查询词典 dial tone

Although the voice-length of the neutral tone syllable is very short, the tone pattern can be perceived. The neutral tone pitch has two types; I .the neutral tone words can be read in brief, low-drop tone when they appear behind the ~ tone, the 2nd tone and the 4~ tone, the tone pitch is 31; the neutral tone words can be read in brief, half rd high-smooth tone.

关于轻声的调值，目前学术界有两个比较有代表性的观点：1、认为轻声在四个声调之后的音高各不相同。2、认为轻声音节尽管音长短，但它的调型仍然可以感知，调值可归纳为两种情况：（1）轻声在第一声、第二声、第四声后读短促的低降调，调值拟为31。

In these portion,the article begins the study of tone sandhi from the point view of two-character phrases and three-character phrases,which is also the focus and difficult point as well.On the basis of substantial materials of Dingzhou dialect,the author elaborates its rules and principles of tone sandhi of the general phrases and those with light tones,and reiterative location.the author puts his views as follows: 1.The rules of tone sandhi of two- character phrase are simple and unitive. 2.The complex of the phrase with light tones lies in the combination of the first tone and light tone.In the case,there are two different pronunciations in Dingzhou dialect.The author guesses it is the coexist of ancient pronunciations and common spoken Chinese. 3.The tone sandhi of general three-character phrases on the basis of the rules of that of two- character phrases,using the grammar structure of the three-character phrases as the restricted conduction,which function jointly. 4.The rules of tone sandhi of three- character phrases with light tones are restricted only by that of the two- character phrases with light tones and thus are foreign to grammar structure. 5.The tone sandhi of the words with reiterative location has their own system.

这两章中，作者采用直接调查法，社会语言学方法分别从一般字组、含轻声字组和叠音词字组三个方面对定州方言连读变调进行详尽地描写，文章中既有对连读变调的共时性描写，也有对连读变调历时性推测，总的来讲笔者认为定州方言变调具有一定的系统性，主要表现在以下几个方面：两字组连读变调规律简单统一，含轻声字两字组内部规律较为复杂，但是具有很强的一致性；定州方言含轻声两字组变调的复杂性主要表现在阴平+轻声的组合中，在这种情况下，定州方言有两种读音方式，推测它是语音存古现象和普通话语音并存的结果；一般三字组连读变调以两字组连读变调规律为基础，以三字组的语法结构为制约条件，二者共同发生作用；轻声三字组变调规律只受轻声两字组变调规律的制约，与语法结构无关；叠音词的变调规律自成系统。

Just the desktop to open the newly created new text document and then type: rasdial broadband connection wzl.8878888 1234567 (to remind you once again: a broadband connection, your dial-up points on the desktop name of the program, if the name of your dial-up procedure is that adsl here fill out a broadband connection on adsl, wzl.8878888 broadband dial-up account, broadband dial-up password is 1234567, please fill in correctly) and then save the file you point to the file name and then enter adsl.bat points can be saved, and this time we will find more than a desktop adsl.bat the batch file, see (in particular, noted that: adsl.bat in the adsl is just my own take of a batch file name, of course, you can easily check, for example, lan, broadband dial-up, such as the name can be).

打开刚刚桌面上新建立的新建文本文档然后输入： rasdial 宽带连接 wzl.8878888 1234567 （再次提醒大家：宽带连接，是你点桌面上的拨号程序的名称，如果你的拨号程序名称是adsl那这里的宽带连接就填写adsl，wzl.8878888是宽带拨号帐号，1234567是宽带拨号密码，请都正确填写）然后大家点文件另存为然后在文件名里输入adsl.bat点保存就可以了，这个时候大家会发现桌面上多了一个adsl.bat的批处理文件，请看（特别注意的是：adsl.bat里的adsl是我自己随便取的一个批处理文件名，当然大家可以随便取，比如lan，宽带拨号，等名字都可以的）。

Lid done with stainless steel plate floor, built-silicate insulation, Furnace Door size 350 mm wide, 580 mm high, the overall lateral wall elevate electric holding furnace door, Furnace Door closure of the Furnace Door as a whole round , Furnace Door sealing performance enhancements, dial made of stainless steel by 1600 m / m turntable, used to load the workpiece, the entire wheel of the plane is not division, the operator can be stacked workpiece, as dial-rotation every 40 minutes a week , when the operator can not see dial in almost rotation, and Furnace Door open the larger operators can be arbitrary and out of the workpiece, and without time limits can dial in 20-60 minutes a week to arbitrary rotation speed, regardless of Furnace Door hoist, from the start of work on the dial continuous rotation, and there was no need for chain hoist Furnace Door, the need to stop rotating, just press the control cabinet, stop button, the gate Furnace Door, operators to seize its own, activated installed in the furnace door open and close button.

炉盖采用不锈钢板做底板，内置硅酸铝保温，炉门尺寸宽350mm，高580mm，侧墙体中整体向上提升式电动保温炉门，炉门关闭时整个炉门为一个圆形整体，炉门密封性能增强，转盘采用不绣钢制成1600m/m转盘，用以承载工件之用，整个转盘为平面不分工位，操作人员可以任意堆放工件，由于转盘每40分钟旋传一周，工作时操作人员几乎看不到转盘在转动，加上炉门开的较大，操作人员可以任意进出工件，而不受时间限转盘可以在20--60分钟旋转一周的时间任意调速，不论炉门启闭、转盘从启动工作就不间断的旋转，没有任何必要与炉门启闭进行联锁，需要停止旋转时，只需按下控制电柜上的停止按钮即可，炉门的启闭，由操作人员自行掌握，按动安装在炉门边的启闭钮即可。

The first direct measurement with micrometer piston skirt and the outside diameter Do micrometer stop screw to the locking plate position, and then dial indicator card installed and well well inserted under the initial installation of the amount of cards, directly into the cylinder corresponding cylinder kit, adjust the volume of the cylinder rod out in table inserted length, so that small hands dial indicator cell has about 1 volume of pre-press and lock locking rod inserted mother, at the same time, large dial indicator dial to adjust zero, the last cylinder to adjust the volume of good form under test card inserted rods and do at Anvil micrometer and measured the rod between the big hands dial indicator at this time than the "zero" high value is the piston and cylinder liner with the space.

3先直接用千分尺测量活塞裙部的外径并将干分尺止动螺钉扳转到锁紧位置，再将卡装好百分表和初步安装好插杆的量缸表直接卡入对应气缸套内，调整量缸表插杆的伸出长度，使百分表的小表针有1格左右的预压量并锁紧插杆锁母，同时将百分表的大表盘调整到零，最后将调整好的量缸表的测杆和插杆卡在干分尺的砧座和测杆之间，此时百分表大表针比&零&高的数值即为活塞和气缸套的配合间隙。

Sport watch, Swiss-Made automatic movement displaying 6-hour, 30-minute and 60-second subdial, Main dial polished silver-tone hour/minute hands with luminous accents and polished chronograph-seconds sweep hand, Subdials displayed by silver-tone hands, Main dial applied and polished silver-tone luminescent baton markers, White Arabic numbers/indices mark subdials, Red/white numbers and white indices mark outer minute track, Analog date display at 3, Polished silver-tone stainless steel round bezel and case with raised design at case sides, Polished screw-in crown and steel pushers, Stainless steel screw-in 'skeleton' caseback, Sapphire crystal, 200 meters/660 feet water resistant.

运动手表，瑞士制造的自动运动显示6小时，30分钟和60秒的表盘，抛光银主拨号音小时/分钟双手发光口音和抛光计时，秒扫手，Subdials显示的银色色调手，主要应用于拨号和抛光银双色荧光指挥棒标记，白色阿拉伯数字/指数马克subdials，红/白，白指数的数字标记外分钟跟踪，模拟3日期显示，抛光银双色不锈钢圆形边框并设立案件提出了设计方面的情况，抛光螺钉在'在冠和钢铁顶推船，不锈钢螺钉骨架'表壳，蓝宝石水晶，200 meters/660英尺防水。

First, sound: O of the short tone, it is only a long tone o shortened to pronounce in English, and American short tone o sound and short tone picture very of English, long tone have r usually suffixation of a nonsyllabic like that that picture speak in the previous section behind the o at the same time, not had has been turned into the pronunciation of o of a short tone automatically.

一是音：短音的o，英语中发音仅仅为一个缩短了的长音o，而美式的短音o听起来和英语的短音很像，同时长音o后面如果有r都通常像上一段里说的那样儿化了，没有的话（如plausible， applause）就自动变成了一个短音的o的发音。

Phonological tone change, the commonly mentioned tone sandhi, is tone change produced by the phonological interaction among syllables, like Beijing dialect's first syllable tone change in "tone II + tone II" contexts i.e.

语音变调，即一般所谓的连读变调，是因音节之间的语音关系而产生的变调，如北京话&上声+上声&时前字的变调。

Company business scope: Metric plug plug plug left teeth straight plug, such as Brandt Gauge Metric ring ring ring teeth left straight Brandt ring ring gauge, such as dedicated short taper gauge cone gauge Mohs gauge needle, such as three types of vernier caliper caliper caliper with standard digital calipers, such as depth micrometer caliper micrometer outside diameter micrometer inside diameter micrometer micron micrometer scale, such as lever-type dial indicator dial indicator inner diameter dial indicator digital display dial indicator, such as Square Block-type wide angle square-foot knife-edge knife-edge angle square feet omnipotent point of view, such as meter-type coordinate measuring machine single lever gear comparator block welding inspection regulations, such as foot and other workers?

本公司经营范围：塞规公制塞规左牙塞规直管塞规布氏塞规等环规公制环规左牙环规直管环规布氏环规等专用量规锥度量规短锥量规莫氏量规三针等卡尺类游标卡尺带标卡尺数显卡尺深度卡尺等千分尺外径千分尺内径千分尺内侧千分尺微米千分尺等量表类百分表杠杆百分表内径百分表数显百分表等角尺类宽座角尺刀口尺刀口角尺万能角度尺等量仪类单坐标测量仪杠杆齿轮比较仪焊接检验尺等块规及其他工？

To address this situation, I believe that the operation could be improved on are: the installation and adjustment of measuring, the first sub-scale do to adjust the nominal cylinder liner size, and then dial indicator card installed and well well inserted under the initial installation of the traffic card directly into the cylinder table by measuring the smallest cylinder liner wear, the cylinder table adjust the volume of the extended length of rod inserted, so that the volume of the dial indicator cylinder table has small hands around 1.5-2.0 preloading cell volume and cylinder volume table mother under lock locking plug, the final table and then measured the volume of cylinder rod and rod card inserted at the anvil micrometer measuring bar between the seat and the large dial and adjust the dial indicator to zero.

针对这种情况，笔者认为，操作上可改进为：安装和调整量具时，先将干分尺调整到气缸套的公称尺寸，再将卡装好百分表和初步安装好插杆的量缸表直接卡入所测气缸套磨损最小处，调整量缸表插杆的伸出长度，使量缸表的百分表小表针有1.5-2.0格左右的预压量并将量缸表的插杆锁母锁紧，最后再将量缸表的测杆和插杆卡在千分尺的砧座和测杆之间并将百分表的大表盘调整到零。

Methods Clinical data of 3 cases of bile duct injury during laparoscopic cholecystectomy were analyzed retrospectively.

回顾总结3例LC术中胆管损伤的临床资料，分析3例胆管损伤的原因及对策。

These techniques are applied to the gobang.

本文将这些技术用于五子棋中。