查询词典 dry saltery

Effects of dry temperature and dry time on properties of heat cured sand and the relationship with binder composition are as follows:sands bonded by binders that are not modified have high strength when dry temperature is high and dry time is long,but their anti-wettability power is poor . Sands bonded by binders that are modified by B but not modified by M can be dried quickly and sand strength is high but anti-wettability power is also poor. Sands bonded by binders that are modified by M but not modified by B can also be dried quickly to obtain maximum strength,then the strength becomes lower when they are dried continually for more time. and sand strength is high but anti-wettability power is also poor. Sands bonded by binders that are modified by M as well as by B at the same time can be dried quickly to obtain maximum strength at low temperature and short time. But the anti-wettability of sand mold is best when they are dried at high temperature and long time.

烘干温度和烘干时间对热硬砂性能的影响及其与粘结剂改性的关系是：未经改性剂B和改性剂M改性的粘结剂砂，脱水速度较慢，烘干温度越高，时间越长，则硬化强度也越高，但未经改性的粘结剂热硬砂的抗吸湿性较差；经改性剂B而不经改性剂M改性的粘结剂热硬砂，烘干硬化速度较快，强度也高，但在高湿度下的抗吸湿性不好；经改性剂M改性而不经改性剂B改性的粘结剂热硬砂，烘干时强度先随烘干时间升高至最大值后，继续烘干时强度又出现下降；经改性剂B和经改性剂M共同改性的粘结剂热硬砂能在短时间和较低的烘干温度下就可烘干到最高强度，即烘干脱水的速度较快，但试样的抗吸湿性差，若在更高温度和更长时间下烘干，试样的抗吸湿性得到改善，综合考虑烘干强度和抗吸湿性要求，对于φ30×30mm试样，理想的烘干温度是200℃，烘干时间20分钟。

Therefore has carried on the next experiment: For the proof slip of paper dry scope migration is but because of receives the earth's attraction the influence to concentrate toward the slip of paper lower part, we have carried on the next experiment, we cut the slip of paper the long strip, then changes the level laying aside, because whether there is can't such slip of paper both sides underneath the space cause the hydro energy downward to concentrate create the experimental result the difference, after the experiment discovered, after has removed this difference, the slip of paper both sides dry need the time is nearly same, but according to above experiment, we arrived following conclusion, the slip of paper dry scope is downward moved from on downward migration because of the slip of paper in moisture content by the attraction attraction, causes under the slip of paperAbove the hydraulic modulus also must be many, above the natural slip of paper falls very quickly on the few water on the evaporation, but under many moisture content need more time can evaporate, causes the slip of paper dry scope most above downward to increase slowly from the slip of paper.

急！！！物理翻译中翻英请帮帮忙於是进行了下一个实验：为了证明纸片〈paper sheet〉乾燥范围的移动〈boundary of drying〉是因为受到地心引力的影响而往纸片下部集中，我们又进行了下一个实验，我们把纸片剪成长条状，然后改为水平放置，这样纸片两端就不会因下方有无空间使水能往下集中而造成实验结果的差异，实验后发现，去除了这个差异后，纸片两端乾燥所需的时间几乎相同，根据以上的实验，我们的到了以下的结论，纸片乾燥范围从上往下移动是因为纸片中的水分被引力吸引而往下移动，使得纸片下面的水比上面还要多，自然纸片上面就少量的水很快就蒸发掉，而下面较多的水分需要更多的时间才能蒸发完，使得纸片乾燥的范围从纸片最上面慢慢往下增加。

Rw is dry as a kind of new dry technology, applied infra-red radiant characteristic, have facility the character such as color of simple, product and nutrition changes the good point with high utilization rate of little, energy, agree with heat quick sex is mixed by force what cannot use the oar body stock with dry sparge is dry.

梗概： 本文综述了rw薄层干燥技术及其探究进展。rw干燥作为一种新的干燥技术，运用了红外辐射的特征，具有设备简单、产品颜色和营养等品质变化少、能源利用率高的优点，适合于热敏性强和不能采用喷雾干燥的浆体物料的干燥。

From late mid-Pleistocence to Holecence, KunMing Basin has gone through follow process: cool and dry to warm and subhumid to warm and dry to moderate and dry to cool and wet to warm and subhumid to warm and dry.

从更新世中期后期至全新世本区气候经历了凉干—温暖半湿润—温暖偏干—温和偏干—温凉湿润—温暖半湿润—温暖偏干的逐渐过渡的过程。

Because of the regional difference of soil and climatic conditions, the division of 4 stages of soil moisture circulation is not all the same between different areas; the soil moisture dynamics between different dry farming areas in the Yellow River Basin is contrasted in this report. The results indicate that soil moisture increases gradually from dry semi-arid area to semi-arid area, dry semi-humid area and semi-humid area, and the high value district generally appears during soil moisture resuming period in rainy season or soil melting period. While the low value district appears at the stage of fast evaporation in spring or slow evaporation in autumn; in views of vertical changes of soil moisture, it is showed that the variation range of upper lays is larger than that of lower among the different dry farming areas in the Yellow River Basin.

由于各区域之间土壤、气候条件的差异，各地土壤水分循环4个阶段的划分也不尽相同；黄河流域不同旱作类型区土壤水分动态变化比较结果表明：就季节变化而言(来源：A70b0B0bC论文网www.abclunwen.com)，由半干旱偏旱区→半干旱区→半湿润偏旱区→半湿润区土壤水分含量呈逐渐增加的变化趋势，而且高值区一般出现在雨季恢复阶段或春季土壤融冻返浆时期；而低值区均出现在春季大量蒸发阶段或秋季缓慢蒸发阶段；就垂直变化而言，黄河流域不同旱作类型区土壤水分垂直变化的趋势均表现为上层变化幅度较下层大。

Limestone does technology of to decoke of law flue gas partly is a kind " work / wet / dry " technology of half dry to decoke, have at the same time wet the advantage with dry method to decoke, namely the reaction process inside desulphurization tower is wet condition, and reaction by-product is dry state.

石灰石半干法烟气脱硫技术是一种&干/湿/干&的半干脱硫技术，同时具有湿法和干法脱硫的优点，即脱硫塔内的反应过程是湿态的，而反应副产物是干态的。

Our main products are: dry candied apple, candied strawberry dry, dry candied kiwi, dried candied pears, dry peach prolyl a dozen varieties, variety, quality assurance, to achieve an annual production capacity of around 1500 tons, and the Company's technical staff are devote themselves to research and development of new products, market demand in order to protect and enhance enterprise competitiveness.

公司主要产品有：干燥苹果脯，干燥草莓脯，干燥猕猴桃脯，干燥梨脯，干燥桃脯等十几个品种，品种齐全，质量保证，年生产能力达到1500吨左右，且本公司技术人员正在潜心研发新产品，以保障市场的需求，增强企业竞争能力。

HX-A smear-dry kiln HX-B level and straight plate dry kiln HX-C single hanging slice plate dry kiln HX-C double hanging slices plate dry kiln (Practical new type patent number: 012448788) HK-P market stove HX-Q extreme flock welder HX-G solidified room The energy used by the above equipment could be adapted according to customer's demand: Gas, fuel oil, electric heat and steam electric heat and so on.

HX-A 涂片干燥窑 HX-B平置式极板干燥窑 HX-C单挂片极板干燥窑 HX-C双挂片极板干燥窑（实用新型专利号：012448788） HK-P熔铅炉 HX-Q极群焊接机 HX-G固化室上述设备使用的能源可根据用户要求采用：燃气、燃油、电热和蒸汽加电热等。

Model GFM-1B dry powder filler is a new product developed by our factory after absorbing the advantages of powder fillers at home and abroad. It can quickly suck dry powder into the cylinder and be directly filled in the cylinder of the extinguisher to be filled by vacuum fluidics; the dry powder can also be directly sucked into the cylinder of the extinguisher to be filled through the filling and cover. It can directly recover the dry powder in the cylinder of the old extinguisher.

GFM16-1B型干粉灌装机是我厂参照国内外粉类灌装机的优点，设计开发的新产品，本机采用真空射流技术，将干粉快速吸入贮粉筒并直接灌入被装灭火器筒体内；也可将干粉通过灌装端盖直接吸入被装灭火器筒体内，并能把旧灭火器筒体内的干粉直接回收。

The design of the dry-dock falling gate"s structure is researched, and integrates the disquisitions and analysis on the dynamic characteristics about dock gate, in order to make the cabin design more visualizing.(2) The emphasis of this paper is the influence of the water hole and gas hole in the tidal cabin and the influence of the drain of the air-operated cabin.(3) In this paper, the building method of the dry-dock falling gate"s parametric model is studied and the dynamic analysis is accomplished in ADAMS, furthermore, the rising-and-falling angle curve is drawn while the dry dock gate is rising and falling.(4) The paper is based on the apprehension of the past theories and researches about air-operated dry-dock falling gate, and is explicated by hydraulic rationales and rising-and-falling mechanical principles. This software is developed by inner programming language in ADAMS and VC. This design could shorten design cycle.

1研究了气控式干船坞卧倒门的结构设计，整合对卧倒门在海水中运动中的动力特性研究，使卧倒门的设计，特别使其舱格设计更具可视化；(2)重点讨论潮汐舱水孔气孔对卧倒门水上运动的影响，空气操作舱充排水对卧倒门运动的影响；(3)研究了气控式干船坞卧倒门仿真模型的参数化方法和过程，并在ADAMS中完成了系统的动力学分析，绘制出了卧倒门在起卧过程中的运动特性曲线；(4)通过对已有的气控式干船坞卧倒门的实验成果和成形理论的解读，在理解其起浮和卧倒机理基础上，应用VC和ADAMS二次开发语言进行设计软件开发，定制了友好的用户化中文人机交互界面，使设计人员可以方便快捷地对卧倒门门进行设计开发，缩短了设计周期。

The work of this paper is as follows: 1. Looking back the progressing history of the linear motor, introducing the features of the elevator driven by linear induction motor, radicating the topic of this paper "the digital frequency variable control of the elevator bi-side direct driven by linear induction motor". The research of this paper covers the conventional VVVF control, space vector based VVVF control, vector control and DTC.

本文主要开展了以下几个方面的工作： 1 回顾了直线电机发展历史，电机的驱动技术演变，特别是针对直线电机的驱动，简要介绍了直线感应电机驱动电梯的优点和不同结构类型，对传统的v／f控制，基于空间矢量法的v／f控制，矢量控制，和基于电压空间矢量的直接转矩控制进行了比较，确立了本课题的研究主题：直线感应电机双边直推式驱动电梯的全数字变频控制。

The article combines with the treatment of a superficial civil air defense work to introduce how the grouting method to improve the performance of the backfill soil.

文章从治理漂浮人防工事的角度提出了注浆技术在改善回填土性质方面的应用，并详细阐述了注浆技术的施工流程。