查询词典 efficiency

The average removal efficiency of TP and COD was 28.76% and 8% after cloth media filter without coagulation, and TP removal was influenced by the influent water quality. However, precoagulation with coagulants of ferric chloride, PAFC, PAC, the average removal efficiency of TP was 63.58%, 60.13% and 66.94% respectively, and no influence of TP removal can be found by the influent water quality. The average removal efficiency of COD was of 17.7%,26.3% and 27.7%,SS was 70.7%,64.3% and 49.1%.

当不投加混凝剂时，滤布滤池对TP和COD的平均去除率为28.76%和8%，其中TP的去除效果受进水水质影响较大；当投加氯化铁、聚合氯化铝铁与聚合氯化铝强化滤布滤池时，滤布滤池对TP的平均去除率分别为63.58%、60.13%和66.94%，TP去除效果受进水水质影响较小；对SS的平均去除率分别为70.7%、64.3%和49.1%；对COD平均去除率分别为17.7%、26.3%和27.7%。

This paper tests the controlling efficiency of China's monetary tools on base money, and indicates that China's monetary tools' efficiency is low. Moreover, it relatively shows that the efficacy of interest rate of required reserve is higher than mirror image of foreign exchange reserve, which is higher than the efficiency of reloan and the required reserve ratio.

以1999年12月至2007年3月相关变量的月度数据为样本对交互影响和多元反馈条件下我国货币政策工具对基础货币的控制效率做检验，得出：样本区间内，我国货币政策工具的控制效率低，相对而言存款准备金利率作用效力相对较高，外汇占款次之，再贷款和法定准备金率效率低。

The results show that Sb addition can diminish the crystal grain, but the content of segregative phase at crystal boundary increases, and the current efficiency of material is low. Compared with Sb addition, Sn addition can also diminish the crystal grain, the current efficiency increases, the content of segregative phase at crystal boundary reduces, but diffusional corrosion of the anode surface is not uniform. The cooperation of Sb and Sn can prevent Si from segregating effectively and enhance the current efficiency obviously. At the same time, anode materials have preferable surface dissolution characteristics.

结果表明： Sb具有细化晶粒的作用，但晶界存在较多偏析相，电流效率偏低；与Sb相比较， Sn也具有细化晶粒的作用，电流效率有所提高，晶界偏析相较少，但阳极的表面腐蚀溶解不均匀； Sn和Sb的协同作用在于能有效地抑制Si的偏析，显著提高阳极的电流效率，使得阳极表面具有良好的腐蚀溶解性。

Based on a computing model of floor heating residences, indoor thermal environment and heat distribution under the effect of heat charge/discharge, operation control and solar radiation has been concluded. Concept and formula of equivalent heat supply has been put forward which indicate that actual heat supply will be equal to the sum of design heat supply and equivalent heat supply. Recommend coefficient has been given taken Dalian as an example. Computed according to the new method, design heat supply can be reduced to 37% in cloudy day and 43.3% in sunny day, energy saving effect is very obvious. In Tromb wall solar house, effect of concrete wall on indoor temperature swing and attenuation of temperature wave is very obvious. While the outdoor air-temperature swing exceeds 10℃, indoor air-temperature swing belows 3℃. In the experiment, maximal difference in temperature between inner surface and outer surface of the 300mm wall exceeded 10℃. Heat storage and collector efficiency varies adversely according to solar radiation. Factors such as thickness, material, absorptance of the wall and permeation of the glass cover all have big influence on heat storage and collector efficiency. There exsisted an optimal thickness of the wall, which can make the best of heat storage and collector efficiency. Most of the heat stored in conventional Trombe wall during the daytime has been lost to the outside at night without heat preservation. Heat preservation on the outside surface of the wall has effectively improved heat release performance of the wall at night, heat supply to the room has increased too.

通过建立的地板采暖系统动态热性能分析模型，得出了在蓄放热特性、运行方式和太阳辐射等因素耦合作用下的室内热环境及热量分配比例，提出了等效供热量的概念及计算公式，指出实际所需供热量应等于设计供热量加上等效供热量，并以大连为例，给出了等效供热量的修正系数，以新方法计算，阴天可减少设计供热量37％，晴天最大可以减少设计供热量43.3％，节能效果显著；集热蓄热墙式太阳房中，混凝土蓄热墙的室温均一化效果和对温度波的削减作用非常明显，当室外温度波动最大幅度超过10℃时，室温波幅不超过3℃，实验中300mm厚墙体内外表面温差超过10℃；墙体蓄热效率与集热效率随太阳辐射照度的变化呈相反的变化趋势；墙体厚度、材料、表面吸收率以及盖板透过率等因素对集热和蓄热效率均有较大的影响，存在一个最佳的墙体厚度值，使得墙体集热和蓄热综合性能最优；传统的蓄热墙夜间没有外保温，辐射散热损失很大，研究表明墙体外保温方式明显改善了蓄热墙夜间的散热性能，增加了向室内的供热量。

The study will develop the important research domain in the high efficiency grinding which has great potentialities, considering that the increase of heat transfer efficiency means an synchronous increase of the limit material removal rate under the condition of grinding unburn, therefore the further perfection of this study will not only increase the available material removal rate to a new level, but also solve the workpiece burn problem of the difficult-to-machining materials in the high efficiency grinding, which has great technical and economical significance

本项研究可望开拓高效磨削的极富潜力的重要研究方向，考虑到换热效率的提高本身也就意味着磨削时不发生烧伤的材料极限去除率的同步提高，因而进一步完善此项研究不仅可望将现有高效深切磨削的材料去除率提高到一个新水平，而且将有效解决难加工材料的高效磨削问题，其技术经济意义十分重大。

And the direction query efficiency based on multi-approximate index is compared with that based on taditional external approximation index. 2 The algorithms of nearest neighbor and reverse nearest neighbor about point, line and ploygen based on multi-approximate index are proposed after the virous methods of distance measure are discussed in detail. And the query efficiency of NN and RNN based on multi-approximate index is compared with that based on taditional external approximation index. 3 The basic concept of semi-join and the strategy of distance-direction semi-join are introduced. And the model of distance relationship, direction relationship and the bounding for spatial object are discussed. Then the method is presented about how to implement the query of distance-direction semi-join, and the efficiency of the algorithm based on multi-approximate index is compared with that based on taditional external approximation index.

即：1在方向关系矩阵模型、开域方向模型基础上，讨论了基于多重近似索引下的定性与定量方向检索方法，并通过实验对基于多重近似索引与外部近似索引下的方向检索效率进行了对比分析；2详细讨论了各种距离度量方法，提出了基于多重近似索引下的点、线、面的最邻近查询和反最邻近查询算法，并通过实验对基于多重近似索引与外部近似索引下的最邻近查询和反最邻近查询效率进行比较分析；3介绍了半连接的基本概念，探讨了距离关系、方向关系以及空间对象数量的约束模型，给出了基于多重近似索引下的距离方向半连接实现方法，并通过实验对基于多重近似索引与外部近似索引下的距离方向半连接的效率进行了比较分析。

Uses the automated control not only on the galvanization production line to be possible to raise the product manufacturing efficiency and to reduce worker's labor intensity, and has the very good economic efficiency and the social efficiency, galvanizes on the production line to be possible to realize the automated control using PLC, PLC has the reliability to be high, the compatibility is broad, has the correspondence function, the structure modulation characteristic, therefore how to use good PLC to become the galvanization production line automation control key, auxiliary to galvanized the automatic production line driving with PLC by the frequency changer to carry on the automatic control, had the structure to be simple, the programming was convenient, the operation was flexible, the use safe, worked stable, the perform reliably and the antijamming ability strong characteristic, was one kind of very effective automatic controlThe way, is galvanizes the production to realize, the low cost, the high grade automated production development direction highly effective.

在电镀生产线上采用自动化控制不但可以提高产品生产效率和减轻工人的劳动强度，而且有着非常好的经济效益和社会效益，电镀生产线上运用PLC则可以实现自动化控制，PLC具有可靠性高，适应性广，具有通信功能，结构模块化的特点，因此如何使用好PLC成了电镀生产线自动化控制的关键，用PLC辅以变频器对电镀自动生产线行车进行自动控制，具有结构简单、编程方便、操作灵活、使用安全、工作稳定、性能可靠和抗干扰能力强的特点，是一种很有效的自动控制方式，是电镀生产实现高效、低成本、高质量自动化生产的发展方向。

The nitrogen removal experiment implies that the nitrogen removal efficiency is very high. The ratio of NH_4~--N/TN is approximately equal to the ratio of TN removal. TN removal efficiency is mainly affected by the influent NH_4~--N concentration, and the optimal TN removal efficiency can be prejudged by the ratio of influent NH_4~--N/TN.

通过对反应器的脱氮研究，发现该反应器的NH_4~--N去除率非常高，发现进水NH_4~--N／TN的百分比值基本上与总氮的去除率一致，脱氮的效果基本取决于进水氨的浓度，最佳的TN的去除效率能通过进水的NH_4~--N／TN比例来判断。

This paper researches the jet pump performance in the water supply of hydropower station technology,through numerical value calculation to determine the geometric size of the flow components,and ensure the efficiency to be the highest value,and Derives the expression for efficiency and performance,protracts operating characteristics of jet pump and efficiency feature curve under different area.

本文针对水电站技术供水中的射流泵进行性能研究，通过数值计算，确定各过流部件的几何尺寸，以保障效率达到最高值。

The experiment result show that desulfurization efficiency declined with the increase of flue gas flux and SO_2 inlet concentration; desulfurization efficiency added with the enhance of Ca/S molar ratio, flue gas humidity, the moisture content of calcium sorbent, desulfurization efficiency also increased after adding activated vapor, superinducing additive, inflicting applied voltage.

试验表明：随着烟气流量，SO_2进口浓度的增加，脱硫效率降低；随着钙硫比，烟气含湿量，石灰含水率的增加，脱硫效率增加：随着活化蒸气的通入，外加添加剂的加入，外加电压的施加，系统的脱硫效率增加。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。