查询词典 damping-off

After the airdrop experiments of the system of the projectile and speed-down parachute, the balance velocity obtained from the optics apparatus on the ground、the balance spinning speed obtained from the gyroscope on the projectile and the image obtained from the infrared detector on the projectile are all used to simulate the six-dimension exterior trajectory of the projectile and identify the roll damping moment derivatives, and the identification can safely come to a conclusion that the absolute value of roll damping moment derivatives from the engineering calculation are on the low side.

对卷弧尾翼弹与减速伞系统进行空投试验，由地面光测系统给出平衡落速、弹上陀螺给出平衡转速、弹上红外探测器拍摄地面图像判断弹的姿态。通过六自由度弹道模拟，对弹滚转阻尼导数进行参数辨识，得到工程估算所得滚转阻尼导数绝对值偏小的结论。 5。对空投试验中出现弹姿态摆动现象，从受力分析及红外图像分析两个方面进行探讨，给出合理解释，并根据分析对弹外形进行修改，在后来的试验中收到很好的效果。

As air damping directly determines the dynamic performance of MEMS, it is very important to estimate the air damping effects on them in the design process.

对空气阻尼进行定性和定量分析是MEMS器件设计中非常重要的一个步骤，直接影响MEMS器件的动态性能。

The air damping of the laterally driven microstructures is slide-film air damping.

对于横向运动的体微机械器件，其周围空气表现为滑膜阻尼。

Secondly,the air damping of CFRP cable of free vibrationg and forced vibration induced by lateral forces of the wind was analyzed and the effect of vibration amplitude as well as wind speed on the damping of CFRP cable was discussed based on the comparison with that of steel cable.

其次，对CFRP斜拉索自振状态及横向静风作用下的空气阻尼特性进行了计算分析，通过与钢索计算结果的对比，讨论了拉索振幅及风速对CFRP斜拉索阻尼特性的影响。

The transition pressure calculated by the model is much closer than that calculated by the existing model. A modified model of squeeze film air damping is developed for the design of high-aspect-ratio damping holes formed by deep RIE process.

本文还提出了开有高深宽比的阻尼孔的多孔板的压膜阻尼的修正模型，为采用深反应离子刻蚀技术制作的阻尼孔的设计提供了手段。

Which is with flexible spring steel supporting components and the air for damping medium to overcome these shortcomings which are complicated air spring structure and high prices, the need for daily use and maintenance costs of steel spring isolator without damping.

它以钢弹簧作弹性支承元件、以空气作阻尼介质，克服了空气弹簧构造复杂、价格高、需要日常使用维护费用和钢弹簧隔振器无阻尼的缺点。

The static model of torsion joint is based on that of bending joint. The effects of structure parameters inside air pressure, initial angle, rube average radius, rube shell thickness on the turning angle are analyzed and the following conclusions are drawn: the relationship between the angle of torsion joint and the inside air pressure is basically linear, the angle of torsion joint increases with the initial angle and rube average radius, the angle of torsion joint decreases while the rube shell thickness increases. The kinetic equation is built for torsion joint. Simulating experiment implies that the time of inflating and deflating process is extremely shorter than that of kinetic process. So the pneumatic process can be ignored in actual system design and control. The factors that affect the dynamic features of torsion joint, such as shell thickness of rubber tube, average radius, initial angle, connector's outlet area, moment of inertia and viscous damping coefficient, are analyzed and the following conclusions are drawn: the change of rube shell thickness has no effects on the dynamic process of FPA inside air pressure while greatly affects the turning angle of torsion joint; when the rube shell thickness is small, the torsion joint has a bigger turning angle, no overshoot and long risetime, when the shell thickness is big, the turning angle of torsion joint is small, but has high response speed, overshoot and low shock; when the rube average radius increases, the turning angle of torsion joint increases and the overshoot increases too; when the initial angle of torsion joint is big, the turning joint is big, the overshoot is small and shock is low, but the risetime is big; the connector's outlet area affects the dynamic process of FPA inside air pressure greatly, but has no effects on the dynamic process of turning angle; moment of inertia and viscous damping coefficient have no effects on the dynamic process of FPA inside air pressure, but affect the dynamic process of turning angle greatly.

在弯曲关节模型推导的基础上，建立扭转关节的静态模型，并分析了扭转关节内腔压力，初始转角，橡胶管平均半径，橡胶管壁厚等参数对关节转角的影响，得出扭转关节的转动角度与充入FPA内腔的压缩气体压力之间基本呈线性关系，扭转关节的转角随初始角度和橡胶管平均半径的增大而增大，扭转关节的转角随橡胶管壁厚的增大而减小的结论；建立了扭转关节的动力学方程，仿真实验表明FPA的充放气过程与扭转关节的动力学过程相比时间极短，在实际系统设计和控制过程中可以忽略不计；分析讨论橡胶管壁厚，平均半径，初始角度，气体节流口面积，转动惯量，粘性阻尼系数等因素对扭转关节动态特性的影响，得出橡胶管初始壁厚的变化对扭转关节FPA内腔压力的动态响应几乎没有影响而对关节转角的响应曲线影响比较明显，壁厚较小时，关节可以得到较大的转角，并且转角的响应曲线没有超调，但上升时间长，壁厚较大时，关节转角变小，响应加快，但是有超调和轻微振荡现象，橡胶管平均半径越大，得到的关节转角越大，但是转角响应的超调量也随之增大，FPA的初始角度越大，关节的转角越大，并且超调量减小，振荡减弱，但是上升时间增大，管接头出口面积的大小对关节FPA内腔压力的建立过程影响较大，但对关节转角的动态响应几乎没有影响，转动惯量和粘性阻尼系数对FPA内腔压力的动态过程几乎没有影响而对扭转关节转角有较大影响等结论。

A ship course controller is designed for Norrbin nonlinear ship mathematical model with matching uncertainty. Combining the backstepping algorithm with the nonlinear damping algorithm to design controller, the nonlinear damping is used to cancel the uncertainty. The integral item is introduced in the design to improve the performance of the controller. Now, general ships can only use the electric gyrocompass to measure the course angle, but they have no equipments to measure the angular velocity, so in this article another ship course controller of output feedback is designed for Norrbin nonlinear ship, firstly the angular velocity is estimated by the observer and then the ship course controller is designed.

本文基于含有匹配不确定项的Norrbin非线性船舶数学模型，将backstepping算法和非线性阻尼算法相结合设计船舶航向控制器，利用非线性阻尼来抵消系统的不确定项，同时为了更好地改善系统的性能，在设计过程中引入了积分项；由于目前一般船舶只有电罗经用于测量船舶的航向角，还没有测量船舶航向角速度的设备，因此，针对Norrbin非线性船舶模型设计了一种输出反馈控制器，首先利用观测器对船舶航向角速度进行估计，然后再设计船舶航向控制器。

The invention is a method for designing and preparing binary reinforced damping magnesium alloy having medium rigidity, medium strength, high-medium damping and medium raw material cost, the prepared alloy is beneficial for balancing required elements in practical application, including optimized rigid, wide frequency band, wide strain amplitude, wide temperature zone, strength, enough high-temperature-resistance, creep resistance, toughness, price, anticorrosion treatment and heat processing, and is beneficial for solving the problems in industry, such as lacking of variety of damping magnesium base alloy, selecting and using of rare-earth resource or drawback of substitution.

设计和制备中等刚度、中等强度、上中等阻尼性能和中等原料成本的二元增强阻尼镁基合金的方法，得到的该合金有利于平衡优化刚度、宽频段、宽的应变振幅、宽温度区间、强度、足够耐高温、抗蠕变、韧性、价格、利于防腐处理和利于热加工等实际应用中需求的要素，利于解决工业上可供选择的阻尼镁基合金品种不多以及稀土资源选择利用或替代利用性不足的问题。

In chapter three, the passive vibration control of a smart cantilever beam with piezoelectric shunt damping system is studied theoretically. In this chapter, the mechanical impedance of piezoelectric shunt damping system is analyzed, and the parameters of the RLC piezoelectric shunt circuit are optimized via transfer function of the piezoelectric shunt damped beam in order to optimize the vibration damping effect.

第三章。研究了利用压电分流阻尼系统进行压电智能悬臂梁被动振动控制的方法，分析了压电分流阻尼系统的机械阻抗，并通过传递函数方法对RLC串联压电分流谐振电路元件的参数进行了优化，以使压电分流阻尼系统的阻尼效果达到最优。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。