查询词典 e-card
- 与 e-card 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Yes. Do you have an I. D. card ?
有的,您有学生证吗?
-
In addition, check the "Device Manager" in the scanner conflicts with other equipment (IRQ or I / O address), if there is a conflict, you need to change the jumper on the SCSI card.
此外,还应检查"设备管理器"中扫描仪是否与其他设备冲突( IRQ 或 I/O 地址),如果有冲突,则需要更改 SCSI 卡上的跳线。
-
Inspection, we can use the mouse in order to open "Control Panel / System / Device Manager / Network adapter" settings window in the window to check whether the interrupt number and I / O address conflict (the best machine to all the interruption of the same set in order to facilitate the comparison), until the network adapter in the attribute of "the device is operating normally," and in "Network Places" to find himself at least that there is no problem with the configuration of the network card.
检查时,我们可以用鼠标依次打开"控制面板/系统/设备管理/网络适配器"设置窗口,在该窗口中检查一下有无中断号及I/O地址冲突(最好将各台机器的中断设为相同,以便于对比),直到网络适配器的属性中出现"该设备运转正常",并且在"网上邻居"中至少能找到自己,说明网卡的配置没有问题。
-
Host system failures are many reasons, such as the motherboard's own fault or I / O bus fault may lead to a variety of add-in card system is not normal.
主机系统产生故障的原因很多,例如主板自身故障或 I/O 总线上的各种插卡故障均可导致系统运行不正常。
-
I have to see your I.D. card.
我必须看你的证件。
-
C: May I see your credit card and I.D.?
请把你的卡和身份证给我,好吗?
-
Can you let me look at your I.D. card?
你能把身分证借给我看吗?
-
As for me, I brought my I.D. Card and its stamped/signed Chinese translation.
就我来说,我出示了我的身份证和盖了章的英语版本身份证。
-
May I have your student's I.D. card?
可以看一下你的学生证吗?
-
That's all. Please get your new I.D. card here next week.
就这些了,下个星期过来取你的新身份证吧。
- 相关中文对照歌词
- Birthday Card
- Face Card
- Wild Card
- Report Card
- Christmas Cards
- Nando's Song
- Love Letter
- An Old Christmas Card
- A Love Letter Christmas
- Drinks On Me
- 推荐网络例句
-
Based on the relationship and the phenomenon model, an improved model of MR damper has been presented in this paper.
摘 要:本文在实验数据的基础上建立了磁流变阻尼器输出力与不同常电流控制量的关系,对现有的 p模型进行了改进。
-
I don't think our founding fathers were very fuckable.
我认为我们的开国元老没什么吸引力
-
In chapter 3, an optimum method of milling parameter based on orthogonal cutting finite element model is proposed.
第三章提出了基于正交切削加工有限元模型的铣削参数优化方法。