查询词典 elastic modulus

Maleic rosin has been added to the surface of wood flour in the form of monoester, i.e., the formation of esterified wood flour bearing a pendent carboxylic group. The rheological study showed that the complex viscosity η(superscript *, storage modulus and loss modulus of WF-HDPE composites decreased firstly and increased afterward and declined lastly as the dosage of maleic rosin increased, however, the viscosity of the composite melts decreased as a whole. After the modification of wood flour, the rheological properties of composite melts were improved markedly. According to the mechanical test it was indicated that, by proper treatment of wood flour with maleic rosin, the tensile strength and flexural strength of WF-HDPE increased obviously.

WF-HDPE流变学研究表明：复合材料的复合黏度η(上标*、储能模量和损耗模量随马来松香用量的增加先减小后增大最后减小，但体系的黏度和模量总体呈下降趋势，木粉经马来松香改性后复合熔体的流变性能显著改善，这不仅有利于提高复合材料的成型加工效率，而且适当的马来松香处理也能够提高复合材料的拉伸强度和弯曲强度，后者被静态力学试验结果所证实。

Choice of materials for Q235, The choice program is stamping process Piercing blanking -- thinning Burring -- Wedge-bending -- U-shaped curve In this program of cost savings but also appropriate to increase production efficiency, use of this program will mainly involve the following four die : Punching blanking die;(2) thinning Burring die;(3) Wedge-bending modulus;(4) U-bending modulus.

选择的材料为Q235，选择的冲压工艺方案是冲孔落料--变薄翻孔--斜楔式弯曲--U型弯曲，此方案在节约成本的同时也适当的提高了生产的效率，采用此方案将主要涉及到以下四套冲压模具：（1）冲孔落料模；(2)变薄翻孔模；(3)斜楔式弯曲模；(4)U型弯曲模。

Taking the remolded soil after K 0consolidation and the samples under special stress state by special stress path as the objects, the effect of stress path circumgyration on shear modulus and the trend of shear modulus along with strain under condition of small strain are studied.

以重塑土经K0固结形成的试样以及经K0固结后通过特殊应力路径达到特定应力状态的试样为对象，研究了在小应变范围内应力路径旋转对土体剪切模量的影响以及剪切模量随应变变化的趋势。

Under the condition of small strain, the initial value of shear modulus increased along with the increment of angle θ between trail stress paths and recent stress history. If the two directions were entirely reverse, the effect of stress path circumgyration on shear modulus was the largest; if they coincided completely, the effect was very feeble.

研究表明，在小应变范围内，剪切模量的初始值随试验应力路径与近期应力历史间的夹角θ的增大而增大，当两者完全相反时，应力路径旋转对土体在小应变条件下的剪切模量影响最大；完全一致时，其影响最弱。

The test object was remolded soil after K0 consolidation. Using advanced stress path triaxial system, STDTTS+UNSAT (7kN/1700 kPa) produced by GDS of UK, the effect of stress path circumgyration on shear modulus and the trend of shear modulus along with variation of shear strain under small strain were studied. Some conclusions were drawn.

以重塑土经K0固结形成的试样为试验对象，采用英国GDS公司生产的STDTTS+UNSAT (7kN/1700 kPa)型号高级应力路径三轴测试系统，研究了在小应变范围内应力路径旋转对土体剪切模量的影响以及剪切模量随应变变化的趋势。

It is convenient for sinter to be leached, and the secondary reaction appears little. The slurry after sinter leaching is transferred into autoclave for desilicification at about 170℃, and the siliceous modulus of solution reaches more than 200. Then some lime is added for deep-desilication at normal pressure, the siliceous modulus of solution increases more than 600 even if the Al2O3 content is more than 200g/L.The SiO2 coefficient in hydrate garnet from deep-desilication is more than 0.28. Under conditions of the addition of seed and application of novel technology of carbonization, the contents of Na2O and SiO2 in product are less than 0.37% and 0.025%, respectively.

实验结果显示：烧成的熟料溶出条件宽松，二次反应程度弱；溶出浆液在170℃左右直接进行加压脱硅，脱硅后溶液的硅量指数大于200，再加入适量的石灰进行深度脱硅，即使溶液中氧化铝浓度超过200g/L时，精液的硅量指数也大于600，且得到的水化石榴石中二氧化硅饱和系数大于0.28；通过加入晶种和采用新的碳酸化分解工艺制度，产品中的SiO2 含量降至0.025%， Na2O含量小于0.37%；加入表面活性剂，不仅能将碳分母液蒸发至Na2OT浓度大于300g/L，而且还可有效减缓表面上结疤的形成速度。

Adding water in forsterite crystal cell decreases bulk modulus, shear modulus, and sound velocities of forsterite.

镁橄榄石晶格中存在水会使镁橄榄石弹性模量及波速降低。

In this paper,the mechanical properties of the old PCC pavement structure overlaid with AC was analyzed with ANSYS,a software for finite element analysis,and the influence of interlayers,depth of AC-overlay and modulus of AC-overlay was taken account.According to the study it could be concluded that in order to retard the reflective cracking the interlayer should be put below the overlayer and the interlayer of high modulus can take effect well.

结合试验路实体工程，采用有限元方法分析了土工布、玻璃纤维网对旧水泥混凝土路面沥青混凝土加铺层复合式路面结构的内力影响，发现为防治旧PCC路面的接缝/裂缝在AC加铺层内产生反射裂缝，宜在加铺层底部铺设夹层，且模量较大的玻璃纤维网效果更好。

The damage represents complex mechanism. In this research based on T300/HT3 laminate structure, fatigue life is predicted phenomenologically, dealing mainly with in-plane stresses without accounting for out-of-plane failures such as craze. Fatigue modulus, based on damage mechanics, is used as a physical parameter which helps to describe the basic fatigue behaviors of unidirectional laminates and obtain expressions for cumulative damages defined by strains and stress. Based on some typical fatigue test data for unidirectional composite laminates, residual modulus sequence is found out.

本文以T300/HT3复合材料层压结构为研究对象，从唯象的观点出发，以损伤力学为基础构造损伤函数，考虑了剩余刚度和应变比率对复合材料的疲劳性能的影响，以这些变化着的机械性能作为损伤变量，建立了复合材料的疲劳损伤模型，基于层压板拉—拉疲劳试验数据，拟合出损伤模型中的参数，从而得到层压板拉—拉疲劳损伤变化规律，并建立损伤变量与内部损伤及疲劳寿命的联系，从而预测常幅应力作用下疲劳寿命。

In the paper, we give the notion of the pointwise convex modulus, the relation between the pointwise convex modulus and some geometric propertries are discussed.

本文主要是给出点态凸性模的定义，并讨论了点态凸性模与一些几何性质之间的关系。

In the days of sailing vessels the crew were afraid they would be becalmed on the ocean.

在使用帆船的时代，船员们担心他们会因为无风而无法在海洋上航行。

As long as foreign donors pay the PA's salary bill, few expect a new intifada.

只要外国继续为巴权力机构的薪水买单，希望发动新暴动的人便寥寥无几。