查询词典 dielectric

It is indicated that the dielectric loss factor of the epoxy resin impregnated paper insulating bushing is generally higher than thatof the oil impregnated paper insulating bushing of the same voltage level; the tests should be strengthened when notable variation is found in the insulation dielectric loss factor and capacitance; when the variation is greater than 10%,the bushing must be replaced.

最后指出，环氧浸纸绝缘套管的介质损耗因数普遍高于同等电压等级的油浸纸绝缘套管，当发现绝缘介质损耗因数和电容值发生较明显变化时，应加大测试密度，当变化量大于10%时，必须更换套管。

Appling the method to multi-channel filter design, we find that the filter efficiency can improve about 50% when the dielectric rod radius is proportion with ransonant cavity dielectric rod radius.

将其应用到多信道滤波器的设计中，发现当其半径与相应缺陷介质柱半径的大小成正比时，各信道的耦合效率均能提高50%左右。

First, the effects of magnetic RAM relaxation time and the rise-time of incident pulse signal on reflection signal are discussed, the relationship between the rise-time of incident pulse and relaxation time based on the energy of reflection signal is revealed. Then, the effects of magnetic hysteric, susceptibilities and saturation upon reflection signal are analyzed, the results reveal the reflection of RAM target and UWB signal design. In the meantime, dielectric relaxation time effect about dielectric RAM target is analyzed simply, and the effects of relaxation time and the width of incident pulse upon reflection signal are probed. Finally, a few RAM targets are measured in the chamber using the impulse radar experiment system which is developed by the team of anti-stealth impulse radar on Department of Electrical Engineering, National University of Defense Technology. The experimental results show the similarity of the rule of echos with the theory. From the compared results of different tagets, we concluded, compared with 15% wideband sinusoidal signal, the impulse signal has increased 10～12dB energy from the same loaded RAM target; this, in turn, shows the nonlinear effects of RAM to the echoes, and the potentiality of the impulse signal to RAM targets.

首先分析了磁性RAM的弛豫时间及入射脉冲信号的上升时间对反射信号的影响，从反射信号能量角度出发，给出了入射脉冲上升时间与弛豫时间的关系；接着分析了磁性RAM的磁滞特性、磁化率及磁化强度对反射信号的影响，给出了RAM目标辐射和有关UWB信号设计的一般性结论；其次，对介电RAM的弛豫时间效应作了简单的分析，探讨了介电弛豫时间及入射脉冲宽度对反射信号的影响；最后利用国防科技大学电子技术系&反隐身冲激雷达技术研究组&研制的冲激雷达实验系统，在微波暗室中对几种不同的RAM目标进行了测量，结果表明：其反射波形的基本规律与上述理论分析相一致；从各种不同目标回波的能量对比结果得出，涂覆RAM目标对冲激信号的吸收比15％带宽的正弦信号要小10～12dB，证实了RAM的非线性效应对回波的影响，也证实了冲激信号反隐身的潜力。

Have discussed liquid dielectric breakdown theory and sundry factors influencing liquid dielectric breakdown voltage, and put forward electric spark discharge model.

论述了液体电介质的击穿理论，分析了各种因素对液体电介质击穿电压的影响，提出了电火花放电模型。

The diversifications of abnormal peaks of dielectric constant and loss were clarified by space-charge model, and during phase transitions, the common-body contradiction was proposed qualitatively between the effect of space-charge model with hopping cation by changing frequency and that of current-carrier scattering by their structural transitions, their co-contributions decided the change behaviors of dielectric constants and loss.

以不同化学微畴的空间电荷模型讨论了相应介电峰和损耗峰的变化机理，提出在频率改变时畴中阳离子跃迁形成空间电荷的效应和相变所带来的载流子散射效应是一对矛盾共同体，它们间的贡献对比决定了介电常数和介电损耗的变化行为。

The temperature rising mechanisms of manganese carbonate fines containing coal by microwave heating were discussed. The results show that, manganese carbonate fines containing coal have good characteristics of microwave heating and self-reduction. At the molar ratios of C atom to O atom as 1.1, 1.2 and 1.3 in the mixed materials, the averaged maximum temperature-rising rate of the mixed materials by microwave heating is 140.7 K/min at 1 473 K with the microwave frequency of 2.450 GHz. At the different containing coal ratios and heating temperatures, the value of the dielectric constant is big, 5.5, but that of the permeability is about 1, so the mixed materials belong to dielectric loss. The temperature rising performance depends chiefly upon the electromagnetic performance of materials, whose change is caused primarily by the chemical reaction, the changes of crystal structural , and the changes of defects state. The bigger the containing coal ratio, the better the absorptivity of microwave. At the same containing coal ratio, the higher the heating temperature, the weaker the absorptivity of microwave.

研究结果表明：含碳碳酸锰矿粉具有优良的微波加热特性和自还原性；在微波加热频率为2.450 GHz、碳氧原子摩尔比分别为1.1，1.2和1.3时，微波加热混合物料至1 473 K的升温速率平均最高达到140.7 K/min；不同的加热温度和配碳比下混合物料的介电常数较大，都在5.5左右，而磁导率为1左右，属介电损耗型；微波加热含碳碳酸锰矿粉的升温性能主要取决于含碳碳酸锰矿粉的电磁性能，而电磁性能的改变主要是由物料加热过程中产生的化学反应、晶体结构变化及缺陷状态的改变引起的；配碳比提高，物料吸收微波的能力有所提高；在相同的配碳比下，加热温度升高，吸收微波的能力有所减弱。

Disadvantage of this device is high voltage, in order to reduce the operating voltage to achieve the purpose of actual use, screening of high dielectric constant material as the dielectric layer material is topic of future research.

缺点是工作电压偏高，需要进一步筛选出介电系数高的物质来作为介电绝缘层材料，以便降低工作电压，达到实际可以使用的目的。

Curing kinetics of epoxy resin and the effects of different compositions on curing reaction were researched by using the differential scanning calorimeters. Relationship between curing temperature and curing converting rate had been studied. Curing conditions for the system were determined. Modified nano-Al2O3/epoxy resin and core shell/epoxy resin composites were prepared by means of blending method. The influence of the composition on the properties was discussed. The thermal and dielectric properties of these composites were investigated using differential scanning calorimetry, Thermogravimetry and dielectric analyzer.

首先，论文通过差示量热扫描仪分析研究了环氧树脂与酸酐固化体系的固化反应动力学及固化工艺；然后，通过共混法和超声分散法制备了一系列纳米氧化铝/环氧树脂及核壳粒子/环氧树脂两相复合材料；进而通过DSC及热重分析仪测试了复合材料的玻璃化温度、热降解温度等热学性能，并采用介电分析仪测试分析了复合材料的介电常数、介电损耗等介电性能，讨论了组成对复合材料的热学性能及介电性能的影响。

A process for making an electronic device which comprises applying a nonaqueous plate-resistant ink by ink jet printing to selected areas of a dielectric substrate, optionally laminated with an electrically conductive metal, exposing the plate resistant ink to actinic and/or particle beam radiation to effect polymerisation, adding one or more metal layers by electrolytic or electroless deposition, the upper layer of which is an etchresistant metal, removing the polymerised plate-resistant ink with alkali and finally removing the electrically conductive metal which are optionally directly laminated to the dielectric substrate and not protected by an upper layer of etch-resistant metal by chemical etching wherein the plate-resistant ink is substantially solvent-free and comprises: A 30 to 90 parts acrylate functional monomers free from acid groups comprising mono- or higher functionality wherein 5 to 95% by weight are mono-functional monomers; B 1 to 30 parts acrylate functional monomer containing one or more acid groups; C 0 to 20 parts polymer or prepolymer; D 0 to 20 parts radical initiator; E 0 to 5 parts colorant; F 0 to 5 parts surfactant; and where the ink has a viscosity of not greater than 30 cPs at 40 DEG C and all parts are by weight.

一种制备电子装置的方法，所述方法包括以下步骤：通过喷墨印刷在任选层压了一种或多种导电金属的介电底材的选定区域涂覆非水的阻沉积油墨，将所述阻沉积油墨暴露在光化辐射和/或微粒束辐射中以完成聚合，通过电解沉积或无电沉积增加一层或多层金属层，其中最上层的金属层为一种或多种阻蚀刻金属，用碱除去聚合的阻沉积油墨，最后通过化学蚀刻将任选直接层压在所述介电底材上并且不被一种或多种阻蚀刻金属的上层保护的导电金属除去，其中所述阻沉积油墨基本不含溶剂，并且包含以下组分：A30-90份不含酸基团的丙烯酸酯功能性单体，所述单体包括单官能或多官能单体，其中5-95％重量为单官能单体；B1-30份包含一个或多个酸基团的丙烯酸酯功能性单体；C0-20份聚合物或预聚物；D0-20份自由基引发剂；E0-5份着色剂；和F0-5份表面活性剂；其中所述油墨的粘度在40℃下不高于30cPs，并且所有的份数以重量计。

One well-understood effect of microwave radiation is dielectric heating, in which any dielectric material is heated by rotations of polar molecules induced by the electromagnetic field.

一个众所周知的微波辐射的作用是非传导加热，所有电介质材料被电磁场导致的两极分子循环加热。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。