查询词典 cutout switch

The transfer sequence of the transfer switch can be appraised by transfer test:if all performance indices meet the design requirements,its transfer capability can thus be ensured,which is proved by years'practices.

因此，在有载调压开关运行前必须做此试验。1有载调压开关的工作顺序有载调压开关是由电动机构、切换开关、分接选择器和转换选择器3大部分组成。

Then, flaw of existing full-digital voltage commutation method is pointed out after the change of the critical area which switch sequence will encounter corresponding to the variety of displacement angle at the input-side of converter has been explicated, then several rules have been presented and used to instruct detailed voltage commutati.

通过分析输入侧功率角变化对矩阵变换器全数字电压换流技术的影响，指出现有全数字化电压换流方案的缺陷，并提出新的改进原则，接着给出详细的数字化电压换流策略实现方法，分析新方法对变换器换流次数的影响。

Position Switch, Operating Sequence

位置开关，操作顺序

Adjusted the sequence of replay based on switch ratio n, which meaned, send n multi-data packages and one gene-data package.

通过数学分析和计算机仿真得出结论，在转发速率恰当设置，此方法能够在保持非实时数据包时延可容忍的情况下，可以将多媒体数据包的平均传输时延降低30%~60%。

Several such tapered slot antennas were arranged radially to form a circle, and a group of PINs was put at their feed lines. With the proper sequence switch of PINs, these tapered slot antennas can be constructed into an equivalent omnidirectional antenna.

将几个这样的渐变缝隙天线以放射状构成一圈，并在它们的馈线上引入一组PIN开关，以适当的时序控制PIN开关依次切换，可构成一种等效的全向天线。

Then, flaw of existing full-digital voltage commutation method is pointed out after the change of the critical area which switch sequence will encounter corresponding to the variety of displacement angle at the input-side of converter has been explicated, then several rules have been presented and used to instruct detailed voltage commutation method built. Increment of switches' commutation-times, thanks to the new method employed, is analyzed in succession.

通过分析输入侧功率角变化对矩阵变换器全数字电压换流技术的影响，指出现有全数字化电压换流方案的缺陷，并提出新的改进原则，接着给出详细的数字化电压换流策略实现方法，分析新方法对变换器换流次数的影响。

I used the homemade ECDL to measure the 2S-3D two photon transition spectrum of Helium , the advantages are that the expense of homemade ECDL is cheap and have good output power. At the same time, I used the electronic part can be got in the market to manufacture a pulse generator in the experiment, the pulse generator can control the output frequency, the pulse width, the relative phase and also can simultaneously control four sets of systems or instruments need the TTL pulse control. The advantage is that the cost of the pulse generator is cheap and the pulse generator is stable. To isolate the magnetic field I used the magnetic foil to helium cell. I also built a gas discharge system, the switch sequence of this system can be controlled by the pulse generator. Finally I built a detecting system can measure the helium energy state. It is cheap and can be combined with the comb laser system in my laboratory.

本实验是利用一台自制的外腔雷射系统来量测2S-3D的氦原子双光子跃迁，其优点在於自制的外腔雷射之费用非常便宜，也有不错的输出功率，同时在实验中我利用市售的电子零件制作了一台脉冲产生器，可控制输出的频率、脉冲宽度以及相对的相位，且可同时控制四套需要TTL脉冲控制的系统或仪器，优点除了便宜之外，也非常稳定；为了隔绝磁场，利用了磁场隔绝金属箔，我也在实验室中建立了一组气体放电系统，其系统可以用脉冲产生器来控制开关时序，最后，我建造了一个氦原子能阶的量测系统，而且费用低廉，可与本实验室的另外一门研究光梳雷射系统做结合。

I used the homemade ECDL to measure the 2S-3D two photon transition spectrum of Helium , the advantages are that the expense of homemade ECDL is cheap and have good output power. At the same time, I used the electronic part can be got in the market to manufacture a pulse generator in the experiment, the pulse generator can control the output frequency, the pulse width, the relative phase and also can simultaneously control four sets of systems or instruments need the TTL pulse control. The advantage is that the cost of the pulse generator is cheap and the pulse generator is stable. To isolate the magnetic field I used the magnetic foil to helium cell. I also built a gas discharge system, the switch sequence of this system can be controlled by the pulse generator. Finally I built a detecting system can measure the helium energy state.

本实验是利用一台自制的外腔雷射系统来量测2S-3D的氦原子双光子跃迁，其优点在於自制的外腔雷射之费用非常便宜，也有不错的输出功率，同时在实验中我利用市售的电子零件制作了一台脉冲产生器，可控制输出的频率、脉冲宽度以及相对的相位，且可同时控制四套需要TTL脉冲控制的系统或仪器，优点除了便宜之外，也非常稳定；为了隔绝磁场，利用了磁场隔绝金属箔，我也在实验室中建立了一组气体放电系统，其系统可以用脉冲产生器来控制开关时序，最后，我建造了一个氦原子能阶的量测系统，而且费用低廉，可与本实验室的另外一门研究光梳雷射系统做结合。

Problems such as charge injection and clock feedthrough caused by turning off swithes are analyzed and solved in this design. The optimal switch sequence helps eliminate the nonlinearity caused by the charge injection; the addition of dummy switches to sensitive nodes caused by the clock feedthrough can greatly reduce the coupled charge; and the use of high PSRR folded cascode differential input stage can restrain the interference from the power supply. The circuit performance, therefore, has been greatly improved.

设计中分析并解决了因时钟信号引起的制约开关性能的因素：优化的开关时序消除了电荷注入引起的非线性；时钟馈通敏感节点增加虚拟开关抵消了耦合电荷；高PSRR共源共栅折叠式差分输入结构，有效地抑制了来自电源的干扰，改善了电路的性能。

Firstly, the relationship between the magnetic pole state of active magnetic pole and the running state of passive magnetic pole was analyzed. The electromagnet's four magnetic pole state and switch sequence, which can drive permanent magnet rotate, were ascertained. Secondly, taking one of magnetic pole state NS (N denotes electromagnet's left magnetic pole and S right magnetic pole) as an example, the distribution of space magnetic field was studied. In addition, the mathematical model of space magnetic field was set up based on the magnetic circuit fundamental and using the method of magnetic analysis and modeling. Lastly, the four states' mathematical model of space magnetic field was solved by using the MATLAB.

首先，分析系统主动磁极磁极状态和从动磁极转动状态之间的关系，确定驱动永磁体转动的电磁体4个磁极状态及切换顺序；其次，基于磁路基本原理，通过磁场分析和建模，以电磁体4个磁极状态之一的NS（N表示其左极、S为右极）为例，对电磁体的空间磁场分布进行研究并建立空间磁场数学模型；最后，以MATLAB为平台对4个磁极状态的空间磁场数学模型进行求解，将求解结果与实验数据进行对比。

You can do some assertiveness training.

你可以进行一些自信训练。

We were well on the path to making a rear-wheel-drive global platform," says Mays."

我们正致力于建立一个后轮驱动的平台，"Mays这样说道。"