查询词典 dielectric

The effect of curing process of thermosetting powder coating consists of carboxylated polyester resin cured with triglycidyl isocyanurate has been investigated using broadband dielectric relaxation spectroscopy over a wide range of frequency and temperature for different constant curing times.

使用在各种各样的频率的宽频介电弛豫分光学治疗过程的作用热固性粉末涂层包括carboxylated聚酯树脂治疗与triglycidyl异氰脲酸酯被调查了和温度不同的恒定的治愈时间。

Electroless Copper is a chemical metalization process intended to metallize the surface of dielectric material at the hole wall and institute electrical connection between all exposed copper surfaces.

化学沉铜：为了使孔壁上不导电的树脂及玻璃能够导电，进行化学沉铜，使孔壁与板面上沉上的一层很薄的铜层，只有大约75微英寸厚（0.5mil），再通过全板电镀，使板面和内层铜联接起来。

But hexagonal zinc metatitanate (ZnTiO_3) decomposes to orthotitanate (Zn_2TiO_4) with relatively bad microwave dielectric properties at ~945℃.

但是六方相ZnTiO_3会在945℃以上分解为微波介电性能极差的立方相Zn_2TiO_4，这将严重恶化陶瓷的微波介电性能。

The number of hydrogen bond between methylol groups and other groups cut in dielectric relaxation increased with increasing WPG based on the activation enthalpy.

根据表观活化焓求得介电松弛过程中需要切断的氢键结合数量，构筑了二氧化硅/木材复合材料介电松弛回转取向运动模型，随着增重率的增加，需要切断的氢键数量增加。

The dielectric relaxation process Ⅲ in higher frequency region, which is composed by the relaxation process based on the reorientation of adsorbed water molecules and relaxation process Ⅰbased on methylol groups, increases with the developing adsorption during moisture adsorption process.

在水分吸着过程中，出现在高频域的由基于吸着水回转取向运动的介电弛豫过程和基于无定形区中伯醇羟基回转取向运动的弛豫过程叠加而成的弛豫过程Ⅲ随着吸着的进行逐渐增大。

Moreover, taking the adsorption process from oven-dry state to the equilibrium state in 20℃,60%RH environment as an example, the dielectric relaxation based on the reorientation of adsorbed water molecules was separated out from that based on the methylol groups in the amorphous region of wood cell wall.

以绝干状态→20℃，60%RH 平衡态的吸湿过程为例，将基于吸着水分子回转取向运动的介电弛豫与基于木材无定形区中伯醇羟基回转取向运动的介电弛豫进行分离，并在 Eyring 的绝对速度反应论的基础上，求得了与吸着水分子进行回转取向运动相关连的热力学量，得到了在吸着过程中吸着水分子与木材吸着点之间的氢键结合随着水分吸着进程的变化情况。

X-ray diffraction, scanning electronic microscope, impedance analyzer and piezoelectric workstation were used to determine the crystal structure, micrographic topography, dielectric, piezoelectric and ferroelectric properties of NKN—based ceramics.

利用X射线衍射分析、扫描电子显微、HP4294A阻抗分析仪、压电工作站等对这三个系列样品的晶体结构、表面形貌、介电性能、压电性能和铁电性能等进行了深入的分析、研究和对比。

In this study, 0.94(Bi0.5Na0.5)TiO3-0.06BaTiO3 is a composition within morphotropic phase boundary. It was prepared by solid state reaction method. The dense ceramics with various grain size distributions were prepared by adjusting process. And grain size effect on crystal structure, dielectric, ferroelectric and piezoelectric properties were studied in detail.

故本研究将以固态反应法合成(Bi0.5Na0.5)TiO3-BaTiO3系统中之MPB 组成之0.94(Bi0.5Na0.5)TiO3-0.06 BaTiO3，并利用制程的调整以制备具有不同晶粒大小之致密陶瓷体，再来探讨晶粒大小变化对晶体结构、介电性质、铁电性质以及压电性质之影响。

(1-x)BiScO3-xPbTiO3 ceramics exhibits excellent dielectric and piezoelectric properties in the vicinity of the morphotropic phase boundary (x=64.0% mol fraction PbTiO3), which separates the rhombohedral phase from tetragonal phase.

(1-x)BiScO3-xPbTiO3陶瓷在x=64.0%附近存在一个从菱方晶系过渡到四方晶系的准同型相界，在此相界附近材料能获得优良的介电和压电性能。

BiScO3-xPbTiO3 ceramics exhibits excellent dielectric and piezoelectric properties in the vicinity of the morphotropic phase boundary (x=64.0% mol fraction PbTiO3), which separates the rhombohedral phase from tetragonal phase.

(1-x)BiScO3-xPbTiO3陶瓷在x=64.0％附近存在一个从菱方晶系过渡到四方晶系的准同型相界，在此相界附近材料能获得优良的介电和压电性能。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。