查询词典 dip into

II: ① take a thin wire, one end with sand paper wipe, and then lightson alcohol to non-yellow flame ignition,② wire with the end of the water dip, and then dip a number of sodium chloride or anhydrous sodium carbonate powder,③ ignited a new spirit lamp (lamp wick is clean, pure ethanol),④ the stained sodium salt powder on the wire on the ignitiontip, when there is a sharpsmall yellow flame, which is sodium flame.

方法二：①取一条细铁丝，一端用砂纸擦净，再在酒精灯外焰上灼烧至无黄色火焰，②用该端铁丝沾一下水，再沾一些氯化钠或无水碳酸钠粉末，③点燃一盏新的酒精灯，④把沾有钠盐粉末的铁丝放在外焰尖上灼烧，这时外焰尖上有一个小的黄色火焰，那就是钠焰。

The research results indicate that (1) fault-failure-type water inrush occurs more often than floor-failure-type water inrush under the existence of normal fault;(2) the influence of fault step and dip angle on the feature and position of water inrush is not evident, and water inrush may occur at both coal layer and the floor near working face;(3) the distance of coal column for preventing water inrush should be increased with the increase of fault step and dip angle.

得出以下结论：(1)当存在正断层时，多发生断层破坏型突水，而底板破坏型突水发生的几率较小；(2)突水性质和突水发生位置受断层断距和倾角的影响不大，煤层和采煤工作面附近的底板围岩都可能成为突水涌出点；(3)随着断层断距和倾角的增加，防水煤柱的合理留设距离应随之增大。

The results of quantitative coding to wavelet transform coefficient show that low-scale extreme wavelet coefficients can accurately localize the subaerial position of fractures.The shifting of extreme wavelet coefficients can be used to judge relative magnitude of dip angle and dip direction of fracture with scale increasing.The value of extreme wavelet coefficients can reflect density difference of formations on both sides of fracture and provide information of physical properties for fracture analysis.

小波变换系数量化编码结果表明，低尺度小波系数极值可以准确定位断裂在地表的位置；随着尺度的增加，小波系数极值会发生偏移，可以判断断裂的倾向和倾角的相对大小；小波系数极值可以反映断裂两侧地层的密度差异，为断裂分析提供物性信息。

Please note this syncline is of incline d axial plane which has the same dip direction as the limb with gentle dip angle.

请注意，这个向斜构造的轴面是倾斜的，轴面的倾向与具有较缓一翼岩层的倾向一致。

The occurrence of the granites in the Foping and vicinity correlates closely with those ductile-brittle shearing zones. The granite bodies are elongate in shape and distribute parellel to the shearing zones with high dip angles, and are plane in shape and emplace along the shearing zones with low dip angles, displaying syntectonic feature.

佛坪及其邻近地区发育的花岗岩体与这些韧性--脆韧性剪切带有密切的空间关系，即在近直立剪切带附近花岗岩体多呈现与剪切带大体平行的长条状，而在缓倾斜的低角度剪切带发育地带，花岗岩体多呈面状，且呈顺层侵位特征，显示同构造侵位特征。

The horizontal and vertical first derivatives of magnetic anomalies of an infinite cylinder are calculated by the cosine transform method, in which the maximum errors are -0.28 nT/m and 0.47nT/m, respectively and the percent errors are generally within -3.57%~3.27% and -1.94%~1.88%, respectively except several data of the boundary and part are bigger because of remains of Gibbus effect. The calculating curve and theoretical curve are approximately coincident, and there is no influence by effective magnetic dip angle in computing. But the errors with the Fourier transform method are -10.62nT/m and 14.42nT/m, there is large departure between the calculating curve and theoretical curve and evident influence by effective magnetic dip angle in computing.

利用余弦变换法计算的无限长水平圆柱体磁异常水平和垂向一阶导数的最大误差分别为-0.28nT/m、0.47nT/m；水平一阶导数的误差一般在-3.57%~3.27%之间，垂向一阶导数的误差一般在-1.94%~1.88%之间；计算的磁异常一阶导数值与理论值大致重合，而且不受有效磁化倾角的影响而Fourier变换法计算的水平和垂向一阶导数最大误差分别为-10.62nT/m、14.42nT/m，计算曲线与理论曲线偏离大，受磁化倾角的影响也较大。

The results of this study showed that the influencing factors of slope instability for the Luchang Area include rock fall at the west slopes, thick colluvium, sliding planes for dip-direction slopes, headward and sideward erosion of channel, as well as fast seepage of ground water. Two slide planes were recognized from geological profile model. One is potential slide plane on the dip-directional slope, another plane is located in the colluvium near Luchang river sides.

本研究结果显示，鹿场地区地质环境之不安定原因，有西侧岩壁落石、厚崩积土体、顺向坡平面滑动、河道的向源侵蚀和侧蚀、地下水渗流快速等；就所建构地质模型可以了解，鹿场地区可能的滑动面有两部份，一为潜在的顺向坡平面滑动面，另一为在鹿场溪河岸崩积层边坡内的滑动面。

The general feature of deformation caused by the collision between two continents also reveals that, during the collision process, apart from a foreland basin and high mountains being formed, there is another compressive depression with an asymmetric structure developed on the side of the obducted plate, which is much easier to be formed when the dip angle of the collisional fracture zone is between 15° and 30° and is the deepest with a dip angle of 30°. This implies that the compressive depression is controlled by both subduction and obduction between two continents.

从大陆与大陆碰挂变形构造特征看，除发育前陆盆地－山脉系统外，在仰冲陆块一侧靠近造山带后缘还发育呈不对称结构的挤压性凹陷，当两个大陆板块碰撞断裂带倾角在15~30°时，该类型凹陷更容易形成，其中以30°倾角对应的凹陷最深，反映其形成可能是大陆碰撞过程中陆块之间相对俯冲和仰冲运动的综合结果。

Alumina sols of different content were prepared by using Al3 as precusor, water as solvent, nitric acid as peptizer, ethylacetoacetate and polyvinylpyrrolidone as modified menstruum. We used dip-coating method and spin-coating method prepared of alumina films on the plane glass and used dip-coating method and rising liquid method inside the wall of the fiber.

以仲丁醇铝为前驱物、水为溶剂、硝酸为胶溶剂、同时加入乙酰乙酸乙酯和聚乙烯吡咯烷酮作为改性剂制备了不同浓度的氧化铝溶胶用提拉法和旋覆法在平板玻璃上镀膜，同时用提拉法和液面上升法在石英毛细管内壁上镀膜。

Effects of hot dip time on the alloy layer depth of hot-dip aluminizing were investigated.

对740℃经不同时间的热浸镀铝试样测定合金层厚度。

A carrier gas such as nitrogen is directed through line 20 and valve 22 to connect with line 26 and mix with the gas sample.

如氮气之类的载体通过管线20和阀22引入，与管线26相通，与气体样品混合。

But for the most part, knaves and parasites had the command of his fortune

然而支配他的家产的大多是恶棍和寄生虫。