查询词典 disk size

Both upper and lower dental study models were collected from 30 boys (12 years old) and 30 girls (12 years old) with acceptable normal occlusion to understand the characteristics of the crown size, dental arch width and length such as (1) mesiodistal diameters of crown size from central incisor to first molar,(2) the width and length of dental arch and basal arch and (3) the morphology of dental arch form. After statistical analysis, data were compared with Japanese, Central and South American Indians and North American Caucasians from papers. The results were:(1) There was no statistical difference in teeth size between males and females, except the upper first molar of males was larger than that of females, lower central incisor of males was smaller than that of females.(2) The dimensions of dental arch of males were larger than that of females in general, especially such items as width and length of basal arch.(3) The crown size of Chinese male was in generally smaller than that of four other races, especially the upper canine, lower central incisor and first molar.

为了解住在台湾的中国人其牙齿的大小，齿列弓幅径及形态，为齿科人类学上的特微，以期能对儿童牙科，齿颚矫正科之临床及齿科基础医学能有所贡献，抽取12岁学童男女各30名共60名，可接受为正常咬合之上下颚齿列模型，测量其上下颚(1)左侧正中门牙到第一大臼齿共计12颗恒牙之牙冠近远心径，(2)齿列弓宽径、长径及齿槽基底宽径、长径，(3)齿列弓之形态，以上资料经统计分析作t-test检定，并与诸学者对日本人、北美白人、中美及南美印第安人人种的研究结果作检讨得知；(1)男女性恒牙的近远心径无明显差异，但男性上颚第大臼齿比女性者大，下颚正中门牙比女性者小；(2)男性的齿列弓幅径比女性者为大，尤以齿槽基底宽径及长径最显著；(3)国人男子的牙齿近远心径比其他四人种者为小，特别是国人的上颚犬齿，下颚正中门牙及第一大臼齿最小。

The fixed assets are 78 million Yuan. The main equipment for mould is imported from abroad such as: Three coordinate numerical control milling machine imported from Japan, on set; large type the five coordinate milling machine typed dragon imported from Spain, sise (4000 x 2500), one set; three coordinate numerical control processing center size (2000 x 1000) imported from Spain, one set; powerful numerical control milling machine typed dragon imported from Taiwan, size (3200 x 2540), one set; five coordinate milling machine typed with five drift link movement imported from Italy, size (4000 x 2500), one set; Five faces numerical control milling machine HVM502T typed dragon imported from Taiwan, one set; numerical control scanning measuring machine imported from America size (5000 x 2438 x l824), one set. Others sophisticated equipment are made in China, such as numerical control cutting machine, planer typed dragon, pressing machine for research, total 16 set; advanced computer graphical working station, total 40 sets. The automobile cover has become into advantage, which is supplied various auto. Cover mould and cool Press mould to many big factories, such as: Jinan Auto. Manufacturing General Factory, Beijing Light-duty Auto. Manufacture Co., Changhe Auto. Manufacturing Factory, Shandonq Bulldozed General Factory, Jinan Diesel Factory, Qongdao Sifang Locomotive Factory, Dongfeng Auto.

该厂现有固定资产7800万元，用于模具制造的有日本引进的数控三座标铣床一台，西班牙引进的大型五坐标龙门仿形铣床一台（4000*2500），三座标数控加工中心一台（2000*1000），从台湾引进的强力数控龙门铣床一台（32O0*2540），从意大利引进的五轴联动五座标龙门铣床一台（4000*2500），从台湾引进五面体数控龙门铣床HVM502T一台，从美国引进的数控扫描测量机一台（5000*2438*1824）以及国产联高精尖的数控切割机，龙门刨床、研配压床等大型设备 I6 台套，高档计算机图形工作站40多台，在模具制造方面已形成制造汽车覆盖件模具的优势，产品质量达到国内先进水平，多年来为济南汽车制造总厂、北京轻型汽车制造有限公司，昌河汽车制造厂、山东推土机总厂、济南柴油机厂、青岛四方机车厂、东风汽车公司等大型骨干企业的产品更新换代生产制造了各种类型的覆盖件模具及冷冲模具，受到用户的好评，并建立了较稳定的供需关系。

It can be seen that the size of the microgels is around 50～60 nm in diameter in the solid state,and the microgels exhibit a narrow size distribution with an average diameter of around 100 nm in the wet state.2.Pore size and morphology of hydrogelThe SEM images of freeze-dried hydrogels exhibited a highly macroporous spongelike structure and the average mesh size is about 10μm.

孔径通过扫描电子显微镜可以看到凝胶内部呈现多孔的类似海绵内部的结构，孔径在10μm左右，浸泡24h后可以发现网络结构发生了降解，孔径变大，达到20μm左右，浸泡7d后凝胶进一步降解，孔径增大到40～50μm.3。

These categories of production is based on open folios (32-and 16-open) size, each making 3 ~ 4 block 5-10 mm long thick wooden planks and boards, is less than 8 mm in size 6-38, the size, width is less than 10 ~ 20mm's format and size.

这几类压不活的制息是根据闭不梢（32闭和16闭）不小小，每类制息3～4块5～10mm薄的木不活，不幼小于闭不梢尺寸6～8mm，阔小于闭不梢尺寸10～20mm。

The results indicate that the mass size distribution of fly-ash particles in the inlet of the WFGD system is typically disturbed bimodally, the peaks are approximate at 1 and 3 μm. And the shape of particles is regular sphericity, the mass ratio of PM2.5 to PM10 is about 0.434. The total mass concentration is about 85 mg/m3. In the outlet of the WFGD system, the mass size distribution of fly-ash particles is also bimodal. The proportion of fine particles increased, the mass ratio of PM2.5 to PM10 is about 0.764. Some fine particles are conglutinated and formed irregular agglomerate. The total mass concentration is under 23 mg/m3, the removal efficiency of total particles is 74.5%. The size removal efficiency is decreased observably with the range of particle size decreasing.

结果表明，WFGD系统入口飞灰质量粒径呈典型的双峰分布，峰值分别在1和3 mm处，颗粒多呈规则球形，PM2.5与PM10质量比为0.434，飞灰总浓度约为85 mg/m3标准状态；出口处飞灰质量粒径分布也呈现双峰性，其中细颗粒比例增大，PM2.5与PM10质量比为0.764，细颗粒间相互聚集粘连形成不规则的块状结构，飞灰总浓度在23 mg/m3以下，总飞灰的脱除效率为74.5%，分级脱除效率随粒径减小而明显下降。

As the same section is concerned, near the bottom the maximum value of frequency appear within 1mm of bubble size, towards the water face this value tend to decrease, yet the corresponding size turns to increase; in the same time, the frequency is concentrated near the bottom and deconcentrated near the water face; under the experiment condition, the maximum frequency of the total section approximately appear at 0.5mm size; mean bubble size access 0 at bottom and increase acceleratively towards water face where tend to be infinite; total number increase during developing of aeration, and become steady when reach wholly developed area; on the same section, the total number in unit time tend to increase at first and decrease then, along the water depth.

对于同一断面，靠近槽底的测点气泡个数分布最大值出现在气泡尺寸小于1mm的范围内，朝水面方向各测点气泡个数分布最大值呈减小趋势，而其对应尺寸则呈现变大趋势；在靠近槽底，个数分布表现得比较集中，而在水面附近气泡个数分布曲线表现得低而平缓；实验条件下，整个断面上的气泡个数分布的最大值大体上出现在尺寸为0.5mm的地方；气泡平均尺寸在槽底处接近于0而朝水面方向迅速增大，且越接近掺气水流的水面，增加速度越快，最终趋于无穷大；气泡总数在掺气发展区内是沿程增加的，当掺气水流发展到一定程度后气泡总数就基本保持不变了；在同一断面上，各测点单位时间内的气泡总数随高度呈现出先增加后减小的趋势。

Please look at the legend layout page, you may discover several size, maximum size is not in cut-paper size, this size indicates that each was given by the 印张 of the page area all paper.

请你看看规划页的图例，你可发现到几个尺寸，最大的尺寸是未裁切的纸张尺寸，此尺寸表示在印张上给予每个书页的所有纸张面积。

Please look at the legend layout page, you may discover several size, maximum size is not in cut-paper size, this size indicates that each was given by the 印张 of the page area all paper.

请你看看筹办页的图例，你可发掘到几个尺寸，最不小的尺寸是未裁切的纸弛尺寸，此尺寸表现在印弛上赐与每个册页的所有纸弛面积。

Afterreflections on the long history of size effect studies, attention isfocused on three main types of size effects, namely the statistical sizeeffect due to randomness of strength, the energy release size effect,and the possible size effect due to fractality of fracture ormicrocracks.

在回顾了尺寸效应研究的悠远发展史以后，着重讨论了三种主要类型的尺寸效应，即由于强度随机性引起的统计尺寸效应、能量释放的尺寸效应和由于微裂纹或断裂的分形特性可能引起的尺寸效应。

The effects of such parameters as temperature, pH, feeding rate,concentration, [NH_3]_T/_T molar ratio, surfactants and agitation, on the morphology and size of the particles, were studied and conclusions obtained are as follows:(1) The morphology and size of the particles are mainly decided by the species of nickel oxalates present.(2) Speeding up dissolution-recrystallization process benefits the preparation of the particles of being composed of a single species with uniform morphology and high aspect ratio.(3) The variations of nucleation and growth supersaturation under different conditions have definite effects on the morphology and size of the particles.(4) Adding PVP25 at a proper amount is beneficial to the preparation of fibrous nickel oxalate particles with high aspect ratio. 3 The formation mechanism as well as the morphology and size control of fibrous cobalt oxalate particlesThe cobalt oxalate particles with fibre morphology were prepared using CoCl_2 solution and mixed(NH_4)_2C_2O_4, NH_3·H_2O solution by a double jet process.

研究了温度、pH值、加料速度、浓度、[NH_3]_T/_T摩尔比、表面活性剂及其添加量、搅拌等对颗粒形貌与粒度的影响，主要结论为：(1)草酸镍化合物种类是决定颗粒形貌与粒度的最主要因素；(2)提高陈化中溶解—再结晶速度，有利于得到物相单一，形貌规整，轴向比大的粉末；(3)不同条件下，颗粒形核与生长过饱和度改变，也会对粉末形貌与粒度产生一定影响；(4)适量添加PVP25有利于大轴向比纤维状草酸镍的制备。3纤维状草酸钴的形成机理及其形貌与粒度控制采用CoCl_2溶液与(NH_4)_2C_2O_4和NH_3·H_2O混合溶液并流加料合成的方法，研究了纤维状草酸钴的制备。

Although translator has turned from being a crystal ball by which the original culture can unrestrainedly penetrate to another crystal ball by which the target culture can freely traverse, the translator's personal embodiment, in the process of cognitive act, are still absent in translation studies. Translators are still subjects without body or simply disembodied subjects.

译者虽然由原语文化可以自由穿透的玻璃球变成了译语文化可以自由穿越的玻璃球，但译者认知过程中的个体体验在翻译研究中依然缺席，译者依然仅仅是一个没有躯体体验的主体。

Chillingly, he claimed our technology is 'not nearly as sophisticated' as theirs and "had they been hostile", he warned 'we would be been gone by now'.

令人毛骨悚然的，他声称我们的技术是'并不那么复杂，像他们一样，和"如果他们敌意"，他警告说，'我们将现在已经过去了。