查询词典 dilatometric

By the experimental results obtained from both dilatometric and magnetic methods, it has been found that addition of 1～2% C_o maymarkedly enlarge the temperature range of low expansion coefficient forinvar steel.

根据膨胀试验和磁性试验的结果，加入1～2％的钴会显著的扩大不变钢最低膨胀系数的温度范围。

TTT curves were determined by dilatometric testing and test specimens of these steels were austempered.

用热膨胀试验测定了TTT曲线，各组试验用钢的试样都进行了等温淬火。

The electrical conductivity and thermal expansion of La2Mo2O9 under low oxygen partial pressure were studied with the help of thermoelectric power and dilatometric measurements, respectively.

通过热电势和热膨胀测量，分别研究了La2Mo2O9在低氧分压条件下的电学性质和热膨胀行为。

Dilatometric measurements show that there is slight shrinkage in the coating till 1250℃, however, a remarkable sintering process happens cluring holding period at 1250℃.

热膨胀性能测量表明，LC涂层从室温升到1250℃时发生轻微的烧结，在1250℃保温过程发生明显的烧结现象。

By dilatometric test, Laboratory experiments were...

利用膨胀法在Thermecmastor-Z型热/力模拟试验机上进行实验室实验，测定了研究钢种在不同的中间保温工艺及一定变形工艺条件下的过冷奥氏体连续冷却转变曲线；对每个试样进行了打磨、抛光、腐蚀，在光学显微镜下观察其组织，研究了在不同中间保温工艺下组织的变化情况；利用所建立的CCT曲线研究了一定变形工艺条件及不同保温工艺对其相变行为及组织的影响，对其影响规律进行了分析。

A continuous cooling transformation diagram of steel 10MnMoNiNb reduced by 50 % at 800 ℃ was constructed using dilatometric method on a Gleeble 1500 thermomechanical testing system, along with optical microscope and TEM.

在Gleeble1500热模拟机上，利用热膨胀法建立了10MnMoNiNb钢在800℃变形50％后的连续冷却相变曲线，并采用光学金相和TEM方法分析了在不同冷速条件下，形变奥氏体的相变产物。

The above-mentioned T8 glass-ceramic showed only 25 % decrease in IR transmittance, 17 % increase in hardness, 61 increase in dilatometric softening point, and 19 % increase in Young s modulus.

上述试片之IR穿透率与T8起始玻璃比较，仅下降了25 %，但硬度上升了17%；与未添加成核剂的玻璃比较，膨胀仪软化点上升约61℃，杨氏系数上升约19 %。

Its precision mainly lies on the Abbe Error caused by the offset between the centerline and the mobile line of the capacitive-gate ruler, the heeling error of the guide mechanism, and the error caused by the dilatometric change of parts resulted from the temperature change.

主要在于它的精度造成的阿贝误差之间的中心线与电容栅尺移动线偏移，指南的机制倾斜误差，以及零件的热膨胀变化引起的温度变化导致的错误。

The dilatometric curves of low-carbon micro-alloyed steel with Mo at different cooling rates were detected on Gleeble-3800 thermo-mechanical simulator.

在Gleeble-3800热模拟试验机上，测定了含Mo 低碳微合金钢在不同冷却速度下连续冷却时的膨胀曲线，利用热膨胀法并结合金相-硬度法，测定了该钢的连续冷却转变曲线；研究了冷却速度对该钢组织及硬度的影响。

The critical cooling rates in undercooled austenite transformation process of T91 ferritic heat-resistant steel were studied by DIL805A/D high-resolution differential dilatometer. According to the dilatometric measurements, phase transformation kinetic information was obtained with the aid of the analysis of the lever rule from the recorded dilatometric curves.

利用DIL805A/D高精度差分膨胀仪，通过线膨胀行为测量与微观组织分析，获得T91铁素体耐热钢连续冷却转变过程中相关动力学信息，结合冷却后T9l钢组织特征，确定了T91钢过冷奥氏体转变过程中的临界冷却速度。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。