查询词典 dsp

More DSP power than even our K Series instruments.

更多DSP功能甚至比我们的K系列文书。

The open architecture intelligent control system for the machining processes is developed and realized by using the key techniques such as plug in module , signal processing network and script command file , etc., on the PC/DSP based open architecture platform. According to the architecture requirements, the principle and development methods of the open real time platform as well as the PIMs used for the intelligent machining processes are studied and designed. Subsequently, the objective systems for the adaptive control and the on-line tool wear estimation are configured by using the SCF files separately.

研究了基于PC/DSP的开放结构智能切削加工控制系统的开发与实现，采用插入式模块PIM(Plug-In-Module)、信号处理网络SPNt和过程描述命令文件SCF等实现系统开放结构的三项关键技术，根据开放结构实时系统平台的结构特点、工作原理及开发过程，设计开发了基于智能切削加工理论和方法的插入式模块的算法流程，采用描述命令文件配置了自适应控制与刀具磨损在线估计的应用目标系统。

In this thesis,I take out oil pole as object to research the principium and the method which base on the DSP to detect the magnetic flux leakage on-line in the first place.

本文以抽油杆为对象，研究了基于DSP的抽油杆在线漏磁无损检测技术的原理和方法，并提出了总体的设计方案和解决方法。

But because the DSP cost is so high, it limites the utility of G.723.1 decoder. Using ASIC to design G.723.1 decoder can reduces the cost, in order to let it be used in more domains.

通用DSP成本较高，若设计专用的G.723.1编解码器ASIC芯片，可有效降低成本，利于G.723.1编码解码器在更广泛的领域应用。

Special navigation computer based on DSP is designed,and it is used to collect the signal of gyros,accelerometers,magnetic heading sensor and velocity sensor,the Kalman filter is applied to multi-sensors data fusion,then the AHRS is built up.

设计了基于DSP的专用导航计算机，并以此为硬件平台，采集陀螺仪、加速度计、磁航向传感器和速度传感器信号，利用卡尔曼滤波技术进行多传感器信息融合，成功搭建了低成本小型航姿系统。

This paper presents a low-cost embedded real-time platform based on DSP and its applications in Coriolis mass flow rate meter,and proposes a different method to calculate mass flow rate,and analyzes tasks scheduling by embedded real-time system at the same time.

本文讲述了一种低成本的基于DSP的实时嵌入式开发平台的体系构成及其在科里奥利质量流量计中的应用，提出流体质量流量的不同计算方法，同时分析了嵌入式实时系统对任务的调度。

The precise time interval measurement with pulse counting is designed by using DSP controller. Using the technique of filter, it minished the measure outcome error of the interference of outside signal and the misuse of apparatus.

设计了基于DSP控制器的脉冲计数方式对时间进行精确测量，并采用滤波技术克服外界信号的干扰、仪器使用不当等因素对测量结果产生的误差。

High executing speed of DSP deals with the question of real time process, which minishes the controller loss.

利用DSP的高速执行速度实现了实时处理，并减少了功耗。

MAX1999EEI Pinout: 8- to 32-bit and 16- to 32-bit word packing options Programmable wait state options: 2 to 31 CCLK Digital audio interface includes six serial ports, two pre- cision clock generators, an input data port, three programmable timers and a signal routing unit Serial ports provide: Six dual data line serial ports that operate at up to 50 Mbits/s for a 200 MHz core on each data line each has a clock, frame sync, and two data lines that can be configured as either a receiver or transmitter pair Left-justified sample pair and I2S support, programmable direction for up to 24 simultaneous receive or transmit channels using two I2S compatible stereo devices per serial port TDM support for telecommunications interfaces including 128 TDM channel support for telephony interfaces such as H.100/H.110 Up to 12 TDM stream support, each with 128 channels per frame Companding selection on a per channel basis in TDM mode Input data port provides an additional input path to the DSP core configurable as either eight channels of I2S or serial data or as seven channels plus a single 20-bit wide syn- chronous parallel data acquisition port Supports receive audio channel data in I2S, left-justified sample pair, or right-justified mode Signal routing unit provides configurable and flexible connections between all DAI components, six serial ports, an input data port, two precision clock generators, three timers, 10 interrupts, six flag inputs, six flag outputs, and 20 SRU I/O pins Serial peripheral interface Master or slave serial boot through SPI Full-duplex operation Master-slave mode multimaster support Open drain outputs Programmable baud rates, clock polarities, and phases 3 Muxed Flag/IRQ lines 1 Muxed Flag/Timer expired line ROM based security features: JTAG access to memory permitted with a 64-bit key Protected memory regions that can be assigned to limit access under program control to sensitive code PLL has a wide variety of software and hardware multi- plier/divider ratios JTAG background telemetry for enhanced emulation features IEEE 1149.1 JTAG standard test access port and on-chip emulation Dual voltage: 3.3 V I/O, 1.2 V core Available in 136-ball BGA and 144-lead LQFP packages Lead free packages are also available

MAX1999EEI引脚说明： 8 - 32位和16 - 32位字包装选择可编程等待状态的选择：2至31个CCLK数字音频接口包括6个串行端口，两个前643时钟发生器，输入数据端口， 3可编程定时器和一个信号路由单元串行端口提供：六双串口数据线，在高达50 Mbps的操作/为200兆赫的每个数据行每个人都有一个时钟，帧同步的核心秒，和两个数据可以作为任何一个接收器或发射器对左对齐和I2S配对样本的支持下，最多可同时接收或传送24个频道，每使用两个系列的I2S兼容立体声设备配置可编程方向线；港口的TDM通信接口，包括支持128个电话接口的TDM的渠道，如H.100/H.110支持多达12个的TDM流的支持下，每帧128个频道每个压缩扩展每通道的基础上选择在TDM模式输入数据端口提供了一个额外的输入路径的DSP核心配置为I2S或串行数据或7加一个20位宽的SYN -异步的并行数据采集接口通道或8通道；支持接收通道I2S音频数据，左对齐样本对，或右对齐模式信号路由单元组件之间提供所有戴配置和灵活的连接，6个串行端口，一个输入数据端口，两个精密时钟发生器，3个定时器，10个中断，六旗投入，产出6个旗，20曼谷南南区域股的I / O管脚串行外设接口的硕士或奴隶通过SPI串行启动全双工运作主从模式多主机支持开漏输出可编程波特率，时钟极性和第三期合并调制旗/ IRQ线路1合并调制旗/定时器过期线光盘的防伪特征：JTAG的访问与64位受保护的关键允许内存内存可分配给程序访问控制的限制下对敏感地区有一个代码锁相环/遥测分比率为背景的JTAG仿真功能增强的IEEE 1149.1 JTAG标准测试访问端口的软件和硬件多钳各种各样和片上仿真双电压：3.3六/输出，可在1.2 V核心136球BGA封装和144引脚LQFP封装无铅封装，也可

TDA4864 Pinout: 8- to 32-bit and 16- to 32-bit word packing options Programmable wait state options: 2 to 31 CCLK Digital audio interface includes six serial ports, two pre- cision clock generators, an input data port, three programmable timers and a signal routing unit Serial ports provide: Six dual data line serial ports that operate at up to 50 Mbits/s for a 200 MHz core on each data line each has a clock, frame sync, and two data lines that can be configured as either a receiver or transmitter pair Left-justified sample pair and I2S support, programmable direction for up to 24 simultaneous receive or transmit channels using two I2S compatible stereo devices per serial port TDM support for telecommunications interfaces including 128 TDM channel support for telephony interfaces such as H.100/H.110 Up to 12 TDM stream support, each with 128 channels per frame Companding selection on a per channel basis in TDM mode Input data port provides an additional input path to the DSP core configurable as either eight channels of I2S or serial data or as seven channels plus a single 20-bit wide syn- chronous parallel data acquisition port Supports receive audio channel data in I2S, left-justified sample pair, or right-justified mode Signal routing unit provides configurable and flexible connections between all DAI components, six serial ports, an input data port, two precision clock generators, three timers, 10 interrupts, six flag inputs, six flag outputs, and 20 SRU I/O pins Serial peripheral interface Master or slave serial boot through SPI Full-duplex operation Master-slave mode multimaster support Open drain outputs Programmable baud rates, clock polarities, and phases 3 Muxed Flag/IRQ lines 1 Muxed Flag/Timer expired line ROM based security features: JTAG access to memory permitted with a 64-bit key Protected memory regions that can be assigned to limit access under program control to sensitive code PLL has a wide variety of software and hardware multi- plier/divider ratios JTAG background telemetry for enhanced emulation features IEEE 1149.1 JTAG standard test access port and on-chip emulation Dual voltage: 3.3 V I/O, 1.2 V core Available in 136-ball BGA and 144-lead LQFP packages Lead free packages are also available

TDA4864引脚说明： 8 - 32位和16 - 32位字包装选择可编程等待状态的选择：2至31个CCLK数字音频接口包括6个串行端口，两个前643时钟发生器，输入数据端口， 3可编程定时器和一个信号路由单元串行端口提供：六双串口数据线，在高达50 Mbps的操作/为200兆赫的每个数据行每个人都有一个时钟，帧同步的核心秒，和两个数据可以作为任何一个接收器或发射器对左对齐和I2S样本对支持，最多可同时接收或传送24个频道，每使用两个系列的I2S兼容立体声设备配置可编程方向线；港口的TDM通信接口，包括支持128个电话接口的TDM的渠道，如H.100/H.110支持多达12个的TDM流的支持下，每帧128个频道每个压缩扩展每通道的基础上选择在TDM模式输入数据端口提供了一个额外的输入路径的DSP核心配置为I2S或串行数据或7加一个20位宽的SYN -异步的并行数据采集接口通道或8通道；支持接收通道I2S音频数据，左对齐样本对，或右对齐模式信号路由单元组件之间提供所有戴配置和灵活的连接，6个串行端口，一个输入数据端口，两个精密时钟发生器，3个定时器，10个中断，六旗投入，产出6个旗，20曼谷南南区域股的I / O管脚串行外设接口的硕士或奴隶通过SPI串行启动全双工运作主从模式多主机支持开漏输出可编程波特率，时钟极性和第三期合并调制旗/ IRQ线路1合并调制旗/定时器过期线光盘的防伪特征：JTAG的访问与64位受保护的关键允许内存内存可分配给程序访问控制的限制下对敏感地区有一个代码锁相环/分比率背景遥测的JTAG仿真功能增强的IEEE 1149.1 JTAG标准测试访问端口软件和硬件多钳各种各样和片上仿真双电压：3.3六/输出，可在1.2 V核心136球BGA封装和144引脚LQFP封装无铅封装，也可

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸，那乌黑、忧郁的眼睛，她便会相信，他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失