英语人>网络例句>drum feed 相关的网络例句
drum feed相关的网络例句

查询词典 drum feed

与 drum feed 相关的网络例句 [注:此内容来源于网络,仅供参考]

This text is by way of analyzing the big needle drum system of cigarette equipment PASSIM's cigarette machine studying YuXi cigarette factory 20th century the nineties import, analyses studying finding shortcoming owing to the congenital design of this system, again many years is r-und to wear and tear, and many questions of PASSIM 12K feed container system are created, it is slow like responds and the lag and leather belt slip and supplies thread uneven.

本文通过分析研究玉溪卷烟厂二十世纪九十年代进口的卷烟设备PASSIM卷烟机大针鼓系统,分析研究发现由于大针鼓系统先天设计的不足,加上多年运行磨损,造成PASSIM 12K料斗系统诸多问题,如响应慢、滞后、皮带打滑、供丝不均匀等。

An SLon pilot continuous centrifugal concentrator (SLon pilot centrifugal concentrator) was used to study the effects of drum rotation speed and reciprocating velocity of water sprays on the separation performance of the concentrator under the optimum conditions of feed volume flow rate (24.5±0.4) L/min, feed solids content 20% and impacting pressure of water sprays 0.45 MPa, with the high gradient magnetic separation concentrate assaying 52.42% Fe from fine hematite tailings as test material.

摘 要:采用SLon实验型连续式离心机(简称SLon实验型离心机),以高梯度磁选细粒赤铁矿尾矿得到的磁性产物(52.42% Fe)为试样,在给料体积速率为(24.5±0.4) L/min、给料固体浓度为20%和水束流冲击压力为0.45 MPa的条件下,研究转鼓转速和水束流往复速度对连续离心分离指标的影响。

Lo models with a horizontal mixer, biaxial pulp of the mixer, Central touch granulators, [250, 320, 350], water droplets grinder, mixer drum additives,(SR-enrichment Material equipment), bucket elevator, U-cutter-type carrier, there are die-pellet feed and other 30 kinds of ancillary equipment.

机型有卧式螺带混合机、双轴浆叶混合机、环摸制粒机、[有250型、320型、350型]、水滴粉碎机、鼓式添加剂混合机、、斗式提升机、U型输送绞龙、还有平模制粒机等30多种饲料配套设备。

Additional reading delay—once dosing of the dribble feed drum has been completed and before the reading are taken, that unit has to wait for all the product in the air to fall into the drum, once the weight is stable the machine waits for this time before reading the finished weight.

附加的阅读延迟—一次配那流口水饲养鼓已经被完成和在阅读之前被拿,那一个单位必须等候空气的所有产品掉入鼓,一次重量是赶入马房里机器这次在读完成的重量之前等候。

Additional reading delay--once dosing of the dribble feed drum has been completed and before the readings are taken,that unit has to wait for all the product in the air to fall into the drum .once the weight is stable the machine waits for this time before reading the finished weight.

另外的阅读延迟--一次配那流口水饲养鼓已经被完成而且在阅读之前被采取,那一个单位必须等候在空气中的所有产品掉入鼓。一经重量是赶入马房里机器在读完成的重量之前等候这次。

Additional reading delay—once dosing of the dribble feed drum has been completed and before the reading are taken, that unit has to wait for all the product in the air to fall into the drum, once the weight is stable the machine waits for this time before reading the finished weight.

另外的阅读延迟-一次配那流口水饲养鼓已经被完成而且在阅读之前被采取,那一个单位必须等候在空气中的所有产品掉入鼓,一经重量是赶入马房里机器在读完成的重量之前等候这次。

Material is put into the drum from the feed end, then transported by blades from bottom to top of the drum, during which it is firstly separated, then combined, which continuously and repeatedly happen in a compound cycle.

物料在搅拌筒进料端起,在搅拌叶片的作用下随着搅拌筒从下部传递到上部,连续反复交替分散、合并形成复合循环的均匀混合并不断往出料端推进,达到快速连续混合

The body has drum mixed with four leaves, stirring with a good performance out of the concrete mix to make a more uniform 2: mixed leaves on a mixed open hole to raise the quality of concrete mixing; 3 ----- sealed tube was funnel shape, Large caliber to ensure a smooth feed: 4: Lo leaves were added to the top surface wear protection, to extend the service life of the leaves, 5 leaves on a few large rectangle-shaped hole and the hole in the concrete to reduce the adhesion of the leaves; 6 : Mixing cylinder B520JJ optional alloy steel materials, wear resistant materials; 7 from the first block plate spinning, 8: ZG35 stirring drum track using the material, casting molding.

筒体内有四块拌叶、具有良好的搅拌性能,使拌出的混凝土更加均匀2:拌叶上开有拌孔能提高混凝土搅拌质量;3密封管-----呈漏斗形状,口径大能确保顺利进料:4:螺叶片呈曲面顶端加防护耐磨条,延长叶片使用寿命,5叶片上有几个圆孔及长方钜形孔减少混凝土在叶片上的粘附; 6:搅拌筒体材料选用B520JJ合金钢、抗耐磨材质;7封头由整块钢板旋压成型,8:搅拌筒轨道采用ZG35材质,经铸造成型。9:搅拌筒壳体各部件由高强度及高耐磨材质制作而成。10:搅拌筒整体焊接采用自动埋弧焊技术。

Using a drum Cr18Ni9Ti furnace tank made of stainless steel cylinder, or a Cr-Mn nitrogen heat-resistant steel castings, by the end of the furnace body, bearing bearing supports, and with a motor-reducer for use furnace tank to the slow rotation, with drum parts Rotation of the tank furnace heated evenly, and the workpiece between each other without coverage phenomenon, the same color after heat treatment furnace can feed the other end to the mouth from two roller bearing.

滚筒炉罐采用1Cr18Ni9Ti不锈钢制成圆柱型,或采用铬锰氮耐热钢铸件,一端由轴承支座在炉体外支承,并采用电动机带减速机进行传用,使炉罐缓慢旋转,工件随滚筒炉罐旋转使之受热均匀,并且工件互相之间无复盖现象,热处理后色泽一致,炉罐另一端为进料口,由二只滚轮支承。

The system uses PID controller and fuzzy controller to design automatic control loops, a study of fuzzy three-element feed-water control system for a CFB municipal waste incinerator is introduced. The incinerator is faced with problems such as large-scale fluctuation of furnace heat load and low regulation resolution of main control feed-water valve. The fuzzy logic control system is applied to modulate PI control parameters according to steam drum water level to fit fluctuated heat load, the inner and outer control loops are realized in an asynchronous way to effectively decrease regulation time and improve regulation precision.

针对垃圾炉炉膛负荷波动较大,同时给水调节阀门执行机构的调节精度较低的现状,在传统三冲量串级汽包水位控制方式的基础上,采用模糊控制策略对内、外串级回路的PI控制参数进行分区域调整,强调了PI参数在被控参量处于不同范围时的分离作用,同时内、外控制回路采用异步控制方式,浙江大学硕士学位论文从而有效地减小了被控参量的调节时间,提高调节精度,使水位波动控制在△为士12~范围内。

第2/3页 首页 < 1 2 3 > 尾页
推荐网络例句

The concept of equivalent rotationally rigidity is offered and the formula of rotationally rigidity is obtained.

主要做了如下几个方面的工作:对伸臂位于顶部的单层框架—筒体模型进行分析,提出了等效转动约束的概念和转动约束刚度的表达式。

Male cats normally do not need aftercare with the exception of the night after the anesthetic.

男猫通常不需要善后除了晚上的麻醉。

Its advantage is that it can be used in smaller units.

其优点在于可以在较小的单位中应用。