查询词典 ejection

The fuel ejection system has important effect on the injurant emission of diesel engine.

燃油喷射系统对柴油机有害物的排放有着重要的影响。

Aiming at the problem that injurant discharged from the traditional fuel ejection system pollutes environment,analyzes the causes that injurant comes into being.

针对传统燃油喷射系统有害物排放污染环境的问题，分析了有害物生成的原因。

The aerodynamic performance of bowed blade becomes worse when the ejection flux is getting larger in the mid-span.

在叶高中部喷气量较大时，弯叶片的气动性能下降较大。

Provide under and over feed protection at the end of the die strip buckling, misfeed, part ejection, etc.

在模具后端在上下均使用送料保护装置（扣料，误送检测，产品顶出等

The sides of the molding terminate at a feather edge and the only simple posed ejection is by means of molding face pins as illustrated.

塑件侧面在翅边收尾，仅有的最简单而可靠的顶出方法是图示塑件面顶杆。

I For the ejection of certain types of circular mouldings.

某些圆形塑件的顶出。

I For the ejection of certain types of circular mouldings.

塑件用中空的顶杆顶出的方式称之为顶管。

The reason is that the guide pillar must support the stripper plate over the complete ejection stroke and.

导柱的工作直径部分的长度通常比对应两半模形式的导柱长。

D. One case had diabetic retinopathy and fundus oculi hemorrhage for many times; two cases showed apparent coronary atherosclerotic heart disease with preoperative cardiac ejection fraction of 52% and 50%.

d，其中1例合并糖尿病视网膜病变，多次眼底出血；2例合并明显冠状动脉粥样硬化性心脏病，移植前心脏射血分数分别为52%和50%。

When assembled, the ejection cylinder slides into to nosecone, mating with the piston.

当组装，弹射缸幻灯片进入nosecone ，交配与活塞。

According to our present broadcasting situation,the thesis proposes using new technology to update and reform the present HFC. It also suggests broadcasting using self-advantage and arranging EPON in order to win the supermarket.

论文从我国广电的现状出发，结合实际，积极倡导采用新技术更新、改造我国现有的HFC网络；倡导广电现阶段利用自身优势，部署EPON网络来赢取市场。

A new general kinetic equation was derived in which the effect of the removal of condensation water was taken into account completely, and was applied to the polyesterification kinetic study of AA/HPHP and AA/NPG. It was found that the reaction order of self-catalyzed polyesterification was not constant. For these polyesterifications, the reaction order was 2.5 at a low temperature, while 3.0 at a high temperature.

考虑缩合水的排除对反应体系的影响，用体积浓度单位推导出一个新的聚酯反应总包动力学方程，并应用到AA/HPHP和AA/NPG两个聚酯化反应的动力学研究中，研究发现，自催化聚酯反应的反应级数并不是固定值，对于AA/HPHP和AA/NPG两个聚酯化反应而言，低温时反应级数为2.5，高温时反应级数为3.0。