查询词典 data-out

The study establishes the compression of models and algorithms for vector graphics data on different basis, including on the basis of vector graphic factors of B spline curves in predecessors research; on the basis of rectangle graphic factors in main axis mode; on the basis of the application of Hough transform to polygonal line, ellipse and circle, so the study improves the models and algorithms of compression for vector graphic data.The compression for vector graphic data mainly studies the data of storing graphic factors.

本文研究的内容是：根据对以往各种曲线矢量数据压缩模型与算法的研究，建立了基于B样条的曲线矢量图形要素的数据压缩模型和算法；在前人研究的基础上，建立基于主轴模式的矩形图形要素的数据压缩模型和算法；本文作者将Hough变换应用到折线、圆及椭圆图形要素的矢量数据压缩上，在此基础上改进了基于Hough变换的折线、圆及椭圆图形要素的数据压缩模型和算法。

For bulk data transfer, the overhead of on-chip memory access is reduced by proper organization of data buffer. Meanwhile, a software-managed cache supporting coarse-grained access and data pre-fetch are adopted to enhance the performance of on-demand off-chip data transfer. In order to facilitate programming, a memory access library based on the proposed methods is implemented.

将CBEA访存分为批量访存和按需访存；通过合理部署数据缓冲区来减小批量访存计算中的片内访存开销，利用支持粗粒度访问的软件管理cache及数据预取来降低按需访存的片外访存开销；以访存接口库的方式来改善软件的可编程性。

When realizing on hardware, for an M×N UFPA, at any sampling time, a shift-register is used to store M data which is before the current sample data and the shift-register′s output is updated with the data which is at the same column while the upper row. Meanwhile, a common register is used to store the data which is at the same row while the previous column.

在硬件实现阶段，对于M×N的UFPA器件，在任意采样时刻，利用移位寄存器保存当前采样点之前的M个响应值，使其输出可实时更新为与采样点同列的上一个数据；同时，利用一般的寄存器实时保存与采样点同行的前一个数据，采用同帧行列间内插法实现无效像元的实时补偿。

Further, a center holds the latest version of program and at least one item of difference data, and transmits the whole data of program or difference data corresponding to a program version in a terminal apparatus, and the program is updated in the terminal apparatus using the received data.

还在中心保持最新程序的全部数据和至少一个相差数据，并且根据终端装置内的程序版本发送程序的全部数据或相差数据，终端装置则用收到的数据更新程序。

It is suggested by our test work on radon mapping of geology that there is a good coincidence between the data got from gamma-ray spectrometer and radon monitor and the U、Th、Ra、K data got from indoor gamma-ray spectrometer and radiochemistry method; the data of gamma-ray spectrometer and radon monitor are also comparative to the 1∶20 ten thousand geochemistry data of U、Th、 Ra (calculated by the equilibrium coefficient between U and Ra) and radon concentrations measured by solid state nuclear track detector .

在国内首次利用地质勘探费用进行氡地质填图方法试验，该试验方法结果表明，利用国产的现场能谱仪、测氡仪获得的数据与室内能谱仪、化学法测得的铀、钍、镭、钾结果一致；与已有的1∶20万区域地球化学数据铀、钍、镭（由铀、镭平衡系数计算得出）、钾和固体核径迹累积法测氡数据具有很好的可比性。

The model of the thesis s forecasting method is synthetical use of experience model method and mine-reserach information adding power model method of mineral resources assessment based on GIS. It use several kinds of analysis means for multi-sources data. Firstly the gold-research prospective domains of this area are forecasted through the spatial query and ana-lysis by means of GIS,based on geological and mineral information of thearea, synthesizing geochemistry anomaly information. Gridding inserting value transforms geochemistry data of sampling point of the south of Acixiarega from scattering data to grid data by means of the development of Delphi and Mapobjects, using distance reciprocal inserting value method. After deposit orientation analyse and spatial overlapping analysis by means of CIS, the gold-research prospective domains of the area are forecasted.

本文所建立的预测方法模型是基于GIS矿产资源评价方法的经验模型法及找矿信息加权模型法的综合使用，对多源数据采用多种分析手段，先以研究区1：5万区域地质资料和矿产资料为基础，综合地球化学异常资料，通过Mapgis的空间检索与分析，做出全区成矿有利区分布图；而阿次夏热嘎南部地区离散的采样点的地球化学数据，是采用面向对象编程语言Dephi与GIS控件Mapobjects为开发工具，运用距离倒数插值法进行插值网格化，从而将离散的数据转换为栅格型数据，矿床定位分析、GIS空间迭加分析，预测出该地区成矿有利区。

Because source data is unsteadiness, the changes of data must be spread to materialized view and make it be consistency the changes of materialized view and source data. Otherwise the freshness of data in materialized view will be fall down and the authenticity and consistency of OLAP will be affected. For the maintenance problem of materialized view, an algorithm is presented and it can make the cost of materialized view recomputation be minimized.

由于源数据的不稳定性，其数据的变化必须及时传播到实体化视图中，以保持实体化视图与源数据的变化一致性，否则会降低实体化视图中数据的新鲜度，并影响联机分析处理查询结果的真实性和有效性，针对视图的维护问题，提出了实体化视图的一种维护算法，它将使视图重计算代价最小化。

hand to restore the partition table is a relatively reliable method to restore the use of this method must first master the strategy division of the hard disk partition, partition the data records of the location, area of the recording format of data, area data of the inter-relationship between as well as the partition table of the relevant knowledge group; winhex followed by the use of software to be able to deal with access to hard data on the sector, and in accordance with the results derived to deal with the loss of the partition information, and to achieve the restoration of the partition table.

手工恢复分区表是一种比较可靠的恢复方法，使用这一方法必须首先掌握硬盘分区的划分策略、分区数据的记录位置、分区数据的记录格式、分区数据之间的相互关系以及分区表组的相关知识；其次要能够使用winhex软件，去处理访问硬盘有关扇区的数据，并根据处理结果来推导出丢失的分区信息，进而实现分区表的恢复。

In order to obtain the reliable and accurate headway distance data, a state space model for distance data filter is established and then a new data fusion and estimation algorithm based on Kalman filter principle is developed. Its recursion formula is obtained. Taking the distance measurements of machine vision and laser radar as inputs, this fusion and estimation algorithm can output more reliable and accurate fusion data in real time.

建立了距离滤波的状态空间数学模型，提出了一种新的基于Kalman滤波原理的距离数据融合估计方法，推导出融合估计的递推公式，对来自机器视觉和激光雷达的距离数据进行融合估计，以减少距离数据的噪声，提高其可靠性与准确性。

The paper has studied the follow questions: In the overall design on this control system, it raises data collecting and control system based on the single microcomputer, matched special use data redisplay card ad PC computer system. The single microcomputer system, special use data redisplay card and PC computer construct the data collecting and controlling system of beam pumping unit.

该论文主要从以下几个方面进行研究和设计：在控制系统总体设计方面，提出了以单片机为核心的数据采集和控制的单片机系统，配以专用数据回放卡和PC微机，三者有机结合构成整个抽油机数据采集、实时控制和数据处理系统。

We have no common name for a mime of Sophron or Xenarchus and a Socratic Conversation; and we should still be without one even if the imitation in the two instances were in trimeters or elegiacs or some other kind of verse--though it is the way with people to tack on 'poet' to the name of a metre, and talk of elegiac-poets and epic-poets, thinking that they call them poets not by reason of the imitative nature of their work, but indiscriminately by reason of the metre they write in.

索夫农 、森那库斯和苏格拉底式的对话采用的模仿没有一个公共的名称；三音步诗、挽歌体或其他类型的诗的模仿也没有——人们把&诗人&这一名词和格律名称结合到一起，称之为挽歌体诗人或者史诗诗人，他们被称为诗人，似乎只是因为遵守格律写作，而非他们作品的模仿本质。

The relationship between communicative competence and grammar teaching should be that of the ends and the means.

交际能力和语法的关系应该是目标与途径的关系。