查询词典 degree scale

If the tooth leads small, ex- tooth tooth cleft(the ≤ 2 mms), the whole the tooth light degree arrives a mid-degree fluorine spot tooth, the whole the tooth light degree is four wreaths plain tooths, the tooth changes countenance separately, the tooth light degree arranges not and together separately, and the external injury tooth jot breaks.

如牙齿过小，前牙牙齿间隙（≤2mm ），全口牙齿轻度到中度氟斑牙，全口牙齿轻度四环素牙，个别牙齿变色，个别牙齿轻度排列不齐，外伤牙齿少量折断。

From the point of microstruction,bamboo volume fraction of bundlesheath,single bundle sheath area,fiber width,cell wall thickness increase withthe growth of age,fraction of cell wall changes like density,increases with thegrowth of age,the 2 age-degree bamboo is the biggest.The reason why 2 age-degree fraction of cell wall more than 3 age-degree bamboo is the former has thegreater fraction of parenchyma;1 age-degree bamboo has the greatest fiberlength,fiber length and width ratio and vessel length.The difference in bamboofiber length,vessel length and width among other age-degrees is not distinct.

从构造角度来说，竹材的纤维束比量、单个维管束纤维束面积、纤维宽度、胞壁厚度随着年龄的增大而增大，胞壁率随年龄变化规律与密度相似，随年龄增大而增大，以2度竹最大，2度竹胞壁率比3度竹大主要由于薄壁组织比量较大所致；纤维长度、纤维长宽比、导管长度以1度竹最大，其它年龄纤维长度、导管形态变化不明显。

Through comprehensive comparison,during the growth from 1 age-degree bamboo to 2 age-degree bamboo,density, mechanical strength(except maximum tensile strength etc.),fraction of bundle sheath,cell wall ratio,crystallinity,cellulose content and lignin content increase rate are the greatest.3age-degree bamboo has higher strength,strength and gravity ratio andcrystallinity are the biggest,fraction of parenchyma is small and insect-resistant.2 degree bamboo has the greatest mechanical strength,but its strength andgravity ratio is not the highest and its crystallinity is lower than 3 age-degreebamboo due to its greatest fraction of parenchyma,loss tangent value is thebiggest.Its creep character is not good and is easily eaten by moth.

通过综合比较，竹材从1度竹到2度竹生长过程中，密度、力学强度、纤维束比量、胞壁率、结晶度、纤维素含量、木质素含量等指标增加幅度是最大的。3度竹强度较高，强重比、结晶度最高，薄壁组织含量较小，相对抗虫蛀，材质最好，适合材用。4度竹结晶度下降引起强度的下降，但薄壁组织组织比量最小，相对最抗虫蛀。2度竹力学强度最大，但是强重比并不是最大，结晶度比3度竹低，由于薄壁组织组织比量最大，内耗值最大，蠕变性能较差，同时相对易遭虫蛀。

Designing space mechanism run into question at first is that correct to confirm space degree of freedom of organization, but calculating many degrees of freedom, seal more ring, harmony wave gear wheel organization, space degree of freedom of organization of mixing with traditional degree of freedom must be very tedious; Calculating general form seal ring low packs of space degree of freedom of organization can be limited greatly too.

设计空间机构时，首先遇到的问题是要正确确定空间机构的自由度，然而，用传统空间机构自由度公式去计算多自由度、多封闭环、谐波齿轮机构、混合型空间机构的自由度时，必须进行变换；计算一般单封闭环低副空间机构自由度时，也会受到很大限制。

B: inner hole standard 54mm, outer diameter 127-160mm or so, various specifications of rolling screws, have modulus rolling rolling round the main motor shaft, fan shaft, worm and other products. C: Three-axis rolling wheels, the standard inner hole 25mm, 25.4mm, 35mm, 40mm, the main hollow tube rolling system, useful connections, art lamp, lighting tube teeth, elbows and so on. D: Automatic lathe accessories: cam, chucks, manual folder, Block, Block, steam-driven folder, sub-degree steam-driven clip seat, horizontal holder, manual horizontal sub-degree holder, a horizontal steam-driven sub-degree Block folder, sub-degree vertical folder manually Block, cylinder folder, CNC lathe tool, diamond grinding wheel, belts, metadata rods, measuring, activities Cam Block, feed rod, dental tube, Grinding, automatic lathes, table lathes, Rolling machine and so on...

产品采用进口钢材合金钢，高速钢专业材料，质量稳定精度高。A：二轴式台湾机型专用3T滚牙轮内孔标准50.5mm，外径90-100mm左右，台湾进口滚制各种规格之螺丝，还有各种直纹，网纹滚丝轮等。B：内孔标准54mm，外径127-160mm左右，滚制各种规格之螺丝，还有模数滚丝轮主要滚制电机轴，风扇轴，蜗杆等产品。C：三轴式滚丝轮，内孔标准25mm，25.4mm，35mm，40mm，主要滚制空心管件，管用接头，美术灯管，灯饰管牙，弯管等等。D：自动车床各种配件：凸轮，夹头，手动夹座，汽动夹座，分度汽动夹座，卧式夹座，手动卧式分度夹座，卧式分度汽动夹座，立式手动分度夹座，筒夹，CNC车刀，钻石砂轮，皮带，元棒，量具，活动凸轮座，送料杆，牙管，磨刀机，自动车床，桌上车床，滚牙机等等。。。

The primary radiation reaction is marrow depression, and primary lung radiation reaction. There are 8 marrow depression cases in these groups,(degree Ⅰ: 5 cases, degree Ⅱ: 3 cases). Leukocyte and haematoblast decreased in these cases. Primary lung radiation reaction cases is 6(degree Ⅰ: 4 cases, degree II: 2 cases).

早期非小细胞肺癌的外科手术切除可以获得60%~70%的5年生存率，但是，一部分早期非小细胞肺癌患者因呼吸功能和心功能低下、糖尿病、血管系统疾病，一般状况差而不能耐受手术或术后不易康复，还有一些患者拒绝手术。

Finally, this paper carried out empirical study to the influential factors and economic consequences of financial behaviour of Chinese listed family firms from the perspectives of ROE, EPS, firm scale, growth rate, family share holding proportion, family control degree, circulated share proportion, stock equity concentration degree, stock equity discretion, board scale, external board member proportion, whether general managers hole the positions of board members, whether general managers are the family members, industry factors, district factors, by using hypothesis test, correlation analysis, regression analysis.

最后，论文从净资产收益率、每股收益、公司规模、成长率、家族持股比例、家族控制度、流通股比例、股权集中度、股权离散度、董事会规模、外部董事比例、总经理是否兼任董事或监事、总经理是否是家族内部人员、行业因素、区域因素等，应用假设检验、相关分析、回归分析等方法，对我国家族上市公司融资行为影响因素与经济后果进行了实证研究。

5 Degree of valve opening and closing valves open and close the display plate ① degree of scale line should be cast in the gearbox cover or change the direction of the display after the disc casing, all for the ground wire brush on the phosphor scale to show striking;② direct needle plate material in the case of better management of available stainless steel, or steel plate for the painting, do not make use of aluminum skin;③ direct drive needle eye-catching, stable fixation, accurate adjustment when opening and closing after Rivets should be locked.

4.5 阀门启闭程度的显示盘①阀门启闭程度的刻度线，应铸造在变速箱盖上或转换方向后的显示盘的外壳上，一律面向地面，刻度线刷上荧光粉，以示醒目；②指示盘针的材质在管理较好的情况下可用不锈钢板，否则氧气专用阀、铜阀门为刷漆的钢板，切勿使用铝皮制作；③指示盘针醒目，固定牢靠，一旦启闭调节准确后，应以铆钉锁定。

Valves open and close the display of the degree plate① valve opening and closing degree of the scale line should be cast in the gearbox cover or change the direction of the Globe Valves display after the disc casing, all for the ground wire brush on the phosphor scale to show striking;② direct drive pin, the material in the case can be better managed stainless steel, or steel plate for the painting, do not use aluminum leather production;③ instruction set pin striking, stable fixation, once the opening and closing After accurate adjustment should be locked rivets.

阀门启闭程度的显示盘①阀门启闭程度的刻度线，应铸造在变速箱盖上或转换方向后的显示盘的外壳上，一律面向地面，刻度线刷上荧光粉，以示醒目；②指示盘针的材质在管理较好的情况下可用不锈钢板，否则为刷漆的钢板，切勿使用铝皮制作；③指示盘针醒目，固定牢靠，一旦启闭调节准确后，应以铆钉锁定。

Rather, they deal with variables that are measured along a continuous scale and are recorded to some predetermined degree of accuracy Temperature, for example, may be measured to the nearest tenth of a degree on the Celsius scale, voltage may be measured to the nearest hundredth of a volt, and pressure may be measured to the nearest "pound per square inch" value.

模拟计算机处理在连续标度上测量的变量并按预先规定的精度进行记录。例如：测量时，温度可精确到1/10摄氏度，电压可精确到1/100伏，压力可精确到&磅／平方英寸&。

In the days of sailing vessels the crew were afraid they would be becalmed on the ocean.

在使用帆船的时代，船员们担心他们会因为无风而无法在海洋上航行。

As long as foreign donors pay the PA's salary bill, few expect a new intifada.

只要外国继续为巴权力机构的薪水买单，希望发动新暴动的人便寥寥无几。