查询词典 cylinder

The P-V indicating diagram of compressor is a truthful record of working condition in the cylinder. According to the technique, the pressure signals collected from cylinder are normalized and treated as characteristic vector. And the vectors are inputted into a multi-class classifier composed of many support vector machines to identify fault modes.

压缩机P-V指示图是压缩机气缸部分工作状况的真实记录，该技术将采集的气缸压力信号经归一化处理后作为特征向量，输入到由多个支持向量机构造的多值分类器中进行故障模式分类。

The Huragok had obliviously removed a panel from the cylinder: a tangle of wires and cabling stretched from a cavity in the cylinder to this box.

胡拉告克不知不觉的从圆柱上取下一块面板：乱七八糟的丝线从圆柱上的一个孔中伸出来进入一个盒子。

Taking HPAM solutions as an example , the unsteady flow of power-law fluid in eccentric annuli with the inner cylinder reciprocating axially is calculated; the distribution of velocity, flow rate and:stress distribution on the outwall of the inner cyinder is obtained; the effect of eccentricity, stroke and frequency on distribution of velocity is analysed; the effect of eccentricity and axial movement on stress distribution on the outwall of the inner cylinder is analysed too.

在计算上，以HPAM水溶液为例，数值计算了幂律流体在内管做轴向往复运动的偏心环空中的流动，得出了这种流动的速度，流量和流体在内管壁上的压力分布；分析了环空偏心度以及内管冲程和冲次对流体速度分布的影响；分析了环空偏心度和内管轴向运动对流体在内管壁上压力分布的影响。

The theoretical and computational results show that an important reason resulting in eccentric wear of the inner cylinder and the pumping rod lies in the nonuniformity of the stress distribution on the outwall of the inner cylinder which yields excentralization effect of the pumping rod when swabbing fluid flows in eccentric annuli with the pumping rod moving axially in a well.

在实验上，通过不同重量百分比浓度的HPAM水溶液在内管做轴向往复运动的偏心环空中非定常流实验，把由理论公式算得的时间平均流量与实验中测得的时间平均流量做了比较，验证了本文数值计算幂律流体在内管做轴向往复运动的偏心环空中非定常流方法的正确性；上述的理论与计算表明，抽油机井杆管偏磨的一个重要原因是，在聚驱工况下，抽汲液体在抽油杆做轴向运动的井筒中流动时，抽汲液体作用在抽油杆外壁上的压力分布的不均匀性所引起的抽油杆在井筒中的偏心效应。

In the turbo and 6-cylinder Legacy and Outback models equipped with the 5-speed automatic transmission (standard on 6-cylinder models), new steering wheel paddle shifters add a new dimension of driver involvement.

在涡轮增压和6缸的遗产，并与5速自动变速器（标准配备6缸机型），新的方向盘换档配备内陆模式向司机参与的新的层面。

Based on the structure of a non-tracking internal-concentrator solar PV-thermal tube collector and the absorber design requirements, the optical design for the compound parabolic concentrator with half cylinder absorber is proposed to improve the solar energy efficiency. Matlab software was used for the optimization and simulation of the concentrator curve and shape. The curve equation of concentrator for maximum incidence of light of the collector was obtained; and the installation locations for CPC/half cylinder absorber and the necessary CNC processing parameters were optimized.

针对非跟踪内聚光光电－光热复合管的结构及接收器的设计需求，对管内具有特殊形状的半圆柱接收器的复合抛物面聚光器进行了光学设计，并利用Matlab软件对聚光器曲线和形状进行了优化与数据仿真，得到了光热复合管能够得到最大入射光的聚光器的曲线方程、安装位置以及供数控机床加工所需的参数，给出了不同入射角的光线和光强分布图，提高了太阳能的利用率。

Four-valve, pent roof cylinder head design uses two spark plugs per cylinder for efficient combustion and great power delivery at all rpms.

四气门，压抑屋顶缸盖设计采用两个火花塞每个气缸的燃烧效率和巨大的功率输出在所有从RPMS 。

According to the results of stress calculation, provided the choosing basis for structure parameters of hydraulic cylinder and advanced a new cylinder bottom structure-oblique plane check ring concave groove.

对 10MN闭模挤压液压机卡环式液压缸进行有限元应力分析，根据分析结果，给出了液压缸缸底结构参数的选取依据，并在此基础上提出了一种斜面卡环凹槽新结构，有效解决了大型卡环式液压缸卡环凹槽的应力集中问

The printing cylinder and plate cylinder are connected to gears G7 and G8,respectively.

这个 印刷缸，缸是连接到档板，八国集团分别G7.G1是输入齿轮。

However, this would also reduce the effective length of the power stroke because once the exhaust valve opens, there is no longer cylinder pressure to force the cylinder down.

然而，这也将减少有效长度的权力，因为一旦中风的排气门打开时，不再有气缸压力，以迫使缸下来。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。