查询词典 dip angle

When measuring, based on the segmented contour line of thread, we used the compiled measurement program to calculate and measure the geometrical parameters of the internal taper thread as pitch, half of thread angle and taper angle. Precisions of pitch, half of thread angle and taper angle reached ±0.012mm,±0.17° and ±0.018°. The results satisfied with the technique requirement of production. The reason of error was analyzed.

在测量尺寸时，使用自编程序计算测量内螺纹的螺距、牙型半形及锥角，测量精度分别达到±0.012mm、±0.17°和±0.018°，满足产品的技术要求，并分析了误差产生的原因。

a system of along-track mode sar based on the gps is established.by seeing the gps signal as a chirp,chirp scaling algorithm of this mode with large squint angle is investigated.chirp scaling algorithm is considered more efficient and widely applicable when the bistatic sar system is in side-look or small squint angle mode,but in large squint angle case,the errors caused by taylor expansion are so large that the algorithm could lose its precision.in such a case,an equivalent mono-static sar range mode which has fewer errors than taylor expansion with large squint angle is proposed to substitute the range history of bistatic sar.then bistatic sar images with large squint angles are gotten by common nonlinear cs algorithm.the effectivity of the method is verified by matlab simulation.

摘 要：建立了基于gps的顺轨sar系统模型，通过将gps信号等效为chirp信号，研究了在该模式下的大斜视角chirp scaling算法。在正侧视或小斜视情况下，cs算法具有较好的聚焦性能和广泛的适用性，但在斜视角较大的情况下，该算法将散焦而不能成像，因而提出了用等效的单基地距离模型来代替双基地距离历史的方法，解决了大斜视角情况下距离模型二阶近似误差较大的问题，并结合单基地非线性cs算法，实现了在大斜视角情况下的基于gps反射信号的双基地sar高精度成像，最后通过matlab仿真进行了验证。

At the peak point of backward swing, the vertical height from the center of the ball to the ground was 1.34 ±0.01 meters, the angle of the shoulder was 82 ± 2.5 degrees and the angle of the elbow was 161.35 degrees. During release, the vertical height was 0.13 ±0.01 meters, the angle of the shoulder was 48.00 ± 3.64 degrees and the angle of the elbow was 160.71 degrees.

所得具体结果如下：在后摆最高点时，球体中心点距地面之垂直高度平均为1.34 ±0.01公尺，肩关节角度为82 ± 2.5度，肘关节角度为161.35度；而在出手瞬间球体中心点距地面之垂直高度平均为0.13 ±0.01公尺，肩关节角度为48.00 ± 3.64度，肘关节角度为160.71度。

The theoretical and experimental investigations of discus flight indicate the following useful conclusions:the optimum combination of throw angle and discus inclination angle is 35°/26°at zero wind,while 45°is not the best release angle due to the aerodynamic force;different combinations of throw angle and inclination angl...

由于气动力的作用，45°并非铁饼的最佳投掷角度，实验和理论研究表明：无风时35°/26°的投掷角/倾角组合最佳；顺风和逆风投掷必须采用不同的投掷角/倾角组合才能获得当地条件下的最好成绩；铁饼出手时25r/s的自转速度已经可以满足稳定性的要求。

According to the functional requirements of adaptive front-lighting system, the relationships between the yaw angle and pitch angle of light axis in AFS and vehicle parameters, including speed, steering wheel angle and pitch angle of vehicle body are derived, thus a kinematics model for AFS is set up.

根据自适应前照灯系统的功能要求，推导了车辆参数（车速、转向盘转角和车身仰俯角）与车灯光轴沿水平和垂直两个方向的偏转角度之间的关系，建立了自适应前照灯系统的运动学模型。

Under the influence of angle of joint and load, the distributing of displace field exits non-uniformity, and with the increase of joint dip angle the non-uniformity become stronger.

6受节理和加荷方向的影响，位移场分布存在一定的不均匀性，随着节理倾角变大，不均匀性增强。

Research shows that the main factors influencing forging penetration efficiency are reduction in pass and the dip angle of the hammer, and the main factors influencing forged piece surface quality are axle feeding speed and rotation angle.

研究表明：影响锻透性的主要因素为道次压入量和锤头倾角；影响锻件表面质量的主要因素为轴向送进速度和旋转角度。

It can meet the requirements for many types of typical layout, such as 500-1400mm belt w idth, dip angle of 0°-18°, and surrounding angle of 190°-210°.

可满足带宽500～1400mm 、倾角0°～18°、围包角190°～210°多种型式的典型布置。

It is a new topic that rule of ground movement in deep dip angle coal seam mining, the coal seam angle is one of important factor of deciding the rule of ground movement , the overlying rock of steep coal seam mining have different homogeneousness in horizontal orientation.

倾斜煤层是指煤层倾角在15°—55°之间的煤层，倾斜煤层开采地表沉陷移动规律是地表沉陷研究领域中的一个重要组成部分，煤系地层倾角是决定上覆岩层的移动和破坏形式及地表移动与变形程度的重要因素之一。

So the main study contents of this thesis are as follows: the load distribution pattern along the length beam and the cross beam in the place of node、 the appropriate matching rigidity of the length and cross beams in the action of same anchorage force and the affection pattern discuss on sloping surfaces dip angle、 beam rigidity 、 anchor-rope angle as well as the position of load which affect the load distribution ratio on length and cross beams. In the end it brings forward lattice beam internal force calculated method on the basis of double parameter groundsill model.

鉴于此，本文主要的研究内容是格构梁节点处荷载沿纵横梁的分配规律、同一锚固力作用下纵横梁合理的匹配刚度以及对格构梁纵横梁荷载分配比值可能存在影响的坡面倾角、梁刚度、锚索夹角、加载位置等因素的影响规律探讨，最后提出基于双参数地基模型的格构梁内力计算方法。

The circulation, consumption and reproduction of the trilogy have not only testified to its historical significance and literariness, but also invested it with new meanings.

该三部曲的流通、消费与再生产不仅验证了其历史意义及文学性，而切还赋予它以新的意义。

If he thought that he could buy me off, he would be wrong.

如果他认为他可以收买我，那他就大错特错了。