spectrometry and electro-chemical determination.

综述了近年来痕量砷的测定方法，主要包括分光光度法、原子吸收光谱法、原子荧光法、电化学方法、X-射线荧光法、电感耦合等离子体质谱法等，并展望了联用技术在砷形态的分离和测定的应用前景

The alumina bubble is a hollow spherulitic heat-insulating material,which is made by electro-melted method.

氧化铝空心球是由电熔法制得的空心球状隔热材料。

In addition, a printing plate edge marked slopes or plate is too thin, or short-run printing of excessive wear lighter, so that the short-run suites and whitespace differences of high and low is too low and too soft pads, resulting in suites blank areaand, electro-chemical layer of aluminum foil, etc, should be made at the edge version slope near 90-degree right-angle (such as seihan with carving techniques that help you make little gradient edge version), according to the characteristics of the short-run suites, with thickness larger plate seihan, and a blank site, using a corrosion deeper stereoplasm lining for short-run; in addition, you should choose thin aluminized layer of anodized, adjust the appropriate business card printing and membership card making and adjusted pressure volume drum uponsize pressuer letoff drum.

此外，印版边沿存在明显的斜坡度或版材太薄，或印版过量烫印磨损变浅，使烫印版面与空白的高低差异太小，衬垫材料过软，造成版面空白部位与电化铝箔层接触等，应将版边沿坡度制成近90 度的直角(如采用雕刻工艺进行制版，可使版边沿几乎没有坡度)，根据烫印版面的特点，采用厚度大一些的版材制版，并将空白部位腐蚀深一点，采用硬质包衬进行烫印；此外，应选择镀铝层较薄的电化铝，调整合适的制卡和会员卡制作压力，并适当调整压卷滚筒压力和收卷滚筒拉力。

In this paper, the pure nickel layer deposited on stainless steel surface has been obtained by pulse electro-plating from sulphamate nickel-based electrolyte.

本文采用氨基磺酸镍高速镀液通过脉冲电镀在不锈钢基体上制得纯镍镀层。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。