查询词典 design of experiments

The method of orthogonal design is applied in the DOE, and the experiments are simulated. The results are analyzed with the analysis of regression to study the effect of the drive and fuel economy performance by the factor of drive train parameters.

对动力传动系统参数进行试验方案设计，对试验方案进行动力性和基于循环工况的燃油经济性模拟计算，采用回归分析的方法对试验结果进行处理，研究了试验因子及其交互对试验指标的影响，并对参数进行了预测和优化。

Secondly, the design strategies, which can give attention to two or more things about summer-hot and winter-cold, of several key factors, such as the sunward, the form , the space and the skin were collated on the base of the former research and experiments with the writer's thoughts and analysis on the potential and the problems which the solar energy utility is facing, However, architecture is not the simple combination of accessories, but the integration of art and technology.

接着，通过对夏热冬冷地区利用太阳能的问题与潜力的分析和思考，总结前人工作、研究的实践，结合本人专业学习、专业实践和实地调研，对夏热冬冷地区多层住宅的朝向、体型、空间、表皮等住宅设计的几个重要要素提出了同时兼顾夏季被动式降温、冬季被动式采暖的设计策略，试图以变化的、科学的、切实可行的设计手法满足夏热冬冷地区多层住宅节能的需求。

By the design and practice of synthesization and token experiments of styrene series polymer, the student's comprehender to the reaction mechanism of macromolecule chemistry, the performance and polydispersity of polymer were intensified.

通过对苯乙烯系列聚合物的合成及表征实验的设计与实践，使学生加深对高分子化学反应机理、高聚物的性能及多分散性的理解，使实验内容与课堂教学内容有机结合，培养学生综合实验能力

In this paper, several traditional models for computing are introduced at first. Conferring probability theory, the load boundary condition of that collector is analyzed, the characteristic values of Tubesheet in different design reference periods are computed. Based on homogenization method, after lots of numerical experiments, the mechanical characteristic of Tubesheet controlled different structure parameters is studied, and an empiristic formulas that could simplify Tubesheet to stiffen plate is gained. Then, G-M method is employed and Tubesheet is simplified to a normal plate.

本文在总结传统计算方法的基础上，参考概率设计方法，分析了大型袋式除尘器的荷载边界条件，计算了不同设计基准期下的花板可变荷载标准值，结合均匀化方法，通过大量数值实验，得出了不同参数对花板受力性能的影响规律，并拟合了将花板简化为加劲板的经验公式，再参考正交异性板法，最终推导了花板简化为均匀平板的经验公式。

The orthogonal test design was used to arrange sequent experiments to test the effect of the four main factors,i.e.,consistency of ethanol,times of reflux,extraction time and temperature on the concrete yield of Lysimachia foenum graecum Hance,and to establish the optimal extraction conditions.

用 L9(34 )正交设计法进行灵香草浸膏的提取试验，研究乙醇浓度、提取温度、提取时间、回流次数对浸膏得率的影响，确定提取灵香草浸膏的最佳条件后，再对所得粗产品进行脱色试验，优选出粗浸膏脱色的最佳条件。

In order to further investigate the relationship of SP and ESCs, we design two level experiments —in vitro and in vivo. In vivo, firstly, We establish the nomal rat full-thickness wounds model, and employ integrin β1 keratin 19(K19)、 keratin 15(K15)、 Brdu as ESCs markers to conform the existence of ESCs in the granulation tissue of Group Capsaicin (rats were subcutaneously injected capsaicin pre-injury to damage sensory neuron and block the secretion of neuropeptides), Group Control, and Group SP (rats were injected SP in the wound postinjury). Secondly, as diabetic skin lacking of SP due to extensive pathological changes of sensory ending, we make a hypothesis:one of the main reason of unhealing wounds on diabetic patients could be insufficient SP which lead to fewer ESCs recruitment around wounds.

在此基础上，为进一步验证P物质促进表皮干细胞向肉芽组织中募集这一重要发现，本研究首先利用β1整合素、K19、K15等干细胞标记物以及干细胞慢周期性的特点，分别在体观察了正常皮肤伤口愈合过程中SP组、辣椒素组采用特异性感觉神经毒性药物辣椒素(capsaicin皮下预注射化学性除去感觉神经从而阻止神经肽分泌、对照组肉芽组织中表皮干细胞分布特点；其次，糖尿病患者皮肤存在周围末梢神经的损伤和神经肽含量的下降，这是否会导致糖尿病皮肤伤口创缘表皮干细胞募集不足，继发伤口难愈？

The design was optimized for maximum signal intensity by simulation and experiments. The size of focal spot in the micro-channel capillary was optimized. Fluorescence signal was enhanced 2～3 times when increasing the diameter of focal spot from 10μm to 50μm (full of the inner wall of capillary), through which the sensitivity and signal-noise ratio were also improved. A technique of using refractive matching liquid was presented. The fluorescence signals were boosted up and the signal collection efficiency was also meliorated when using this method.

通过理论分析和实验优化本系统的设计：优化聚焦于微通道中的激发光斑大小，增大聚焦到毛细管内径中的激发光斑尺寸，使光斑尺寸由最小的10μm增大到50μm，光电倍增管接收到的荧光信号提高了2-3倍，从而提高系统的信噪比和灵敏度；提出在聚焦物镜处加折射率匹配液的方法，加匹配液后的荧光信号得到了增强，因而提高了荧光收集效率和灵敏度。

On the base of comparatively analysis about various design method to piles cap, a new compound material——steel fiber reinforced concrete is first applied in piles cap. The modeling experiments on 9 three-pile caps and 15 four-pile caps specimen are carried on, the mechanic characteristic of piles cap and obvious effect of adding steel fibers into concrete are analyzed in detail, which provide reliable experimental basis for establishing the loadtransferring model of piles cap.

在分析比较各种有关承台设计计算方法的理论体系后，首次将钢纤维混凝土这种新型复合材料应用于桩基承台进行理论研究，并基于9个三桩承台和15个四桩承台的模型试验，详细分析了承台的力学性能，以及钢纤维的掺入对提高构件承载能力，延缓裂缝开展，有效降低承台厚度等方面的显著影响，为桩基承台传力模型的建立提供可靠的试验依据。

The rolling experiments were performed in the rolling mill of laboratory with lead, the roll pass scale is 1:5 according to the actual size of 310 Z shape steel. The effect of rolling design and the reduction to the molding of the 310 Z shape is the topic of the research works. We can conclude that the

本文针对孔型系统，将孔型缩小为实际尺寸的1/5，利用实验轧机轧制铅试样的实验方法，研究了孔型形状参数、道次压下量等因素对310乙字钢成型的影响，为改变孔型系统、提高产品质量提供了解决的方向。

In the Royal Chemical Industry Company is located in Huddersfield and Grangemouth trap performance of industrial plants for up to 7 years of monitoring and experiments, a laboratory in the two manufacturers of steam traps of steam loss of performance and monitoring of fresh and experimental basis, the Royal Chemical Industries ultimately its "design guidance" in the selection of the contents of the trap has been modified.

在对英国皇家化学工业公司位于Huddersfield和Grangemouth工业厂的疏水阀性能进行长达7年的监测和实验，一级在两家生产商实验室进行的疏水阀性能和新鲜蒸汽损失的监测和实验的基础上，英国皇家化学工业公司最终对其《工程设计指导》中有关疏水阀选型的内容作了修改。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。