查询词典 dielectric loss

Experimental result indicated that the physical process of capacity with aging time was identical with analysis of experimental result of dielectric loss.

实验结果表明，试样电容随不同老化条件变化的物理过程与介质损耗实验结果的分析是一致的：电老化对tanδ的影响最大，热老化在一定程度上起了热清洗的作用，导致老化后介损反而降低。

Aging Characteristics Analysis of Inter- turn Insulation Using Dielectric Loss.

用介质损耗分析变频电机匝间绝缘老化特性。

Installation, test and practical measurements of the whole system also have been implemented. Studied the various methods of digital monitoring dielectric loss for transformer bushes: harmonic analysis method. Sine-shape parameters method and integration method, states the principles of the three methods, its computational formula has been inferred and compared. Among them, harmonic analysis method was used to test practically both in lab and on site.

研究了变压器套管介质损耗的数字化监测方法：谐波分析法、正弦波参数法和积分法，论述了三种方法的监测原理，详细推导了各种方法的计算公式，比较了各种方法的优缺点，并采用谐波分析法在实验室和现场进行了测试，其结果表明该方法在介损测试中具有较高的稳定性和准确性。

In recent years, it has become a new direction to research a new type of dielectric loss measurement devices.

近几年，对新型绝缘介损测量装置的研究成为一个新的方向。

It's one of the main tasks of this thesis to researching and developing a new type of dielectric loss measurement device.

在理论上进行了详细的推导和分析。

The structure, component, morphology and magnetic property of the composites were characterized by X-ray diffractometry, Fourier transform infrared spectroscopy, transmission electron microscopy and vibrating sample magnetometry, respectively. The tangent value of magnetic loss angle and dielectric loss angle of the composites were measured by an impedance/material analyser with the frequecy in the range of 1 MHz～1 GHz.

利用X射线衍射仪、红外光谱仪、扫描电子显微镜和振动样品磁强计分别表征了样品的结构、形貌和磁性能，用阻抗/材料分析仪测定了复合物在1 MHz～1 GHz的频率范围内的磁损耗和介电损耗，并研究了聚苯胺和引发剂的相对含量对复合物的磁损耗和介电损耗的影响。

The results show that glass ceramics with thermal expansion coefficient of 5.11×10^(-6)℃, major phase of α-cordierite and ε=5.5, tan σ=2.1×10^(-4) can be prepared by the addition of 3.6% alkalis (Li2O+Na2O), and Li2O occupies 1.8%. With Li2O substitution for Na2O, spontaneous crystallization is obviously enhanced, and temperature of the first crystallization peak decreases from 950℃ to nearly 900℃, but the crystallization temperature of the second peak was not varied. With the increase of Li2O content, mixed alkali effect can be observed from the thermal expansion coefficient and dielectric loss curve which decreases first and then increases. Dielectric constant decreases monotonously with the increase of Li2O content.

研究结果表明：Li2O和Na2O总含量为3.6%，其中Li2O含量为1.8%时，微晶玻璃以α-堇青石为主晶相，热膨胀系数为5.11×10^(-6)℃，微波频率下介电常数ε为5.5，介电损耗tanσ为2.1×10^(-4)；随着Li对Na的取代，玻璃的析晶能力增强，初始析晶峰温度从950℃降至900℃左右，但没有降低第二析晶峰温度；随着Li2O含量增加，热膨胀系数及介电损耗都出现明显的混合碱效应，曲线呈现先降低后升高的变化趋势；样品的介电常数随Li2O含量增加单调降低。

The results show that glass ceramics with thermal expansion coefficient of 5.11×106 ℃, major phase of α-cordierite and εr=5.5, tan σ=2.1×104 can be prepared by the addition of 3.6% alkalis(Li2O+Na2O), and Li2O occupies 1.8%. With Li2O substitution for Na2O, spontaneous crystallization is obviously enhanced, and temperature of the first crystallization peak decreases from 950 ℃ to nearly 900 ℃, but the crystallization temperature of the second peak was not varied. With the increase of Li2O content, mixed alkali effect can be observed from the thermal expansion coefficient and dielectric loss curve which decreases first and then increases. Dielectric constant decreases monotonously with the increase of Li2O content.

研究结果表明：Li2O和Na2O总含量为3.6%，其中Li2O含量为1.8%时，微晶玻璃以α-堇青石为主晶相，热膨胀系数为5.11×106 ℃，微波频率下介电常数ε r为5.5，介电损耗tan σ为2.1×104；随着Li+对Na+的取代，玻璃的析晶能力增强，初始析晶峰温度从950 ℃降至900 ℃左右，但没有降低第二析晶峰温度；随着Li2O含量增加，热膨胀系数及介电损耗都出现明显的混合碱效应，曲线呈现先降低后升高的变化趋势；样品的介电常数随Li2O含量增加单调降低。

An oxide coating is formed on the surface of the aluminum powder after the surface passivation treatment, so as to efficiently avoid the formation of leakage conductance due to mutual contact between eclectically-conducting additives and thereby to reduce the dielectric loss of the material. The composite material has high dielectric constant, low density and good flexibility. The production method of the composite material has the advantages of simple and controllable process, low hot-pressing temperature, energy conservation and environmental protection.

铝粉经过钝化处理，表面形成一层氧化物包覆层，有效地避免了导电添料因相互接触而形成漏电导，降低了材料的介电损耗；复合材料介电常数高，密度低，加工简单，并具有良好的柔韧性；复合材料的制备方法工艺易控简单、热压温度低、节能环保。

The temperature rising mechanisms of manganese carbonate fines containing coal by microwave heating were discussed. The results show that, manganese carbonate fines containing coal have good characteristics of microwave heating and self-reduction. At the molar ratios of C atom to O atom as 1.1, 1.2 and 1.3 in the mixed materials, the averaged maximum temperature-rising rate of the mixed materials by microwave heating is 140.7 K/min at 1 473 K with the microwave frequency of 2.450 GHz. At the different containing coal ratios and heating temperatures, the value of the dielectric constant is big, 5.5, but that of the permeability is about 1, so the mixed materials belong to dielectric loss. The temperature rising performance depends chiefly upon the electromagnetic performance of materials, whose change is caused primarily by the chemical reaction, the changes of crystal structural , and the changes of defects state. The bigger the containing coal ratio, the better the absorptivity of microwave. At the same containing coal ratio, the higher the heating temperature, the weaker the absorptivity of microwave.

研究结果表明：含碳碳酸锰矿粉具有优良的微波加热特性和自还原性；在微波加热频率为2.450 GHz、碳氧原子摩尔比分别为1.1，1.2和1.3时，微波加热混合物料至1 473 K的升温速率平均最高达到140.7 K/min；不同的加热温度和配碳比下混合物料的介电常数较大，都在5.5左右，而磁导率为1左右，属介电损耗型；微波加热含碳碳酸锰矿粉的升温性能主要取决于含碳碳酸锰矿粉的电磁性能，而电磁性能的改变主要是由物料加热过程中产生的化学反应、晶体结构变化及缺陷状态的改变引起的；配碳比提高，物料吸收微波的能力有所提高；在相同的配碳比下，加热温度升高，吸收微波的能力有所减弱。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。