查询词典 decalescence

The phase transition limit of the most of cooling medium is called as vaporization point. Along with the increase of decalescence of cooling medium, gas contents increases and degree of dry steam rises.

冷却介质主流发生相变的点称之为蒸发点，其后随着介质不断吸热，气态含量增多，蒸汽干度上升。

Firstly in this part the paper establishes three fibrin heat falling models: fibrin decalescence decomposition model; fibrin heat release decomposition model and burnt carbon heat release model.

论文第三章对在微重力环境下火焰传播进行了数值研究，建立了固体纤维素燃料热降解理论模型和火焰沿薄的纤维素固体表面传播理论模型。

Thermal expansion characteristic of semimetallic nylon composite (nylon 1010 packed metal oxide) was analyzed with thermal expansion appearance. The change of composite weight after being heated and decalescence / heat release of composite were analyzed by carrying TG-DSC experiment.

用热膨胀仪分析了半金属尼龙复合材料（金属氧化物填充尼龙1010）的热膨胀特性；通过进行TG-DSC实验，分析了复合材料在受热后其重量的变化以及吸放热情况。

The thermodynamic investigation of adsorptions shows that adsorption of CCTS to Pb~(2+),Cu~(2+),Cd~(2+),Ni~(2+) is spontaneous.Because the values of Gibbs free energy are negative and the calculated entropy values of interactions are positive.However the positive values of the variation in enthalpy show that besides chemisorption, other processes of decalescence, such as physical adsorption and swelling of CCTS were also involved.

CCTS对各重金属离子的吸附热力学分析结果表明：CCTS对各重金属离子吸附熵变△adsS为正值，并且吸附自由能改变量△adsG均为负值，说明CCTS对各重金属离子的吸附是自发进行的，但其吸附焓变△adsH为正值，说明CCTS对重金属离子的吸附不仅仅是化学吸附的过程，还伴随着其他如物理吸附、吸附剂溶胀等吸热过程。

The results show that the decalescence of catalyst bed affects the process of hydrogen peroxide catalytic decomposition greatly. If the catalyst bed is preheated or made up of materials with low thermal conductivity, that influence can be depressed. At the same time, the response characteristic of catalyst bed and the efficiency of catalytic decomposition can be improved. The low frequency pressure instability of catalyst bed occurs because of the coupling of catalytic decomposition and supplying. The decomposition plane pushes all the way through the catalyst bed during pressure oscillations, causing unreacted liquid hydrogen peroxide to be exhausted from the bed and leading to the appearance of liquid hydrogen peroxide channeling. Consequently, how to prevent or at least limit this channeling is the key to eliminate the pressure instability of catalyst bed. It was found that adding clapboard to the catalyst bed can depress the pressure instability efficiently.

结果表明催化剂床及催化剂的吸热对过氧化氢分解过程影响很大，对催化剂床进行预热或采用热导率低的材料制造催化剂床等措施，可以降低催化剂床壁面吸热对催化分解过程的影响，提高催化剂床的响应特性和催化分解效率；催化剂床的低频不稳定是催化分解过程与供应系统耦合产生的，催化剂床气体界面的波动过程中，液体过氧化氢穿透催化剂床形成过氧化氢液体通道，过氧化氢液体通道的产生和扩大是催化剂床不稳定的主要原因，也是消除催化剂床不稳定的关键，试验中在催化剂床内加入分流板成功地抑制了催化剂床的低频不稳定。

According to the composition of elements of fuel,thermochemical forms,combustion heat,and time-dependent relations of oxygen concentration acquired during fullscale tunnel fire experiment,the formulae are given for calculating di- mensionless burning rate, released heat rate ,and ratio of medium decalescence.

根据燃料的元素构成、热化学反应式、反应物和生成物的焓变以及燃烧过程中监测到的烟气中氧气浓度随时间变化规律，提出了计算某一时刻燃料燃烧速率、释热速率和介质吸热率的关系式；通过实际规模的火灾试验，对其数据的计算表明，对木质类巷道火灾，最大比燃烧速率为0.193，最大释热速率约为1～3.5 MW，介质的吸热率为22

It was found that the Polymeric Titanic Sulfate has a apices of decalescence at 150℃,and it changed into ivory-white powder of when sintering to 335℃, and the chemical formatis(SO_4); then it changed into yellow powder when sintering to 595℃, the Ti(SO_4)_2 andTiO_2 are found from XRD.

聚合硫酸钛升温到150℃有吸热峰；升温到335℃，形成乳白色的(SO_4)粉末状；升温到595℃，生成淡黄色Ti(SP_4)_2和TiO_2粉末状混合物。

Thus,in experiments of water mist flashover restraining, consideration only the mist decalescence in smoke and flame would be enough and doable.Nonlinear dynamics was chosen here for investigating water mist flashover restraining.

雾滴冷却汽油池火燃料表面效果不佳，因而在构建细水雾抑制轰燃预测模型时可以忽略燃料表面冷却，仅考虑雾滴在烟气层和火焰区的吸热效果。

Some conclusions were summarized as following: wood、 paper、 fabric and kitchen rubbish have the resemble pyrolysis characteristics; it is obvious that plastic"s decalescence happened during it"s pyrolysis process; the range of τ_max from great to small in sequence is plastic、 rubber、 fabric、 paper、 kitchen rubbish and wood.

其次，本文对垃圾典型组分的快速热解特性作了研究，并同程序升温时的热解特性作了比较，得到以下一些结论：木屑，纸屑，织物和厨余，其热解特性具有相似之处，微分转化率曲线均表现为单峰曲线；塑料在反应时存在较明显的吸热现象；τ_max(最大失重率所对应的时间)由大到小依次是塑料，橡胶，织物，纸屑，厨余，木屑。

The blend has following properties with 10 parts compatibilizer. The tensile intensity and elongation at break reach 35.66MPa and 23.58%, respectively, improving by 26.6% and 65.7% respectively compared with 0 part compatibilizer; The characteristic absorption peak of carbonyl at 1725～1800cm-1 disappear and the characteristic absorption peak of hydroxide at 3438～3440cm-1 increase induce the formation of hydrogen bond; The decalescence peak of blend increase by 2℃compared with the blend containing 0 part compatibilizer near 100℃; Lignin can be dispersed homogeneously to avoid reuniting of lignin particle.

2当共混材料中增容剂含量为10份时，共混材料表现出如下特性：拉伸强度和断裂伸长率分别达到35.66MPa及23.58%，较未加增容剂分别提高了26.6%和65.7%；从1725～1800cm-1范围内羰基特征吸收峰接近消失以及3438～3440cm-1范围内的羟基波数的增加暗示了共混材料中氢键缔合的发生；共混物在100℃附近的吸热峰较未加增容剂时降低了近2℃，相容性得到了提高；木质素在基体中进一步分散，结晶度增加，从而阻止木质素的团聚，增加了两相的相容性。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。