查询词典 depth

Preload condition, the cylinder head bolt-hole depth of deformation of the cylinder sets a great impact on the proper cylinder head bolt hole depth Shen cylinder liner to reduce the deformation.

预紧工况下，缸盖螺栓沉孔深度对气缸套变形影响很大，适当的缸盖螺栓沉孔深度有利于减小气缸套变形。

Except for three hilts, which have dislocated G interface and extended down to the bottom interface (whose depth is about 10km) of the upper crust, the other faults have ended above G interface at 3 to 5km depth, or have converged at G interface.

其中，除3条断裂错断结晶基底并向下延伸至上地壳底界面外，其他断裂均在深度3~15km以上终止或收敛于G界面之上。

Science and technology have been powerful impetuses to economic development. To comply with the trend of social development, we should pay attention to in-depth Sci-tech news report. As print media, there are extraordinary advantages for newspapers in the field of in-depth report.

开展科技新闻深度报道是各类媒体顺应时代进步的要求和科技新闻传播不断发展的趋势，而报纸媒体在科技新闻深度报道方面有着独特的优势。

The article,taking Gan Jianhua′s The Iron-willed Sword and GoodPerson Under Heaven for examples,inquires into the depth of in-depth reports which rests with the choice of the cultural perspectives of the reporter.

文章以甘建华两本新闻作品集为例，探讨深度报道的深度在于作者文化视角的选择。

To validate the above conclusion, a series of mixture tests were performed and different samples were made by mixing each of three kinds of nature silt and the nature clay with different mixture ratio. The liquid-plastic limits of all the samples, in which the clay particles content were between the nature silt and the nature clay, were attained using the combined test method. The results showed that the lowest clay particles content of the silt, when it was suitable with the combined test method, is 12% to 15% with little differences. If the point of 3～4mm depth of penetration of fall cone exist, and the loglog relationship between the depth of penetration of fall cone and the water content of all the points were clearly linear, it could be concluded that the clay particles content of the sample is over the lowest value when the combined test was suitable.

3其后为了进一步验证所得结论，针对三种粉土，分别与一种黏粒含量较大的天然黏土进行多种组合的配比试验，配比后的土样其黏粒含量均介于原粉土与原黏土之间，并对各种配比后土样进行联合测定法确定液、塑限的试验研究，得出各种土对联合测定法适用的最低黏粒含量限值因粒径组成不同、矿物组成不同等因素，存在微小差异，在12%到15%之间；当圆锥下沉深度在3～4mm之间的试验点存在，且与其他试验点之间能形成良好的双对数直线关系，即认为土中黏粒含量超过该土对联合测定法适用的最低限值，联合测定法适用。

The best turning tools and parameters of lathe manufacturing magnesium alloy chips are the 31003C with depth of cut 3.5mm and amount of feed 0.4mm, and the 31303C with depth of cut 3 mm and amount of feed 0.3mm.

车床制备镁合金屑料的最佳刀片为31003C刀片和31303C刀片，对应的最佳参数分别为切削深度3.5mm，进给量0.4mm以及切削深度3mm，进给量0.3mm。

At the mean time, for P2 and P3 instrumentation points which located at the depth of 2.5 m below the mid-slope surface and at the depth of 3 m below the slope top respectively, the pressure head remain negative and this indicates both points are still situated at the unsaturated zone in between the soaking line and groundwater table.

在此同时，P2监测点(坡面中点下方2.5 m)及P3监测点(坡顶下方3 m)之压力水头则仍维持负值，此显示两监测点周围区域仍处於浸润线与地下水水位线间之未饱和区。

Shallow moonquakes are located at depth of about 50-220 km, they are strong but rare, and with high-frequency. Deep moonquakes are located at the depth of about 700-1150 km, and occur as clusters related with the tidal stress between the Earth and the Moon.

月震按震源深度分布分为浅源月震与深源月震，前者的震源深度大约为50~220km，释放的能量较大但发生次数较少，记录信号以高频成分为主；后者的震源深度大约为700~1150 km，并具丛集性，与潮汐应力有关。

Studies on various mineralization marks reveal that in Yuerya Au deposit mineralization would be intensified to and gold grades gradually less variated to depth thus it is potential for further prospect to depth.

对各类矿化标志的研究表明，峪耳崖金矿床金矿化强度向深部逐渐增高，金品位值的变化向深部逐渐变小，深部找矿远景很大。

Compared with no-tillage, subsoiling reduced the water consumption of oats in the 0-50 cm depth and increased the water consumption in the 50-100 cm depth.

与对照相比，深松减少了0~50cm的作物耗水量，促进根系对50~100cm土层土壤水分的消耗。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。