查询词典 deviation factor

The results revealed that 1% deviation of scale factor in a certain axis would result in an angle error of about 17′,and the reading error cause...

研究表明，某轴测量通道1%的比例因子偏差将造成约17′的读取姿态误差，电极轴不正交造成的读取误差与不正交的程度约在同一数量级。

Data collected from the questionnaires were analyzed by the number of distribution, percentile, mean, standard deviation, t test, factor and multiple regression to prove the hypotheses.

所得资料以SPSS套装软体进行分析，使用的统计方法包括：次数分配、百分比、平均数、标准差、t考验、单因子变异数分析、二因子变异数分析。

Thus, we can avoid the deviation which the subjective factor will bring possibility when actual operation is carried out during the logistics delivery performance appraisal.so we can expect a more comprehensive, accurate and objective result.

从而，在物流绩效评估实际操作时将避免主观因素可能带来的偏差，评估结果将更为全面、准确、客观。

Comparing response function curves of array induction logging in straight hole with that in deviated well, it shows that deviation angle is an important factor which obviously makes response function value smaller and malformed.

通过垂直井与斜井条件下的响应函数曲线的对比，进一步表明井斜角是造成阵列感应测井响应函数值明显变小和曲线畸形的重要因素。

In 8 sets of experiments, the average of angular deviation is reduced by a factor of 7.3, minimal correction error is 0.009 degree and mean correction error is 0.02 degree.

在八组实验中，角漂平均减小了7.3倍，最小修正偏差0.009°，平均修正偏差0.02°。

The results showed that if calculated according to the CaO standard deviation,the blending factor of raw meal homogenization silo was 1 only,far blow the design value(6~8);while calculated according to the KH sta...

结果表明，以CaO标准偏差计算的生料均化库的均化系数只有1左右，远低于6￣8的设计值；以KH标准偏差为统计指标计算的生料均化库均化系数为1￣1.5，窑系统均化系数为1￣2。

At the same time it is shown the population dissociation coefficient method is abetter calculating method for structural reliability in solid rocket motors and themajor factor affecting structural strength reliability is the standard deviation.

在置信度为0.90时，其结构可靠度大于0.9954。同时表明总体变异系数法是较佳方法，影响结构可靠性的主要因素是样本标准差。

Drilling track is key factor which decide trenchless success or failure , but controlling drilling track stay around rectifyed phase at the present .guided the theory of force is the key affectting the drilling track ,the paper discuss primary factors on contralling drilling track ,and advance the formulary ahout reckoning deviation force and azimuth force ,expect to achieve the aim that drilling track were controled real time and be anticipated , and have the initiative on drilling track contaolling .

岩层钻进轨迹是决定非开挖成败的关键因素，目前对钻孔轨迹的控制仅仅停留在被打纠偏层面上，本文在力是影响钻进轨迹本质因素理论指导下，对影响岩层钻进轨迹控制的因素进行了理论探讨，并针对造斜力和变方位力提出了计算模式，希望最终能实现钻孔轨迹的实时监控与调整，变被打纠偏为主动钻进。

Also, the performance of four techniques, using different approximation to estimate the equivalent peak value of shear stress and strain were investigated for the purpose to determine the equivalent shear modulus, damping, excess pore water pressure and residual strain induced by seismic loading, in which the equivalent peak value was computed in terms of its standard deviation and the corresponding peak factor.

利用上述动力有限元程序分别对水平地基进行了总应力、不排水有效应力和排水有效应力随机动力响应分析，并通过4种不同的方法来计算地基的等效剪切模量、阻尼比、振动孔压和残余剪应力。

The standard deviation of factor, regerssion equation and correlation coefficient between estimated and actual leaf area all demonstrated the adequency of the model The leaf length and width were used to calculate total leaf area per plant for Phalaenopsis white hybrid grown in phytotron at various day/night temperature After 9-month experiment, plants grown at 30/25℃ increased 1.4 and 3.8 times total leaf area compared with plants grown at 25/20℃ and 20/15℃, respectively.

由於检定有共同斜率之存在，故不计大小可求得共同估值的0.825，并由常数之变异范围、叶面积估值与实际叶面积之廻归方程式及相关系数确知其适用性，以叶面积估算决比较不同温度对白花蝴蝶兰生长之影响，则不论叶幅、叶面积增加量、长叶率均以日／夜温30／25℃增加量最大，其叶面积增加量为25/20℃之1.4倍，20/15℃之3.8倍。

In the negative and interrogative forms, of course, this is identical to the non-emphatic forms.

。但是，在否定句或疑问句里，这种带有"do"的方法表达的效果却没有什么强调的意思。

Go down on one's knees;kneel down

屈膝跪下。。。下跪祈祷