查询词典 deceleration

It is one kind when when the automobile encounters the collision the abrupt deceleration can inflate very quickly the cushion aerocyst, may protect in the vehicle the crew member not to send hits in the compartment, is one kind of passive safety device.

它是一种当汽车遭到碰撞而急剧减速时能很快膨胀的缓冲气囊，可以保护车内乘员不致撞到车厢内部，是一种被动安全装置。

Aread B reading C reads D being readIt registers the severity of the crash by__6__the deceleration data from the airbag's sensor.

B。分析：空格处所在的结构作介词by的宾语，因此判断B合适。

Regarding the thermobaric explosive further tests, the research showed that the compressive stress was 6.699MPa; The tensile stress was 0.716MPa; Heat sensitivity was 288℃(5s); The anti-overload capacity may withstand 1.0×104g launch overloads and smaller than 2×105g the impact deceleration overload; first decomposition temperature was 251.9 ℃, highest exothermic peak temperature was 286.9 ℃; In the compatibility, except the ceresin and Oxidant, the ceresin and the F rubber, the ceresin and Al compatible rank could reach to second level of compatibility, the others could reach to the first level of compatibility.

对此粘结-钝感体系包覆的温压炸药样品进一步测试研究显示：抗压强度为6.699MPa；抗拉强度为0.716 MPa；热感度为288℃（5s爆发点）；抗过载能力为可承受1.0×104g的发射过载和小于2×105g的撞击减速过载；安定性为分解温度251.9℃，最高放热峰温度286.9℃；内相容性为除蜡类钝感剂+氧化剂，蜡类钝感剂+F橡胶，蜡类钝感剂+Al相容性等级为2级相容性较好外，其他组分间相容性均为1级，相容性很好。

Starchaser rocket science 1:00 (Do not look down on it 1:00), calls the precise attitude invincible until 7:00 (you need to 22:00), 7:00 Emergency soldiers, the military maniac blasting line break 7:00 precise attitude, reverse the hands of thorns study 2 point to the remaining points are added to sen University, at least study the blood claws 1:00 (blood furthest distance claw attacks, as well as the role of deceleration), God bless, curse, blessing the sacred places should be 7:00 or above in order to Fissidens village cut convenience, I have learned to噬魂surgery department of 1:00

追星箭学1点（千万别小看这1点），召唤的无敌修满7点为止（需要22点吧），战士冲锋7点，狂爆系破军修满7点，逆手刺学个2点即可，余下的点都加到仙系，血爪最少学1点（血爪的攻击距离最远，还有减速的作用），战神祝福，诅咒，神圣祝福应该学满7点（为了砍凤尾村长方便，本人学了地系的噬魂术1点

There are more than two dozen reported cases of lumbar facet dislocation after rapid deceleration injuries (e.g., traffic accidents), most involving L5 S1.61,112 115 The mechanism of injury in these cases is purported to be a combination of hyperflexion, distraction, and rotation.61,112,116 In a posthumous study conducted in 31 lumbar spines of subjects who died of traumatic injuries,Twomey et al.117 found occult bony fractures in the superior articular process or subchondral bone plate in 35% of victims, and z-joint capsular and/or articular cartilage damage in 77% of cases.

多项研究报道了急性减速伤后发生腰椎小关节分离，多数发生于L5-S1，其机制可能为过度屈曲，分离和旋转。在一项对死亡病例的研究中，Twomey 等发现，31例因交通事故死亡的人中有35%的腰椎上关节突或软骨下骨性终板存在隐匿骨折，77%存在小关节囊和/或关节软骨损伤。作者总结创伤后隐匿性股和软组织损伤也许是腰痛的来源。

There are more than two dozen reported cases of lumbar facet dislocation after rapid deceleration injuries (e.g., traffic accidents), most involving L5 S1.61,112 115 The mechanism of injury in these cases is purported to be a combination of hyperflexion, distraction, and rotation.61,112,116 In a posthumous study conducted in 31 lumbar spines of subjects who died of traumatic injuries,Twomey et al.117 found occult bony fractures in the superior articular process or subchondral bone plate in 35% of victims, and z-joint capsular and/or articular cartilage damage in 77% of cases.

多项研究报道了急性减速伤后发生腰椎小关节分离，多数发生于L5-S1，其机制可能为过度屈曲，分离和旋转。在一项对死亡病例的研究中，Twomey 等发现，31例因交通事故死亡的人中有35%的腰椎上关节突或软骨下骨性终板存在隐匿骨折，77%存在小关节囊和/或关节软骨损伤。

This design gives joltless startand stop, and continuous acceleration and deceleration, with a positioning accuracy within 1 o The Tomson-CSF design is similar to the AEG and ABB versions in certain respects, its unique feature is that oneside of the structrue isweighted.

在定位精确到1°之内的情况下，这种结构提供了无摇动的启动停止和连续的加速减速，汤姆逊—CSF的设计在某些考虑上与AEG和ABB的产品相类似。它的唯一特征是在其结构的一侧增大了重量。

In order to study theoretically the effects of complicated factors on traffic flow, by considering the drivers'sensitivity and prediction of forthcoming traffic situations, the deterministic deceleration step and the randomization one in the rules of the NaSch model are interchanged, which results in the sdNaSch model.

本文的工作旨在综合分析各种现有的交通流模型的基础上，提出更为符合实际的模型，并通过理论分析和数值模拟，探索交通系统中的各种非线性现象，特别侧重于交通流临界相变行为的研究，全文的工作由五部分组成

Take the 10~12ml single-valve capacity as the example, with flings turns the head to separate evenly, 36.000rpm 60 the hour, turns the head with the angle type to separate 45, OOOrpm 36 the hour, the former including adds the deceleration to use in common 130,000,000 revolution of actuation department lives, the latter must use 100,000,000 revolution of actuation department lives, this was 100 ~ 20,000,000,000 transfers to at that time the supercentrifuge total life looked, without doubt each time tests the expense to be excessively high, in addition the CsCl amount used are many, price expensive and so on factors, causes this kind of separation purification work to become the very expensive experiment.

以10~12ml单管容量为例，用甩平转头分离，36.000rpm 60小时，用角式转头分离45，OOOrpm 36小时，前者包括加减速在内共用去1.3亿转驱动部寿命，后者也要用去1亿转驱动部寿命，这对当时超速离心机总寿命为100~200亿转来看，无疑每次实验费用过高，加上CsCl用量多、价格贵等因素，使这类分离纯化工作成为非常昂贵的实验。

In this paper the nonstationary vibration behavior of an unbalanced rotor system, which is assumed to be bending flexible but torsionally rigid, during acceleration or deceleration through the critical speeds is investigated. Influencing factors such as gyrascopic effects, external and internal damping, Supporting mass, damping and stiffness, asymmetry of the shaft crass section as well as anisotropy of the supports are considered.

在理论分析方面，本文考虑了转子的陀螺效应，内外阻尼，轴截面的非对称性，支承的貭量、阻尼、刚度和支承的各向异性等因素的影响，使用分析动力学，建立起严格的运动方程，并考虑了弯曲自由度与转动自由度间的耦合，因而能较精确地分析和描述转子通过临界点时的非定常振动和转速变化規律。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。