查询词典 diluted ammonia solution

In the spiral pipe heat exchanger exports terminal, the ammonia steam temperature has been heated up 85 ℃--95 ℃, by now, the ammonia steam had the 45kg-55kg/cm2 ammonia steam pressure, sent in the ammonia steam turbine through the constant temperature pipeline, impelled ammonia steam turbine revolving, led the generator electricity generation;After the ammonia steam makes the merit release energy, the temperature drop, the returns ammonia storage tank, passes through again adjusts the press pump to press into the spiral pipe-type heat exchangers to carry on the next circulation;Including the ammonia steam turbine entire ammonia steam road is becomes the independent closed cycle system, is isolates completely with the outside air;The ammonia steam only plays the carryhome and the shift energy role, in the electricity generation process does not consume the actuating medium, the stored energy carrier water also is only gets up the carryhome and the shift energy function,The waterway also is from becomes the independent closed cycle system, in the electricity generation process also the needless water consumption, through the actuating medium ammonia steam and the stored energy carrier water unceasing shuttle service, transforms through the heat interchanger the solar energy as the actuating medium ammonia steam heat energy and the kinetic energy,With the aid of the ammonia steam turbine heat - machine transformation function and the generator machine - electricity transformation function, has realized the solar energy hot - electricity entire conversion process, transforms continuously the solar energy into the electrical energy, power supply for foreign;The low temperature generating system must solve three big technical keys:One, the anticorrosion (has actuating medium has strong corrosiveness), two is Explosion-proof (Some actuating medium Can have the detonation with the air mix when divulging, controls warm malfunction, elevates temperature suddenly also can have detonation), three is guards against the revolution axis divulging

以太阳能低温发电系统为例，低温发电方法是这样进行的：以水作为储能载体的太阳能采集器将太阳能采集起来，将水温提升至85℃--98℃；用氨作为工作介质储于氨储罐及氨汽路中；采用螺旋管型热交换器；用调压泵将氨储罐中的氨汽压入螺旋管型热交换器的螺旋管内，用调压泵将携带太阳能的85℃--98℃的储能载体热水压入螺旋管型热交换器的螺旋管外壁空间进行循环式热交换，在热交换器的螺旋管出口端，氨汽温度已被加热到85℃--95℃，这时，氨汽具有45kg—55kg/cm2的氨汽压力，通过恒温管道送入氨汽轮机，推动氨汽轮机旋转，带动发电机发电；氨汽作功释放能量后，温度下降，返回氨储罐，再经调压泵压入螺旋管型热交换器进行下一次循环；包括氨汽轮机在内的整个氨汽汽路是自成独立的封闭循环系统，与外界空气是完全隔绝的；氨汽只起携带和转移能量的作用，发电过程中并不消耗工作介质，储能载体水也是只起携带和转移能量的作用，水路也是自成独立的封闭循环系统，发电过程中也不消耗水，通过工作介质氨汽和储能载体水的不断循环运行，通过热交换器将太阳能转化为工作介质氨汽的热能和动能，借助氨汽轮机的热—机转化功能和发电机的机—电转化功能，实现了太阳能的整个热—电转化过程，将太阳能源源不断地转变为电能，对外供电；低温发电系统要解决的三大技术关键：一是防腐（有的工作介质具有较强的腐蚀性）、二是防爆（有的介质泄漏与空气混合会产生爆炸，控温失灵，急剧升温也会产生爆炸）、三是防轴漏（汽轮机是动态旋转体，必须解决工作介质的防轴漏问题）。

The invention relates to a way to prepare nickel, manganum and cobalt hydroxide. The method includes making the mixed solution a coprecipitate with mixed solution B in base solution C. The mixed solution A contains nickel salt, manganese salt and cobalt salt, the mixed solution B is a strong base solution, the base solution C is aqueous ammonia solution. The solution A also contains ammonium salt while solution B also contains aqueous ammonia; besides, after being mixed, the molarity of ammonia in solution A and solution B is the same with that in solution C.

一种镍锰钴氢氧化物沉淀的制备方法，该方法包括将混合液A和混合液B在底液C中进行共沉淀反应，所述混合液A中含有镍盐、锰盐、钴盐，所述混合液B为强碱溶液，所述底液C为氨水溶液，其中，所述混合液A中还含有铵盐，混合液B中还含有氨水，并且参于等当量反应的混合液A中的铵盐与混合液B中的氨水在混合液A和混合液B混合后氨的摩尔浓度与底液C中氨的摩尔浓度相等。

Computation makes clear as a result, the smooth balance of power that 6 ammonia in 6 ammonia magnesium chloride form in nucleus and other electron breaks up in field, cent is two class, the first class 4 ammonia, the 2nd class 2 ammonia, when outside ambient changes, it is to shuck off 4 ammonia element likely most, additionally 2 ammonia are shucked off again after warming up, this one conclusion accords with experimental result to agree.

计算结果表明，六氨氯化镁中的6个氨在原子核和其它电子形成的平均势场中分裂，分为两级，第一级4个氨，第二级2个氨，当外界条件变化时，最有可能是脱去4个氨分子，升温后再脱去另外2个氨，这一结论符合实验结果一致。

With Ammonia as refrigerant and water as absorbent, they are boiled by the heater in the generator, as a result, the Ammonia-water solution is evaporated. The Ammonia vapor is purified by the rectifier and is condensed into liquid Ammonia in condenser. The liquid Ammonia and the pure Helium purified in the absorber are evaporated together in the evaporator and to absorb heat thus refrigerate at the same time.

采用氨为制冷剂，水为吸收剂，通过对制冷机芯的发生器加热，使氨水溶液中的氨蒸发，氨蒸汽经精馏器提纯后进入冷凝器成液氨，液氨在蒸发器中与经吸收器提纯的纯氦共同蒸发，同时从外部吸收热量，达到制冷的目的。

The results show that the bud bacilli can oxidate ammonia to nitrous, and when ammonia concentration in wastewater ranges from 25 mg/L to 70 mg/L, ammonia removal amount is direct proportion to ammonia concentration in wastewater and ratio of ammonia removal ranges from 58% to 69%.

结果表明，芽孢杆菌主要进行亚硝化脱氮，在氨氮进水浓度25～70 mg/L范围内，氨氮去除量与进水氨氮浓度成正比，氨氮的去除率稳定在58%～69%。

Ammonia distilling is to distill the residual ammonia from the blast section in an ammonia still, which evaporate the wolatile ammonia into the saturator to increase the production of vitiol ammonia and send waste water to biochemistry section to decontaminate.

蒸氨生产主要是将来自鼓风冷凝岗位的剩余氨水在蒸氨塔内进行蒸馏处理，使剩余氨水中的挥发氨蒸出后送回到煤气中以增加煤气含氨量进而提高硫酸氨的产量，并将蒸氨废水送至生化污水处理工序进行处理。

Methods: In accordance with conventional reporter gene analysis reagent preparation method, the main component Luciferase, Luciferin and ATP were serial diluted to find the optimal concentration; Reaction solution was prepared according to the optimal concentration of the main component, then ATP were serial diluted to measure their reporter gene. Then standard curve of ATP were drawed. Tumor cell lines H1299 were serial diluted and their ATP were measured by reaction solution prepared to analyse the minimum cell number.

按照常规报告基因分析试剂配制方法，将其中主要成分Luciferase和Luciferin及ATP浓度进行倍比稀释后找到最适合反应的最佳浓度值；按照最佳浓度配制反应液，将ATP浓度倍比稀释测定报告基因数值并绘制标准曲线，分析检测灵敏度；另外选取肿瘤细胞株H1299，倍比稀释后裂解细胞应用配制好的反应液进行ATP检测，分析最低检测细胞数。

The intermediates of manufacturing process include the hydrolyzed solution, the aqueous solution of Radix Isatidis extraction, the aqueous solution of Fructus Gardeniae extraction, the aqueous solution of Flos Lonicerae Japonicae extraction, the aqueous solution of baicalin, the alcohol solution of mixteure composed by cholic acid and hyodeoxycholic acid, 4-blended solution, 6-blended solution, the blended solution of baicalin and ASFLJE and 8-blended solution.

清开灵注射剂处方由胆酸、猪去氧胆酸、水牛角、黄芩苷、板蓝根、栀子、金银花和珍珠母组成，其生产过程中间体包括水解液、板蓝根液、栀子液、金银花液、黄芩液、四混液、胆酸混合液、六混液、银黄液和八混液。

Wherein, the chemical formula of said compound is γ-HaKbNac(H2O)dNixM1-XO2 and the method comprises that mixing the nickel salt solution and at least one metal salt solution to attain the solution A; preparing caustic soda or caustic potash solution and adding sodium carbonate or potassium carbonate to attain the solution B; preparing the ammonia solution C; reacting the A, B, and C, processing the solid-liquid separation to attain the ball α nickel hydroxide; reacting with the oxidant in the solution of caustic soda or caustic potash to attain the black solid-liquid mixture and processing the solid-liquid separation to attain the ball γ hydroxyl nickel oxide.

其化学表达式为γ-HaKbNac(H2O)dNixM1-XO2，将镍盐溶液与至少一种金属盐溶液混合得溶液A，配制氢氧化钠或氢氧化钾溶液，加入碳酸钠或碳酸钾得溶液B；配制氨水溶液C；将A、B、C反应，固液分离，得球形α氢氧化镍；在氢氧化钠或氢氧化钾溶液中与氧化剂反应，得黑色固液混合物，再固液分离，得球形γ羟基氧化镍。

A preparation method of the visible-light photocatalyst Bi2WO6 nano-powder is characterized by comprising the steps as follows:(1) the selection of raw materials;(2) bismuth nitrate Bi(NO33 question mark 5H2O is added into a citric acid solution to obtain the citric acid solution containing white sediment;(3) EDTA is added into ammonia water which is then added dropwise with the citric acid solution containing the Bi(NO3)3 question mark 5H2O so to obtain a solution of bismuth;(4) the solution of bismuth is added with (NH4)6W7O24 question mark 6H2O solution to form a precursor solution which is then stirred, dried, coked, cooled and ground to obtain decarburized powder;(5) the decarburized powder is roasted for 2h to 4h under 450 DEG C to 550 DEG C to obtain the visible-light photocatalyst Bi2WO6 nano-powder.

可见光催化剂Bi 2 WO 6 纳米粉体的制备方法，其特征在于它包括如下步骤：1原料的选取；2将Bi(NO 3 ) 3 5H 2 O加到柠檬酸溶液中，得到含有白色沉淀的柠檬酸溶液；3将乙二胺四乙酸加到氨水中，并缓慢滴加入含有Bi(NO 3 ) 3 5H 2 O的柠檬酸溶液中，得铋的溶液；4将(NH 4 ) 6 W 7 O 24 6H 2 O溶液加入上述铋的溶液中，组成前驱液；搅拌，干燥，焦化，冷却后，研磨，得去碳的粉体；5将去碳的粉体在450～550℃下焙烧2～4h后，得到可见光催化剂Bi 2 WO 6 纳米粉体。

A carrier gas such as nitrogen is directed through line 20 and valve 22 to connect with line 26 and mix with the gas sample.

如氮气之类的载体通过管线20和阀22引入，与管线26相通，与气体样品混合。

But for the most part, knaves and parasites had the command of his fortune

然而支配他的家产的大多是恶棍和寄生虫。