查询词典 dilatometer

CCT curves of 450 MPa and 550MPa high strength weathering steel were studied by gleeble1500 hot simulator and DT-1000 dilatometer.

采用Gleeble1 5 0 0热模拟试验机及DT 1 0 0 0膨胀仪研究了 4 5 0MPa和 5 5 0MPa级高强耐候钢的连续冷却转变曲线，分析了不同变形及冷却工艺条件下高强度耐候钢的金相组织类型。

The effect of Stress applied at certain temperature on low temperature phase transformation of T91 was studied with Baehr DIL805A/D high-resolution differential dilatometer. According to the results of dilatometric measurement and microstructure observation, kinetics of phase transformation was obtained.

采用Baehr DIL805A/D高精度差分膨胀仪测量线膨胀行为与微观组织分析获取了T91铁素体耐热钢低温相变过程动力学信息，研究不同温度（760、650和440℃）下施加不同压应力（100、150和200 MPa）对低温相变过程的影响。

The critical cooling rates in undercooled austenite transformation process of T91 ferritic heat-resistant steel were studied by DIL805A/D high-resolution differential dilatometer. According to the dilatometric measurements, phase transformation kinetic information was obtained with the aid of the analysis of the lever rule from the recorded dilatometric curves.

利用DIL805A/D高精度差分膨胀仪，通过线膨胀行为测量与微观组织分析，获得T91铁素体耐热钢连续冷却转变过程中相关动力学信息，结合冷却后T9l钢组织特征，确定了T91钢过冷奥氏体转变过程中的临界冷却速度。

In this thesis, the phase diagram of Zn-Al binary system on 10~69.5 w% was reinvestigated by using differential scanning calorimeter, X-ray diffraction and pushrod dilatometer. The process of isothermal transformation during the aging of high-Aluminum-Zinc-based alloy was studied by using differential scanning calorimetry, and the aging behavior of the alloy was analyzed at the aspect of thermal analysis kinetics. The change of microstructure which the alloy was being heated was observed on high-temperature metallurgical microscope. The microstructure and wear-friction properties were compared among the alloys treated with several different heat treatment processes, and a model for heat treatment processes was proposed based on artificial neural network,so as to predict the relationship between friction coefficient and parameters of aging treatment such as aging temperature and time.

本文采用高温X射线衍射、示差扫描量热分析、热膨胀等方法重新测定含锌量范围为10％～69.5％的Zn-Al系二元相图，利用示差扫描量热分析法，研究高铝锌基合金时效等温转变过程，并从热分析动力学的角度分析高铝锌基合金合金时效行为；使用高温金相显微镜观察合金加热时的组织变化；比较几种不同热处理工艺对高铝锌基合金显微组织与耐磨性能的影响并利用人工神经网络建立高铝锌基合金热处理工艺模型，预测合金摩擦系数随时效温度及时间变化规律。

AlPO4 was synthesized by a Sol-Gel method. Its coefficient of thermal expansion was measured by dilatometer. Its corrosion behavior was tested in an environment of 50vol%H2O/50vol%O2 with a flow rate of 0.085cm/s at 1350℃. The phases and composition of the samples were analyzed by X-ray diffraction and Energy Dispersive Spectroscope. The microstructures of AlPO4 were characterized by Scanning Electron Microscope.

采用溶胶凝胶法合成了一种AlPO4环境障碍涂层材料，测定了其热膨胀系数，在1350℃、50vol% H2O/50vol%O2、1.013×105 Pa、气体流速0.085cm/s的水氧耦合环境中研究了其抗水氧腐蚀性能，并利用X射线衍射仪、能谱分析仪和扫描电子显微镜分析了材料组成和微观结构。

In the United States, chronic alcoholism and hepatitis C are the most common ones.

在美国，慢性酒精中毒，肝炎是最常见的。

If you have any questions, you can contact me anytime.

如果有任何问题，你可以随时联系我。