查询词典 due process

It is important for the application of formal approach and formal specification in all stages of software development to study and design automatic refinement from Z to high-levellanguage: Insure complete formalization in all stages of software development; Avoid antilogy in refinement due to mistaken operation or computative mistake and insure consistency and integrity of system; Due to avoiding manual operation in refinement process, it is feasible to bulid a compile environment that Z specification automatic refine and form high-level programme, this will accelerate the promotion and application of Z in industry.

Z到高级语言自动求精的研究与设计对于形式化方法及形式规格说明应用于软件开发的各个阶段具有非常重要的意义：确保了从需求分析阶段开始的软件开发周期的完全形式化；避免了人工的误操作或演算错误导致的求精前后不一致，保证了系统的一致性和完整性；由于求精过程避免了手工操作，因而Z规格说明自动精化为程序代码的编译环境可以建立，这将会加速Z规格说明在工业界的推广应用。

The heat due to losses of a process can be calculated according to total losses, differential equation of the motor, initial conditions and rotational angle. Since a period has several processes, the total heat due to losses of a period can be get by summing the losses heat of every process and the average losses can be calculated by dividing the total heat of a period with the cycle time.

根据电机运行总损耗和电机运行微分方程，结合初始条件和电机转角，获得了电机运行过程的损耗热，将一个周期内各运行过程的损耗热相加，可以得到一个周期内的总损耗热，从而一个周期内的平均损耗可求，以此为依据，和电机的额定损耗相比较，可以判断该电机在该工作制下的合理性。

From the "" to wet-membrane "" viscostty dry film evolves, you can see any of the oils or gloss drying or curing process must go through the process of viscosimetry products, that is solid oils or varnish, mostly due to its own power, but was decoratine adhensive in coated packaging business card printing and membership card making products surface, it is not possible to immediately contiguous becomes solid continuous gloss films, only up to a certain conditions in order to complete all of the varnish coating to the drying process of prefilming.

从"湿膜"到"干膜"的粘度变化过程中，可以看到：任何一种的底油或光油的干燥或固化过程必然都要经历该产品粘度的变化过程，即是固体的底油或光油，由于其本身多为粉末状，但在装饰粘附在被涂布的包装制卡和会员卡制作制品表面后，还不可能立即就形成连续进行变成为固体连续光油薄膜的过程，只有达到一定条件才能完成全部的由光油涂布到干燥成膜的过程。

Based on observation data, the development process of the breach of landslide dams due to over topping may divided into 3 modes: vertical erosion, breadthwise extension and regression erosion of dam slope. A mathematical model describing the gradual failure process of the landslide dams is established based on the formula expressing the high intensity erosion obtained from experimental data, which can integrate the 3 modes of breach development process together. The validity of the model is verified by observation data.

根据一般滑坡堰塞坝特点和实际观测到的堰塞坝溃口发展规律建立了一个溃口扩展模式，并将溃口扩展过程归纳为溃口垂直下切、横向扩展和坝坡溯源冲刷3种主要表现形式，采用通过试验资料建立的高强度泥沙冲刷计算公式将这3种表现方式联系在一起，建立了堰塞坝逐渐溃决数学模型，并利用实测溃坝资料验证了模型的可靠性。

Bellows premature failure often occurs in engineering application due to polythionic acids stress corrosion cracking or due to high-temperature oxidation and sulphidation Failure with development of catalyse and cracking process technology of heavy oil.

随着重油催化裂化技术的发展，波纹管在实际工程应用中经常发生连多硫酸应力腐蚀、高温硫化-氧化腐蚀失效。

The microstructure and morphology are examined by SEM, XRD, EPMA, and the electrochemical performance is studied by potentiodynamic polarization and current efficiency. The results show that the alloy elements in the electrode coating prepared by the sol-gel process are well distributed, more sufficient to form solid solution and with higher current efficiency than by the traditional thermal decomposition process. The deactivation effect is due to the forming of unconductive TiO2 for the sol-gel process, but due to the dissolution of active composition for the thermal decomposition process.

SEM、XRD、电子探针、极化曲线、电流效率实验表明，由溶胶-凝胶法制备的氧化物涂层比热分解法制备的氧化物涂层的分散性好、形成固溶体充分、电流效率高；由溶胶-凝胶法制备的氧化物涂层的失效是由于生成不导电的TiO2引起，而由热分解法制备的氧化物涂层的失效是由于活性氧化物涂层的溶解引起。

The objectives of this paper were to investigate the simulation and design of continuous multiple-station rolling forming process for a U-Section Steel Bar by CAE software-DEFORMTM Due to the limitation of elements number using a short strip 120mm went through all the stations to simulate the real continuous rolling forming on factory The roller gap was fixed as 0 30mm roll speed was 20 rad/sec and progressive angles were all equal for each rolling process which were the formed angle divided by by the number of station Three rolling processes were selected with 6 9 and 12 stations respectively During simulation processes two cases occurred Case A the strip was through a single station Case B the strip across two stations Because the strip laterals side was stretched and twisted during the process The model of case B closer to the practical process than case A and the calculated stress and strain on the tip of U section for case A were lower than these for case B by up to 15% From the result of case B for each process the stress for 12-station process was smallest 9-station process second and 6-station process next Because less-station can save larger cost and forming time but the bigger stress and strain for 6-station caused wrinkles on lateral sides not found on 9-station and 12-station Therefore 9-station process was a more suitable design than 12-station process smaller stretched and twisted and stress The progressive angles for 12-station was 7 5?

本文主要是以DEFORMTM有限元素软体模拟U型钢片连续道次成型与单一道次成型以确认单一道次模拟的是否可取代连续道次模拟之研究。因DEFORMTM 软体对於网格元素上的限制故使用较短素材120mm通过所有的成型站以模拟工厂实际连续成形方法。辊轮间隙固定为0 3mm；辊轮转速为20 rad/sec；弯曲角度的方法为将成型角度平均除以成型站数。有三种辊轮成型方式被选择分别为6站，9站，与12站。在模拟的过程中有两种现象会产生 Case A，素材通过单一成型站。Case B，素材会通过两个成型站。因为在模拟过程中素材的两端会有拉应力与扭力。Case B的模拟比Case A像实际的制程，并计算应力与应变在U型断面的Tip部中可发现Case A比Case B低约15%。从Case B的每站的结果可以得知，12站的成型应力最小，9站次之，6站最后。

The exclusion of illegal evidence in civil litigation reflects the fact that people begin to highpoint the due process in civil litigation.

对民事非法证据的排除，反映了民事诉讼对程序权利和宪法权利问题的关注正日益上升。

When you have finished this lesson, you should be able to explain the Fifth and Sixth Amendment guarantees regarding indictments, double jeopardy, and due process of law. You should be able to identify the rights protected by the Sixth Amendment, particularly the right to counsel. You should be able to describe the Eighth Amendment provisions about bail and punishment.

学完这一课，你应该能够说明，第五条和第六条修正案，关于起诉、双重追诉和正当法律程序的保证；你应该能够识别，第六条修正案保护的权利，特别是获得律师辩护的权利；你应该能够描述，第八条修正案关于保释和惩罚的条款。

"Fifth Amendment:An amendment to the Constitution of the United States, ratified in 1791, that deals with the rights of accused criminals by providing for due process of law, forbidding double jeopardy, and stating that no person may be forced to testify as a witness against himself or herself."

&美国宪法第五修正案：1791年被通过的美国宪法修正案，涉及通过为受指控的罪犯提供适当的法律程序保护他们的权利、禁止双重审判并声明任何人不得被强迫自证其罪。&

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。