查询词典 distance

When described as a distance of an arc on the engagement pitch circle, it is called "Circumference Direction Backlash", when described as the shortest distance between two opposing tooth surfaces is called "Normal Line Backlash".

当描述为齿间弧度距离时，也叫做"圆周向回程间隙"。当描述为两啮合面的最短距离时，也称作"常规线性回程间隙"。

By Visual Basic 6.0 program, taken the distance between hole 200mm and buried depth 120～150mm as the optimization goal, the most optimum parameters range of the mechanism was obtained as follows: the initial angle between planet frame and the line formed from spraying-fertilizer needle-tip and planet wheel axle was -45°～-40°, the initial angular displacement of planet frame was 40°～50°, the distance between spraying-fertilizer needle-tip and the planetary gear axle center was 280～300mm, simultaneously, the semi-major axis of elliptic gear was 29.364mm, the teeth quantity was 23, the ratio of semi-minor axes and semi-major axis was 0.958, the radius of circular gear was 25mm.

对该机构进行运动学分析，建立了数学模型，以穴距200mm和入土深度120～150mm为寻优目标，应用Visual Basic 6.0软件编程得出满足机构运动要求的最优参数范围为：喷肥针尖和行星轮轴连线与行星架的初始夹角-45°～-40°、行星架初始角位移40°～50°、喷肥针尖与行星轮轴心距离280～300mm，此时椭圆齿轮长半轴29.364mm、齿数23、短半轴与长半轴比0.958，正圆齿轮半径25mm。

Firstly, the soil samples are gathered from the same section such as surface layer soil samples gathered from 0cm to 15cm depth and representation on studied object. Secondly, the precondition of tested samples must be the same. This study indicates that the tested samples must be 1mm diameter, over-dried at 40℃ for 24h and airtight cooling for 24h before measured for air-dry samples, and softly planish the surface at measuring. Lastly, the illuminating condition of light must be the same. This study indicates that the testing geometric condition are light source angle 15°, light source distance 30cm and sensor distance 15cm for soil hyperspectra indoor. The surface of white reference must be the same plane of that of sample.

第一个环节的"相同"是指田间土壤样品采集时的剖面位置一致，如表层土都采集0～15cm深度范围内的土壤，且所采集的样品应能尽量具备研究对象的代表性；第二个环节的"相同"是指土壤制备过程中的一些前处理条件应一致，建议土壤光谱测试样品的粒径1mm，风干土壤样品测试前在40℃恒温条件下烘24小时，然后密闭冷却24小时，测试时土壤表面进行稍稍压平处理；第三个环节的"相同"是保证测试光照条件的一致性，建议在50W卤素灯、8°探头角条件下，采用15°的光源照角度、30cm的光源距离和15cm作为室内士壤高光谱测试几何条件，测试时除遵循光谱测试指南的要求外，还须保证参考板表面与测试土壤样品的表面在同一平面上。

By taking the noise of an infrared focal plane detector as the main factor, an operating distance estimation equation for point targets is derived. A calculation example of the operating distance of a typical infrared detection system is given.

本文推导了以红外焦平面探测器噪声为主要因素的点目标红外探测系统的作用距离估算方程，结合实例求解了典型红外探测系统的探测系统的作用距离。

The results show, when polar distance is bigger than the size of cross section of tunnel, the difference of anomalous feature between the corner-sections and wall-sections in tunnel is very small. The apparent resistivity is only related to the distance between section and bodies. The shielding effect of the tunnel is not so evident that the character and value of anomalous are similar with those in full space.

计算结果表明，当坑道内偶极测深的极距大于坑道截面尺寸时，坑道角与坑道面断面异常形态差异不大；视电阻率值只与断面和地质体间的距离有关；坑道空腔的屏蔽效应并不明显，坑道内各个测深断面的异常幅值和形态与全空间中观测结果非常相似。

Distributing control point used of straight closed traverse and using of distance measurement polar coordinates and near distance high degree level measuring method to do deformation measuring for the plugging water curtain wall.

用直伸闭合导线布设控制点，以测距极坐标和近距高等级水准测量方法对堵水帷幕墙进行变形测量，有利于提高观测精度，能消除横向误差对监测点位精度的影响，精度及效果较

The distance of preference relation based on lattice order is defined, and the distance between binary relations are calculated.

针对决策者具有格序偏好结构的群决策问题，提出了一种基于偏好距离测度的群决策方法。

The parameters are :① reservoir effective thickness;② reservoir porosity;③ reservoir volume efficiency;④ fair pay ′ s reservoir volume efficiency;⑤ distance to the fault;⑥ reciprocal of the square root of the distance to the fault ）;⑦ apparent fold strength coefficient;⑧ maximum principal curvature of structural plane;⑨ transversal section line curvature;and ⑩ longitudinal section line curvature.

摘 要 介绍了气井产能的确定方法及地质参数的选择与计算方法：采用初始二项式无阻流量、稳定产量及初始采气指数作为气井产能评价的指标；10项参数分别是①储层有效厚度；②储层孔隙度；③储容系数；④好储层的储容系数；⑤与断层的距离；⑥与断层距离开方的倒数；⑦视褶皱强度系数；⑧构造面最大主曲率；⑨横向剖面线曲率；⑩纵向剖面线曲率。

The sealant dispenser includes a stage on which a substrate is mounted; a nozzle for dispensing a sealant while making a relative motion with the substrate; a syringe coupled to the nozzle, for storing the sealant; and a distance sensor installed on both sides of a lower portion of the syringe, for measuring a vertical distance between a principal plane of the substrate and an outlet of the nozzle.

密封剂配送器包括其上可安装基板的工作台；用于在相对基板移动的同时配送密封剂的喷嘴；与喷嘴耦合，用于存储密封剂的注射器；和距离传感器，安装在注射器的下部的两侧，用于测量基板的主平面和喷嘴的出口之间的垂直距离。

The following values was measured: angle of cusp line between the second and third molar, impact state and depth, distance from Rickett's Xi to distal cusp of third mandibular molar along the occlusal plane, anterior border of ramus to the third mandibular molar, distance from projection of distal contact point of maxillary third molar to intersection of pterygoid vertical on occlusal plane.The change between pre-and post-treatment was calculated and analyzed with SPSS10.0 software package.α angle, Xi-LTM, R-LTM, R-LTM were tested with independent-sample t test, impact state and depth was tested with Chi-square test. Influence of age on the values was also evaluated.

测量治疗前后的第二、第三磨牙牙尖连线角度、阻生状态和深度，Rickett's Xi点到下颌第三磨牙远中尖距离、下颌支前缘到第三磨牙远中尖距离、翼上颌裂切线到上颌第三磨牙后缘的距离及上、下磨牙的前移量，计算治疗前后各变量的差值，采用SPSS10.0软件包进行统计学分析，α角、Xi-LTM、R-LTM、R-LTM用t检验，阻生状态和深度用χ^2检验，比较年龄因素对各指标的影响。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。