查询词典 elastic

It can be concluded that, when only elastic impact is considered, the coefficient of restitution is determined by not only the material property of the target, but also the mass ratio of the colliding body to the target, and the boundary condition of the target.

结论如下：只考虑弹性碰撞时，恢复系数不仅与靶体的材料性质有关，还与碰撞物体质量比、靶体的支承条件有关，但与碰撞的初始速度无关。

The classical Hertz and JKR elastic contact theory is successfully applied to the plastic collision of cohesive particles. And the coefficient of restitution is then defined from the consideration of energy.

在经典Hertz弹性接触理论和JKR粘弹性接触理论的基础上，本文从理论上将其推广应用至粘附性颗粒塑性碰撞的情形，并从能量的角度定义了能够更加合理反映碰撞规律的弹性回复系数。

With a rational assumption of the viscosity coefficient of the material, the rate-sensitive constitutive equations for the ideally elastic-viscoplastic field are derived under the model.

通过对材料的粘性系数做出合理的假设，推导了一种弹—粘—理想塑性材料的率敏感型本构关系。

In order to remedy this shortage, it was put forward that the frame of terrigenous elastic rocks should be expressed as the collaring rectangle instead of rectangle.

对于陆源碎屑岩来说，这样既不能表示出其粒度变化情况，又不能反映出它形成时的沉积动力学特征。

Take the normal graded granularity for example, the curve function of the collaring rectangle was derived, which can provide a kind of mathematic model for drawing the lithologic frame of terrigenous elastic rocks in the second development of graphic software.

为了弥补绘图软件的这些不足，提出用曲边矩形代替矩形来绘制陆源碎屑岩岩性框架，并以表示正粒序陆源碎屑岩岩性框架的曲边矩形为例，详细推导了其曲边的函数表达式，为绘图软件的二次开发提供了陆源碎屑岩岩性框架绘制的一种数学模型。

Results: 1. A collarless press fit canine femoral stem of CFRPSF composite (elastic modulus was 40 GPa, containing carbon fiber 30%) using HA (50%) and PSF (50%) composite for surface coating was made. Directions of carbon fiber in the stem were similar to the arrangement of trabeculae of proximal femur.

实验结果：1。用弹性模量为40GPa，碳纤维含量为30％的聚砜复合材料，制造出纤维排列方向模拟股骨上段骨小梁走行，表面涂层为羟基磷灰石50％/聚砜50％混合物的压配型狗人工髋关节股骨柄假体。2。

The coefficients in trial function can be gained by the point collocation method, then the solution of the boundary value problems is obtained. Non - uniform beams and irregular plates on Winkler foundation and plates on elastic half space foundation can be numerical calculated by the introduced method.

为对土与结构物的相互作用进行研究，在采用适当的土体模型的基础上，必需求解地基与基础的共同作用方程，而该共同作用方程一般是偏微分方程或微分积分方程，除一些简单的模型外，其解析解较难获得，因此只能采用数值方法求其结果，加权残仇法是一种L作鼠少、简便易行的数仇方法{2，但其解的精度'。

The elastic stress diagram design method is behind the times and cant meet the command in practice.In the paper the author collected and analyzed a large amount of data about the SLRCP on several typical domestic model experiments and the projects in practice. By summarizing and analyzing the data, the author set up a typical computing model and analyzed the model by the software ANSYS, by reading the output data of the stress and the crack from the program, combined with the experimental results, the author summarized the destroy procession of the stock. The paper also discussed the influence of other main factors to the crack and the stress besides the internal water pressure, such as the concrete material, the dimension of stock and the way of laid-out steel bars.

本文通过对大量实际工程中的坝后背管资料的收集、归纳和分析，选取了具有代表性的计算模型；用有限元软件ANSYS计算了典型坝后背管结构在实际内水压力作用下的应力分布和裂缝发展情况；以国内几个有代表性的模型试验和有限元计算的成果为依据，分析了在内水压力作用下钢衬钢筋混凝土压力管道管壁裂缝的特点，并尝试总结出此种管道的裂缝出现的原因及其发展规律，同时确定了坝后背管结构极限状态的新的定义方式——以坝后背管的裂缝宽度来定义。

With the results which include performance point , shear force-displacement , distribution of the plastic hinges and so on, and has carried on the comparison with the elastic response spectrum method and the time-history method . An appraisal has been made after considering the structure earthquake resistance performance.

分析结果包括结构在小震和强震下的性能点和顶点位移，底部剪力-顶部位移，结构破坏时塑性铰的分布等，并与弹性反应谱法和动力时程分析的结果进行了比较，利用分析结果对结构的抗震性能做出了评估。

Considering the influence of fluid's viscosity and large amplitude slosh, the 3-dimension coupling system composed of uncompressible viscous fluid and ideal elastic structure is studied in this paper. The moving state of the interface between the fluid and the structure is analyzed, and the boundary's moving condition (i.e. displacement compatibility) and dynamic condition (i.e. traction equilibrium) are given.

本文探讨了计入流体的粘性、大幅晃动影响，不可压缩粘性流体与弹性体的三维动力耦合问题，分析了流体、固体接触界面的运动状态，给出了其运动和动力边界条件，即位移一致性和作用力平衡条件。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐