查询词典 depth of penetration

Furthermore, the deposition rate increases per unit of welding current by decreasing wire diameter, and adjustment of the penetration depth is enabled by alternating current wave form and polarity.

减少焊丝直径，能提高熔敷效率，再加上使电流波形交流化，就可以调整熔深。

According to research, velocity and angle of incidence plays an important part in penetration depth.

研究表明：速率和着角对侵彻深度具有重要影响。

Ionized helium at least, the density minimum, it can quickly disperse from the metal bath of metal vapor produced by an increase, so to use helium as shielding gas, the plasma will be to maximize the suppression, thus increasing the penetration depth, improve welding speed.

氦气电离最少，密度最小，它能很快地驱散从金属熔池产生的上升的金属蒸气，所以用氦作保护气体，等离子体将被最大程度地抑制，从而增加熔深，提高焊接速度。

The computational results of the penetration depth are in agreement with the experiments.

数值模拟的最终穿深计算结果与实验一致。

Of a particular food determine microwave penetration depth, heat capacity,...

某食品确定微波穿透深度，热量，。。。

Generally speaking, a certain diameter of the laser beam penetration depth as the beam power increases.

一般来说，对一定直径的激光束，熔深随着光束功率提高而增加。

The relationship between parameters of airborne laser bathymetry and its maximum penetration depth is discussed.

以确定的参量建立的系统具有白天 4 9m和晚上 6 5m的最大测深能力，可完全满足在沿岸带以及岛礁的测量要

To the relatively small thermal penetration depth within the workpiece and the continuous removal of grinding chips.

由于在工件内相对较小的热渗透深度和不断去除的磨削碎片

The increment of weld penetration depth caused by heat sources distance is the most, which is 55%, and the effects of wire stick-out and laser defocused distance on the weld depth are also stronger.

其中，热源间距对熔深的影响最大，不同间距处的熔深增幅高达55％，焊丝干伸长和离焦量对焊接熔深也具有较强的影响。

From 2004 to 2007, 34 cases were treated with extrapedicular screw fixation in Department of Orthopaedics, Third Affiliated Hospital of Sun Yat-sen University. The screw entry point, angle, depth and diameter were measured and defined on the thoracic vertebrae pedicle by CT thin-slice scan in standard prone for all cases before operation. The screw entry point was located at the tip of transverse process. The average inclination angle should be 10°-20° headward and 30°-40° toward neutral line respectively. The screw was inserted and entered into the vertebral body along the external cortex of pedicle. The integrity of cortical bone around screws, the distance to segmental blood vessels and the penetration of cortex were observed after operation to evaluate the accuracy and safety of screw placement.

应用椎弓根外内固定技术2004/2007年在中山大学附属第三医院骨科治疗34例患者，固定前采用CT加密扫描测量进钉点、进钉点至椎体前缘的深度、进钉角度和直径，固定中椎弓根钉入点为横突尖，进钉方向为平均向头侧倾斜10°~20°、与中线成角30°~40°，顺椎弓根外侧皮质进入椎体，固定后CT加密扫描观察螺钉周围的皮质骨是否完整、是否靠近节段血管、是否穿透皮质骨，评价置入钉的准确性和安全性。34例患者共置入160枚胸椎椎弓根螺钉，固定后CT加密扫描和X射线片观察到148枚(92.5%)螺钉置入准确，12枚(7.5%)螺钉发生错置。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。