查询词典 edges

By Galerkin meshless method, the equations of motion of static rectangular membrane is established. The first ten natural frequencies of the different aspect ratios and the different pull ratios of rectangular membrane with four clamped edges, three clamped edges and one free edge, two opposite free edges and other two clamped edges were calculated. It is feasible and valid to solve the transverse vibration problem of membrane by Galerkin meshless method.

采用伽辽金无网格法，建立了矩形薄膜横向自由振动的运动方程，并对四边固支、三边固支一边自由、一对边固支另一对边自由三种边界条件下，薄膜的不同长宽比及不同单位长度拉力比作用下的矩形薄膜的前十阶固有频率进行了数值计算，结果说明伽辽金无网格法用于求解薄膜横向振动问题是切实可行的。

Crack propagation problems under the influence of the edges of the crack subjected to homogenous loads, the origin of the coordinates subjected to concentrated increasing loads, the central zone of the edges of the crack subjected to homogenous loads, the certain point of the edges of the crack subjected to moving unit step loads, the origin of the coordinates subjected to moving increasing loads Px m, the edges of the crack subjected to instantaneous impulse loads, the edges of the crack subjected to moving concentrated variable loads, the origin of the coordinates subjected to point loads, the edges of the crack subjected to a constant moving concentrated loads and the origin of the coordinates subjected to instantaneously moving impulse loads are studied respectively, and the analytical solutions of dislocation distribution function have been obtained.

同时对裂纹面受均布载荷、坐标原点受集中增加载荷、裂纹面中心区受均布载荷、裂纹面上某点受运动阶跃载荷、坐标原点受运动增加载荷Px m、坐标原点受瞬时冲击载荷、裂纹面受运动集中变载荷、坐标原点受集中载荷、裂纹面受常数运动集中载荷、坐标原点受瞬时运动冲击载荷作用下的裂纹扩展问题分别进行了研究，获得了位错分布函数的解析解。

An algorithm of edge detection combined with morphological filter is proposed, firstly, it adopts adaptive method to decide the wimble structuring element and applies iterative morphological filter based on two wimble structure elements to filter the image, then uses multi-scale morphological edge detector to get multi-scale edges, and obtains the more ideal image edges under the environment of existing noise by integrating the edges of various sizes.

文中提出了一种结合形态学滤波的边缘检测算法，该算法采用自适应方法确定锥形结构元素，然后利用双锥形结构元素对图像进行形态学迭代滤波，对滤波后的图像进行多尺度形态学边缘检测，并将各尺度下边缘检测的结果进行合成，最终得到在噪声存在条件下较为理想的图像边缘，并且与其它边缘检测算法进行了对比实验，实验验证了该算法的可行性和有效性。

And water board press paper ball at the edges: transmission and paperboard paper before syndiospecific back, the value of paper paper ball should leave the edges, but sometimes paper aglaonema'silver queen'under sected size is too large, which results in a press paper ball edges.

负纸不活压纸球压着纸边：负纸不活上的纸弛出去后规后，负纸不活压纸球答当挨近纸边，但有时纸弛栽切尺寸太不小，而导致该压纸球压着纸边。

The monitoring images were opened and closed using a circle structural element in morphological in the algorithm, and their edges were detected with Canny operator. With the transform analysis of the edges images, the linear characteristics of the edges of the empty-trains-images were outstood.

运用圆形结构元素对监控图像进行形态学的先开启、后闭合的操作，用Canny边缘检测算子来检测图像的边缘，并对边缘的图像进行变换分析，突出了空列车图像边缘的直线性质。

Digital image process technique is used in pantographic faults monitoring, and a new algorithm named window-edge tracking is proposed in this paper. Based on the binary image of edges which is detected by Canny operator, a window in proper size is set to track the discontinuous edges to estimate the position of the lost edges. With this method continuous edges will be obtained, and continuous and smooth edges will be got after least-squares curve-fitting.

中文摘要：将数字图像处理技术应用于受电弓故障监测，提出一种新型的窗口边缘跟踪算法，在采用Canny算子计算出边缘二值图的基础上，设置适当大小的窗口对初始不连续边缘进行遍历，估计断点处边缘点位置获得连续边缘，并采用最小二乘法拟和出连续平滑的曲线函数。

While only first-order gradient feature (denoted by 1) and the feature used in SRNE (denoted by 12) yield results with obvious jagged staircase effect in the constant color region and NEVPM yields results with noisy edges and blur, the proposed improved feature combination with a (13al) preserves sharper edges and shapes and suppress blocky artifacts such as the edges of goblet and book.

仅当第一顺序梯度特征（表示1）和用于在连续色彩区域中其结果明显带有锯齿状阶梯形的SRNE的特征（表示12），以及用于结果带有边缘和污点干扰的NEVPM的特征，被提议的改进的特征组合a（13al）保留了较锋利的边缘和外形以及人为控制的块状，比如酒杯和书的边缘。

It was derived from Mondrian's sketches of Paris building facades that included traces of demolished elements.Rule decided to use a similar composition--an interlocking sequence of spaces and angles,but composed on the ground plane with lawn edges,low walls,and arrangements of hedges.This had tremendous appeal for the client,an art collector.Rule outdid the competing designer,and the three-acre garden was completed in 2002 after two years of design and construction.

他来自蒙德里安的绘画巴黎的建筑立面，其中包括痕迹拆卸法治要素决定采用类似成分-联锁序列的空间和角度，但对组成的地面上的飞机与草坪边，低墙，并安排h edges.this了强大的感召力，为客户，一门艺术c ollector.ruleo utdid竞争的设计师，和三英亩的花园，是在2002年完成，经过两年的设计和施工。

Daily production circumstances, be it hand-mounted or mounted automatic mechanical, it is inevitable that mounted are not allowed to occur, in order to prevent the phenomenon of mounted after the non-business card printing and membership card making dangersous them…we edges appear is projected in the phenomenon, generally business card printing and membership card making to the characteristics of the product, the business card printing and membership card making semi-finished side gauges and control edges before placing 3 ~ 6 mm overlap at the ends of the cutting, which mounted, the non-business card printing and membership card making dangersous the rules appropriate to the inner edges of microphtography for some mm mounted to effectively prevent non-business card printing and membership card making dangersous them…we pop-out phenomenon appears edges ensure precise cutting.

日常生产情况表明，不论是手工裱贴或机械自动裱贴，都难免会出现裱贴不准现象，为防止裱贴后的非制卡和会员卡制作面的规矩纸边出现凸出现象，一般在制卡和会员卡制作时就要根据产品的特点，将制卡和会员卡制作半成品的侧规和前规纸边加放3～6mm不等的修边余量，这样裱贴时，将非制卡和会员卡制作面的规矩纸边适当往内缩若干毫米进行裱贴，可有效地防止非制卡和会员卡制作面的规矩纸边出现凸出现象，保证产品模切的准确。

Daily production circumstances, be it hand-mounted or mounted automatic mechanical, it is inevitable that mounted are not allowed to occur, in order to prevent the phenomenon of mounted non-business card printing after dangersous them…we projecting edges appear, usually in the phenomenon of hkd250 based on the characteristics of the product, the business card printing for side gauges and padding on the edges of the former syndiospecific 3-6 mm overlap at the ends of the cutting, which mounted, the non-business card printing dangersous them…we edges appropriate to carry out some mm sonagraph mounted to effectively prevent non-business card printing dangersous them…we projecting edges appear and which would ensure the accuracy of the die-cutting.

常日不入产环境暗示，不论是手工裱贴或板滞被迫裱贴，都不免会呈现裱贴禁绝本体，为避免裱贴后的否制卡背的端方纸边呈现凹陷本体，凡是在制卡时不离给根据产物的特点，不兵制卡半制品的侧规和后规纸边增不收3—6mm不相等的修边余量，这样裱贴时，不兵否制卡背的端方纸边不分往边伸众少毫米举行裱贴，可灵验不天避免否制卡背的端方纸边呈现凹陷本体，包管产物模切的不确。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。