查询词典 deflection

In this paper it is given a more effective formula about the direction angle of the main plane in the plane stress state.2. To introduce the principle and method for drawing 3-D graph with the compuer and for checking up with the computer cursor,to give outline of expressions of 3-D curve,outline of cursor meterage of well depth,well deflection angle and direction angle at any section.

介绍了在实践中总结出的计算机绘制与光标检测3维图形的原理和方法，给出了3维动态图形到屏幕坐标的变换式、各测点的平滑连接方法以及描绘与检测井眼轨迹曲线的典型应用，实现了空间井眼轨迹曲线的任意旋转、投影和给出了任一井段的井深、井斜角和方位角的光标检测软件。

The nanomechanical deflection of gene chip in Wu's experiments was predicted by minimum principle of energy.

其次，利用能量最小原理预测了Wu实验中基因芯片的纳米挠度响应。

With the mixing ratio getting smaller, the deflection was increased, which showed toughness getting better.

随着牙托粉与牙托水的比例越来越小，其挠度值逐渐增大，说明韧性越来越好。

Hence, the modulus of rigidity, G, of glulam was measured by vibration test method in order to realize the shear deflection effect. The E/G values of Japanese cedar, Taiwania, Douglas-fir, and southern pine glulam were ranged form 13.2 to 14.5, 14.6 to 16.6, 12.1 to 16.6 and 16.0 to 19.1, respectively. The pure MOE was also obtained. The Ep and MOR values of glulam were ranged from 10.6 to 13.4 GPa and 48.3 to 61.9 MPa for Japanese cedar, ranged from 12.1 to 15.0 GPa and 41.8 to 58.8 MPa for Taiwania, ranged from 10.5 to 16.4 GPa and 37.2 to 65.6 MPa for Douglas-fir, ranged from 14.5 to 20.6 GPa and 70.2 to 78.48 MPa for Southern pine, respectively.

而消除剪力挠曲影响，即可得集成材之抗弯弹性模数真实值与抗弯强度，依本研究配置所得之柳杉集成材之Ep值与MOR值分别为10.6-13.4 GPa与48.3-61.9 MPa；台湾杉集成材之Ep值与MOR值分别为12.1-15.0 GPa与41.8-58.8 MPa；花旗松集成材之Ep值与MOR值分别为10.5-16.4 GPa与37.2-65.6 MPa；南方松集成材之Ep值与MOR值分别为14.5-20.6 GPa与70.2-78.4 MPa。

The paper carries out mechanical analysis of the weight distributing of goods in loading container based on analysis of packing and tansporting environment, and draws the formula of the ratio of the weight of loading goods and the maximum loading weight W/W0, and the length distributing ratio of loading goods α=l/L under the condition that the bending quadrature produced by part load is within the range of the maximum bending quadrature. It also gives the graph that the sum deflection of mudsill and underside girder can reach high-point value with the length of bottom distributing varying, when the loading amounts of container of 20ft and 40ft are given. Furthermore, it provides the relation graph of an eccentric rate of loading goods and the allowed loading amount. For on-site safety loading work, it has certain guidance and reference value.

在分析包装件运输环境的基础上，对装载集装箱的货物重量分布进行了力学分析，得出局部负荷产生的弯矩如在最大容许弯矩范围以内时，装载货物重量与最大载货重量之比W/W0，同装载货物的长度分布率α=l/L的关系式；绘出了20 ft和40 ft集装箱在装货量一定时，随着货物底分布长度的变化，底梁和下侧梁之合计挠度达到极限值的曲线图；绘出了装载货物的偏心率与容许装货重量的关系图；对现场安全装载作业有一定的指导作用和参考价值。

The reasons of the multiple image's deflection and synthetic image's deformation are analyzed.

分析了导致多重像偏离和综合像变形的原因，并给出解决这一问题的关键技术。

The first is the connection between the changing electric field and the magnetic field. It arose from Oersted's experiment on the deflection of a magnetic needle and led to the conclusion: a changing electric field is accompanied by a magnetic field.

第一个是变化着的电场跟磁场相结合，它是从奥斯特的关于磁针发生偏转的实验中形成的，并且它得出了这样的结论：变化着的电场总是由磁场伴随着的。

In the second part, by using uniform design and orthogonal design methods, some groups of mix test of foam lightweight with different component are conducted, the test data is analyzed by neural networks model and regression model, and optimum mix proportion is obtained. Orthogonal design for mix material considering density factor is presented, as well as uniform design for mix material adapting to different density. The mechanic characteristics of foam lightweight material and engineering characteristics differing from general material under an allround press are founded. Through the analysis of asymmetry settlement for Doulong sluice and the comparison of correct deflection scheme, the foam lightweight material shows some advantages in the load reduction.

在泡沫轻质材料的研究方面，利用均匀设计和正交设计方法进行了几组不同组分的泡沫轻质材料的配方试验，利用神经网络模型和回归模型对试验数据进行处理，得出最优配方；提出了考虑密度因素的混料配方的正交设计方法和适合不同密度时的混料配方均匀设计方法；研究了泡沫轻质材料的力学特性，并发现了在围压作用下所表现出的不同于一般材料的工程特性；论文将上述研究成果用于斗龙港闸工程的处理设计，通过对该闸的不均匀沉陷分析和各种纠偏方案比较表明，采用泡沫轻质材料进行减载处理有一定的优越性。

Secondly, oscillation energy function of inter-area mode oscillation is defined which can be regarded as a measure of the deflection away from the steady state position during dynamic oscillation period.

分析了功率振荡过程中能量函数的变化，提出了衰减振荡能量的阻尼控制策略，目的是使系统暂态能量以最快的速度归零，即回到故障后的稳定平衡点。

The stall/spin test fly for one trainer has been conducted, which is a difficult and great risk project. It is studied in the test fly that entering stall/spin and the effect of all deflection surface on stall/spin and the effect of nose outshoot and gravity location and so on. Using the oscillatory type recovery control law recover successfully from flat spin.

在对某教练机进行的技术难度大、高风险的失速／尾旋试飞研究中，进行了失速／尾旋的进入方法、失速／尾旋的特征、改出特性的研究，同时研究了各舵面对失速／尾旋特性的影响、机头突出物的影响、重心位置等因素的影响，使用振荡型操纵规律成功地改出了平衡尾旋。

I am accused of being overreligious," she said in her quiet, frank manner,"but that does not prevent me thinking the children very cruel who obstinately commit such suicide.""

客人们在卡罗利娜·埃凯家里，举止就文雅一些，因为卡罗利娜的母亲治家很严厉。

Designed by French fashion house Herm è s, this elegant uniform was manufactured in our home, Hong Kong, and was the first without a hat.

由著名品牌 Herm è s 设计，这件高贵的制服是香港本土制造，是我们第一套不配帽子的制服。